From mboxrd@z Thu Jan 1 00:00:00 1970 From: Julien Grall Subject: Re: Can not boot Dom0 when using Anthony's new XenARM source for Arndale. Date: Wed, 27 Mar 2013 11:53:10 +0000 Message-ID: <5152DDA6.6060909@citrix.com> References: <5151F87A.1020404@citrix.com> Mime-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Return-path: In-Reply-To: List-Unsubscribe: , List-Post: List-Help: List-Subscribe: , Sender: xen-devel-bounces@lists.xen.org Errors-To: xen-devel-bounces@lists.xen.org To: Gihun Jung Cc: Anthony Perard , "xen-devel@lists.xensource.com" List-Id: xen-devel@lists.xenproject.org On 03/27/2013 08:15 AM, Gihun Jung wrote: > 2013/3/27 Julien Grall : >> On 03/25/2013 10:35 AM, Gihun Jung wrote: >> >>> Hi Xen Developers, >> >> Hello, >> >> >>> I had tested new XenARM for Arndale board that is updated in Anthony's >>> tree from 2 days ago. >>> >>> I expected that will be working. But, I can not boot Dom0 Kernel. >>> I used kernel and XenARM both are from Xen >>> Wiki(http://wiki.xen.org/wiki/Xen_ARM_with_Virtualization_Extensions/Arndale). >>> >>> It (seems) stopped after "(XEN) Freed 212kB init memory" message. When >>> I changed serial input to Xen ('ctrl-a' 3 times) and dump state, it >>> show we are in Undefined processor mode or sometimes in Abort mode. >>> >>> Does anyone else have the same problem? or Am I doing something wrong? >> >> I have updated the wiki page and the linux git. >> Could you retry with the new instructions? If you still have this issue, >> could you send serial output? >> >> Thanks, >> >> Julien >> > > > Thanks for your reply. It is pleasure to read updated wiki! > I have solved this issues with changing the load address of zImage by > u-boot to 0x60000000 from 0x40007000. > In that case, we should change "reg" of "module@0" node, which > described xen,multiboot-module as compatible from > exynos5250-ardale.dts. > The default value is reg = <0x40007000, 0x40000>. Am I doing right to > change 0x40007000 to 0x60000000?. It succeed to boot when i change it. > However, when I just leave it as a default and loaded zImage at > 0x60000000, it was not working: Xen could not find zImage. > I think you will mention about this matter on wiki for clearing this > situation if it is right. I made a commit yesterday evening to change module@0 base address. I don't have access to Anthony's git so I have created a new git: http://xenbits.xen.org/gitweb/?p=people/julieng/linux-arm.git;a=summary The wiki should point to the new git. Cheers, Julien