RE: [PATCH V4 3/3] i2c: qup: Fix error handling

["Sricharan" <sricharan@codeaurora.org>]

+Wolfram Sang

>-----Original Message-----
>From: linux-arm-kernel [mailto:linux-arm-kernel-bounces@lists.infradead.org] On Behalf Of Sricharan R
>Sent: Friday, June 10, 2016 11:38 PM
>To: linux-arm-msm@vger.kernel.org; ntelkar@codeaurora.org; galak@codeaurora.org; linux-kernel@vger.kernel.org;
>andy.gross@linaro.org; linux-i2c@vger.kernel.org; agross@codeaurora.org; linux-arm-kernel@lists.infradead.org;
>nkaje@codeaurora.org; absahu@codeaurora.org
>Cc: sricharan@codeaurora.org
>Subject: [PATCH V4 3/3] i2c: qup: Fix error handling
>
>Among the bus errors reported from the QUP_MASTER_STATUS register
>only NACK is considered and transfer gets suspended, while
>other errors are ignored. Correct this and suspend the transfer
>for other errors as well. This avoids unnecessary 'timeouts' which
>happens when waiting for events that would never happen when there
>is already an error condition on the bus. Also the error handling
>procedure should be the same for both NACK and other bus errors in
>case of dma mode. So correct that as well.
>
>Signed-off-by: Sricharan R <sricharan@codeaurora.org>
>---
> drivers/i2c/busses/i2c-qup.c | 76 ++++++++++++++++++++++++--------------------
> 1 file changed, 41 insertions(+), 35 deletions(-)
>
>diff --git a/drivers/i2c/busses/i2c-qup.c b/drivers/i2c/busses/i2c-qup.c
>index b8116e5..44c80ae 100644
>--- a/drivers/i2c/busses/i2c-qup.c
>+++ b/drivers/i2c/busses/i2c-qup.c
>@@ -310,6 +310,7 @@ static int qup_i2c_wait_ready(struct qup_i2c_dev *qup, int op, bool val,
> 	u32 opflags;
> 	u32 status;
> 	u32 shift = __ffs(op);
>+	int ret = 0;
>
> 	len *= qup->one_byte_t;
> 	/* timeout after a wait of twice the max time */
>@@ -321,18 +322,28 @@ static int qup_i2c_wait_ready(struct qup_i2c_dev *qup, int op, bool val,
>
> 		if (((opflags & op) >> shift) == val) {
> 			if ((op == QUP_OUT_NOT_EMPTY) && qup->is_last) {
>-				if (!(status & I2C_STATUS_BUS_ACTIVE))
>-					return 0;
>+				if (!(status & I2C_STATUS_BUS_ACTIVE)) {
>+					ret = 0;
>+					goto done;
>+				}
> 			} else {
>-				return 0;
>+				ret = 0;
>+				goto done;
> 			}
> 		}
>
>-		if (time_after(jiffies, timeout))
>-			return -ETIMEDOUT;
>-
>+		if (time_after(jiffies, timeout)) {
>+			ret = -ETIMEDOUT;
>+			goto done;
>+		}
> 		usleep_range(len, len * 2);
> 	}
>+
>+done:
>+	if (qup->bus_err || qup->qup_err)
>+		ret =  (qup->bus_err & QUP_I2C_NACK_FLAG) ? -ENXIO : -EIO;
>+
>+	return ret;
> }
>
> static void qup_i2c_set_write_mode_v2(struct qup_i2c_dev *qup,
>@@ -793,39 +804,35 @@ static int qup_i2c_bam_do_xfer(struct qup_i2c_dev *qup, struct i2c_msg *msg,
> 	}
>
> 	if (ret || qup->bus_err || qup->qup_err) {
>-		if (qup->bus_err & QUP_I2C_NACK_FLAG) {
>-			msg--;
