RE: [PATCH V5 6/7] iommu/msm: Use writel_relaxed and add a barrier

["Sricharan" <sricharan@codeaurora.org>]

Hi Arnd,

>> Ok, so i was doing this from the idea that, other iommu drivers
>>  where polling on a status bit in their sync call to ensure completion
>> of pending TLB invalidations. But in this case, there is no status bit.
>>  So added a barrier to have no ordering issues before the client
>> triggers the dma operation. But as you say above that it is implicit that
>> the device would have a barrier before starting the trigger, then the
>> barrier here becomes redundant.
>
>Ok. There are two more things to note here:
>
>* On other platforms, polling the register is likely required because
>  an MMIO write is "posted", meaning that a sync after writel() will
>  only ensure that it has left the CPU write queue, but it may still be
>  on the bus fabric and whatever side-effects are triggered by the
>  write are normally not guaranteed to be completed even after the
>  'sync'. You need to check the datasheet for your IOMMU to find out
>  whether the 'dsb' instruction actually has any effect on the IOMMU.
>  If not, then neither the barrier that you add here nor the barrier
>  in the following writel() is sufficient.
>
   Thanks for the detailed explanation.
i will check this. So with this, i think that if the iommu does not
 support polling for its status, then it should listen to 'dsb' otherwise
 there will no be no way of make it coherent ?

>* The one barrier that is normally required in an IOMMU is between
>  updating the in-memory page tables and the following MMIO store
>  that triggers the TLB flush for that entry. This barrier is
>  implied by writel() but not writel_relaxed(). If you don't have
>  a hardware page table walker in your IOMMU, you don't need to worry
>  about this.
>
  To get my understanding correct here, is the barrier required here because
   of speculative fetch ?

Regards,
 Sricharan