All of lore.kernel.org
 help / color / mirror / Atom feed
From: bugtrack@alsa-project.org
To: alsa-devel@alsa-project.org
Subject: [ALSA - driver 0000644]: CMI8738 - Line-in as bass conflicts with line-as rear.
Date: Thu, 2 Dec 2004 19:25:40 +0100	[thread overview]
Message-ID: <117eab6e2ca72d033c92df930ad5484e@bugtrack.alsa-project.org> (raw)


A NOTE has been added to this issue.
======================================================================
<https://bugtrack.alsa-project.org/alsa-bug/view.php?id=644> 
======================================================================
Reported By:                jborges
Assigned To:                tiwai
======================================================================
Project:                    ALSA - driver
Issue ID:                   644
Category:                   PCI - cmipci
Reproducibility:            always
Severity:                   minor
Priority:                   normal
Status:                     assigned
Distribution:               Kurumin 3.2 (a Brazilian flavor of Knoppix) with kde
3.2.3
Kernel Version:             Kernel 2.4.25-klg
======================================================================
Date Submitted:             11-12-2004 00:09 CET
Last Modified:              12-02-2004 19:25 CET
======================================================================
Summary:                    CMI8738 - Line-in as bass conflicts with line-as
rear.
Description: 
I'm using Kurumin 3.2 (a Brazilian flavor of Knoppix) in a ASUS P4B533 with
CMI8738 sound chip, processor is Pentium IV 3.0 GHz, 512 RAM and 120
Maxtor Ultra Dma Hard Disk.

Also I use Kde 3.2.3 on Kernel 2.4.25-klg.

This Linux installation works in a dual-boot with windows xp.

The sound works fine (all 6 channels respond very well)under windows xp or
98.

+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

Trying to configure my sound to work I noticed some problems with
alsamixer:

1 - As I can see, there is a conflict for the output. I can't see Line-In
been used to output as bass and the same Line-In used to output as rear
(L/R).

2 - I think Line-In would be used to output as Rear (L/R) and Mic to
output as Bass/Center.

What is happening is that: when one uses a 6 channel system there is no
sound in the conflicted Line-In as bass and Mic as center. The little
sound that goes there is squeezed from Line-In as rear. The sound in bass
and center is full of noise. Impossible to listen.

I took some snapshots (2) to show you what I'm talking about. Please take
a look on them in the attached files.

Julio Borges
Rio de Janeiro - Brazil
======================================================================

----------------------------------------------------------------------
 jborges - 11-28-04 10:51 
----------------------------------------------------------------------
I seems that I made a mistake in my last reply. I wrote something and
attached a new picture. The picture is there but nothing went togheter.
Maybe I forgot to push the add note button. Sorry about that.
What I wanted to tell you is: in the new picture you can see more clearly
that line-in as bass and line-in as rear are not enabled. There is no bars
on them and neither the doted lines above the empty bars. The samething
happen with 3d control and mic as.

Again, sorry.

----------------------------------------------------------------------
 tiwai - 12-02-04 19:25 
----------------------------------------------------------------------
Both are enabled in the new pictures indeed, too.
You'll see 'MM' on the top of volume bar and '[Off]' in the item name when
the switch is disabled.  Try to push 'M' key on the corresponding volume.

Issue History
Date Modified  Username       Field                    Change              
======================================================================
11-12-04 00:09 jborges        New Issue                                    
11-12-04 00:09 jborges        File Added: sound-cm8738-alsamixergui.png         
          
11-12-04 00:09 jborges        Distribution              => Kurumin 3.2 (a
Brazilian flavor of Knoppix) with kde 3.2.3
11-12-04 00:09 jborges        Kernel Version            => Kernel 2.4.25-klg
11-18-04 18:16 tiwai          Note Added: 0002455                          
11-18-04 19:04 jborges        Note Added: 0002458                          
11-18-04 19:40 tiwai          Note Added: 0002463                          
11-20-04 23:25 jborges        File Added: sound-cm8738-alsamixer.png            
       
11-28-04 10:51 jborges        Note Added: 0002621                          
12-02-04 19:25 tiwai          Note Added: 0002691                          
======================================================================




-------------------------------------------------------
SF email is sponsored by - The IT Product Guide
Read honest & candid reviews on hundreds of IT Products from real users.
Discover which products truly live up to the hype. Start reading now. 
http://productguide.itmanagersjournal.com/

             reply	other threads:[~2004-12-02 18:25 UTC|newest]

Thread overview: 9+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2004-12-02 18:25 bugtrack [this message]
  -- strict thread matches above, loose matches on Subject: below --
2006-07-28  1:45 [ALSA - driver 0000644]: CMI8738 - Line-in as bass conflicts with line-as rear bugtrack
2004-12-07 17:33 bugtrack
2004-12-06 11:32 bugtrack
2004-11-28  9:51 bugtrack
2004-11-18 18:40 bugtrack
2004-11-18 18:04 bugtrack
2004-11-18 17:16 bugtrack
2004-11-11 23:09 bugtrack

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=117eab6e2ca72d033c92df930ad5484e@bugtrack.alsa-project.org \
    --to=bugtrack@alsa-project.org \
    --cc=alsa-devel@alsa-project.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.