* small problem configuring and installing reiser4progs
@ 2003-08-27 1:11 Tupshin Harper
2003-08-27 4:16 ` Steven Cole
2003-08-27 5:23 ` Yury Umanets
0 siblings, 2 replies; 4+ messages in thread
From: Tupshin Harper @ 2003-08-27 1:11 UTC (permalink / raw)
To: Reiserfs List
I just downloaded and installed reiser4progs-0.4.12 and libaal-0.4.9.
This was the first install of either of these, and I ran into the
following problem:
configured and make installed libaal-0.4.9
configure of reiser4progs ends with the following:
checking whether -falign-loops works... yes
checking for aal_device_open in -laal... yes
checking aal/aal.h usability... yes
checking aal/aal.h presence... yes
checking for aal/aal.h... yes
checking for libaal version = 0.4.9... no
It ends there, without any indication that there was a fatal error, but
it didn't build the Makefiles. So, two problems...insufficient error
reporting, as well as a slight problem with the process. After running
ldconfig, configure works just fine.
-Tupshin
^ permalink raw reply [flat|nested] 4+ messages in thread
* Re: small problem configuring and installing reiser4progs
2003-08-27 1:11 small problem configuring and installing reiser4progs Tupshin Harper
@ 2003-08-27 4:16 ` Steven Cole
2003-08-27 5:23 ` Yury Umanets
1 sibling, 0 replies; 4+ messages in thread
From: Steven Cole @ 2003-08-27 4:16 UTC (permalink / raw)
To: Tupshin Harper; +Cc: Reiserfs List
On Tue, 2003-08-26 at 19:11, Tupshin Harper wrote:
> I just downloaded and installed reiser4progs-0.4.12 and libaal-0.4.9.
> This was the first install of either of these, and I ran into the
> following problem:
> configured and make installed libaal-0.4.9
> configure of reiser4progs ends with the following:
> checking whether -falign-loops works... yes
> checking for aal_device_open in -laal... yes
> checking aal/aal.h usability... yes
> checking aal/aal.h presence... yes
> checking for aal/aal.h... yes
> checking for libaal version = 0.4.9... no
>
> It ends there, without any indication that there was a fatal error, but
> it didn't build the Makefiles. So, two problems...insufficient error
> reporting, as well as a slight problem with the process. After running
> ldconfig, configure works just fine.
>
> -Tupshin
>
Yeah, I flailed around with this problem for a couple of minutes too.
I also ran /sbin/ldconfig, but still got the above, so I added the
install directory for libaal (I think it is /usr/local/bin, but I don't
have it here) to /etc/ld.so.conf, and ran ldconfig again, and after that
everything worked. I guess if I really understood this better, it
wouldn't have been even that hard, but general users shouldn't have to
jump through these hoops.
Steven
^ permalink raw reply [flat|nested] 4+ messages in thread
* Re: small problem configuring and installing reiser4progs
2003-08-27 1:11 small problem configuring and installing reiser4progs Tupshin Harper
2003-08-27 4:16 ` Steven Cole
@ 2003-08-27 5:23 ` Yury Umanets
2003-08-27 5:47 ` Tupshin Harper
1 sibling, 1 reply; 4+ messages in thread
From: Yury Umanets @ 2003-08-27 5:23 UTC (permalink / raw)
To: Tupshin Harper; +Cc: Reiserfs List
On Wed, 2003-08-27 at 05:11, Tupshin Harper wrote:
> I just downloaded and installed reiser4progs-0.4.12 and libaal-0.4.9.
> This was the first install of either of these, and I ran into the
> following problem:
> configured and make installed libaal-0.4.9
> configure of reiser4progs ends with the following:
> checking whether -falign-loops works... yes
> checking for aal_device_open in -laal... yes
> checking aal/aal.h usability... yes
> checking aal/aal.h presence... yes
> checking for aal/aal.h... yes
> checking for libaal version = 0.4.9... no
>
> It ends there, without any indication that there was a fatal error, but
> it didn't build the Makefiles. So, two problems...insufficient error
> reporting, as well as a slight problem with the process. After running
> ldconfig, configure works just fine.
>
> -Tupshin
>
>
That is because your ldcache is still not updated. Run ldconfig under root first.
Regards.
^ permalink raw reply [flat|nested] 4+ messages in thread
* Re: small problem configuring and installing reiser4progs
2003-08-27 5:23 ` Yury Umanets
@ 2003-08-27 5:47 ` Tupshin Harper
0 siblings, 0 replies; 4+ messages in thread
From: Tupshin Harper @ 2003-08-27 5:47 UTC (permalink / raw)
To: Yury Umanets; +Cc: Reiserfs List
Yury Umanets wrote:
>On Wed, 2003-08-27 at 05:11, Tupshin Harper wrote:
>
>
>>I just downloaded and installed reiser4progs-0.4.12 and libaal-0.4.9.
>>This was the first install of either of these, and I ran into the
>>following problem:
>>configured and make installed libaal-0.4.9
>>configure of reiser4progs ends with the following:
>>checking whether -falign-loops works... yes
>>checking for aal_device_open in -laal... yes
>>checking aal/aal.h usability... yes
>>checking aal/aal.h presence... yes
>>checking for aal/aal.h... yes
>>checking for libaal version = 0.4.9... no
>>
>>It ends there, without any indication that there was a fatal error, but
>>it didn't build the Makefiles. So, two problems...insufficient error
>>reporting, as well as a slight problem with the process. After running
>>ldconfig, configure works just fine.
>>
>>-Tupshin
>>
>>
>>
>>
>
>That is because your ldcache is still not updated. Run ldconfig under root first.
>
>Regards.
>
>
>
>
Uh...yeah...I thought I was clear that that was exactly what I did.
Thanks, though.
-Tupshin
^ permalink raw reply [flat|nested] 4+ messages in thread
end of thread, other threads:[~2003-08-27 5:47 UTC | newest]
Thread overview: 4+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2003-08-27 1:11 small problem configuring and installing reiser4progs Tupshin Harper
2003-08-27 4:16 ` Steven Cole
2003-08-27 5:23 ` Yury Umanets
2003-08-27 5:47 ` Tupshin Harper
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.