Re: [PATCH] [POWERPC] Always build setup-bus.c on powerpc

[Benjamin Herrenschmidt <benh@kernel.crashing.org>]

On Thu, 2008-01-24 at 00:07 -0600, Kumar Gala wrote:
> The common arch/powerpc code calls in to functions in setup-bus.c
> so some builds of ppc32 would fail.
> 
> Note, ppc32 usage of setup-irq.c is limited to arch/ppc and should be
> removed when arch/ppc goes away.

I don't understand... the old code would build setup-bus.o for both
PPC32 and PPC64 cases, how did you make it fail ?

Ben.

> Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
> ---
> 
> Greg, recent changes that BenH has made to the arch/powerpc pci code make
> this necessary. If you don't have an issue I'd like this patch to go via
> the paulus's powerpc.git tree.
> 
> - k
> 
>  drivers/pci/Makefile |    4 ++--
>  1 files changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/pci/Makefile b/drivers/pci/Makefile
> index 945bf02..869d689 100644
> --- a/drivers/pci/Makefile
> +++ b/drivers/pci/Makefile
> @@ -31,8 +31,8 @@ obj-$(CONFIG_ALPHA) += setup-bus.o setup-irq.o
>  obj-$(CONFIG_ARM) += setup-bus.o setup-irq.o
>  obj-$(CONFIG_PARISC) += setup-bus.o
>  obj-$(CONFIG_SUPERH) += setup-bus.o setup-irq.o
> -obj-$(CONFIG_PPC32) += setup-irq.o setup-bus.o
> -obj-$(CONFIG_PPC64) += setup-bus.o
> +obj-$(CONFIG_PPC) += setup-bus.o
> +obj-$(CONFIG_PPC32) += setup-irq.o
>  obj-$(CONFIG_MIPS) += setup-bus.o setup-irq.o
>  obj-$(CONFIG_X86_VISWS) += setup-irq.o
>