>-			dev_err(qup->dev, "NACK from %x\n", msg->addr);
>-			ret = -EIO;
>+		if (qup_i2c_change_state(qup, QUP_RUN_STATE)) {
>+			dev_err(qup->dev, "change to run state timed out");
>+			goto desc_err;
>+		}
>
>-			if (qup_i2c_change_state(qup, QUP_RUN_STATE)) {
>-				dev_err(qup->dev, "change to run state timed out");
>-				return ret;
>-			}
>+		if (rx_nents)
>+			writel(QUP_BAM_INPUT_EOT,
>+			       qup->base + QUP_OUT_FIFO_BASE);
>
>-			if (rx_nents)
>-				writel(QUP_BAM_INPUT_EOT,
>-				       qup->base + QUP_OUT_FIFO_BASE);
>+		writel(QUP_BAM_FLUSH_STOP, qup->base + QUP_OUT_FIFO_BASE);
>
>-			writel(QUP_BAM_FLUSH_STOP,
>-			       qup->base + QUP_OUT_FIFO_BASE);
>+		qup_i2c_flush(qup);
>
>-			qup_i2c_flush(qup);
>+		/* wait for remaining interrupts to occur */
>+		if (!wait_for_completion_timeout(&qup->xfer, HZ))
>+			dev_err(qup->dev, "flush timed out\n");
>
>-			/* wait for remaining interrupts to occur */
>-			if (!wait_for_completion_timeout(&qup->xfer, HZ))
>-				dev_err(qup->dev, "flush timed out\n");
>+		qup_i2c_rel_dma(qup);
>
>-			qup_i2c_rel_dma(qup);
>-		}
>+		ret =  (qup->bus_err & QUP_I2C_NACK_FLAG) ? -ENXIO : -EIO;
> 	}
>
>+desc_err:
> 	dma_unmap_sg(qup->dev, qup->btx.sg, tx_nents, DMA_TO_DEVICE);
>
> 	if (rx_nents)
> 		dma_unmap_sg(qup->dev, qup->brx.sg, rx_nents,
> 			     DMA_FROM_DEVICE);
>-desc_err:
>+
> 	return ret;
> }
>
>@@ -841,9 +848,6 @@ static int qup_i2c_bam_xfer(struct i2c_adapter *adap, struct i2c_msg *msg,
> 	if (ret)
> 		goto out;
>
>-	qup->bus_err = 0;
>-	qup->qup_err = 0;
>-
> 	writel(0, qup->base + QUP_MX_INPUT_CNT);
> 	writel(0, qup->base + QUP_MX_OUTPUT_CNT);
>
>@@ -881,12 +885,8 @@ static int qup_i2c_wait_for_complete(struct qup_i2c_dev *qup,
> 		ret = -ETIMEDOUT;
> 	}
>
>-	if (qup->bus_err || qup->qup_err) {
>-		if (qup->bus_err & QUP_I2C_NACK_FLAG) {
>-			dev_err(qup->dev, "NACK from %x\n", msg->addr);
>-			ret = -EIO;
>-		}
>-	}
>+	if (qup->bus_err || qup->qup_err)
>+		ret =  (qup->bus_err & QUP_I2C_NACK_FLAG) ? -ENXIO : -EIO;
>
> 	return ret;
> }
>@@ -1178,6 +1178,9 @@ static int qup_i2c_xfer(struct i2c_adapter *adap,
> 	if (ret < 0)
> 		goto out;
>
>+	qup->bus_err = 0;
>+	qup->qup_err = 0;
>+
> 	writel(1, qup->base + QUP_SW_RESET);
> 	ret = qup_i2c_poll_state(qup, QUP_RESET_STATE);
> 	if (ret)
>@@ -1227,6 +1230,9 @@ static int qup_i2c_xfer_v2(struct i2c_adapter *adap,
> 	struct qup_i2c_dev *qup = i2c_get_adapdata(adap);
> 	int ret, len, idx = 0, use_dma = 0;
>
>+	qup->bus_err = 0;
>+	qup->qup_err = 0;
>+
> 	ret = pm_runtime_get_sync(qup->dev);
> 	if (ret < 0)
> 		goto out;
>--
>QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux
>Foundation
>
>
>_______________________________________________
>linux-arm-kernel mailing list
>linux-arm-kernel@lists.infradead.org
>http://lists.infradead.org/mailman/listinfo/linux-arm-kernel