Re: [PATCHv2 1/2] net: Allow ethtool to set interface in loopback mode.

[Ben Hutchings <bhutchings@solarflare.com>]

On Wed, 2011-05-04 at 18:30 -0700, Mahesh Bandewar wrote:
> This patch enables ethtool to set the loopback mode on a given interface.
> By configuring the interface in loopback mode in conjunction with a policy
> route / rule, a userland application can stress the egress / ingress path
> exposing the flows of the change in progress and potentially help developer(s)
> understand the impact of those changes without even sending a packet out
> on the network.
> 
> Following set of commands illustrates one such example -
>     a) ip -4 addr add 192.168.1.1/24 dev eth1
>     b) ip -4 rule add from all iif eth1 lookup 250
>     c) ip -4 route add local 0/0 dev lo proto kernel scope host table 250
>     d) arp -Ds 192.168.1.100 eth1
>     e) arp -Ds 192.168.1.200 eth1
>     f) sysctl -w net.ipv4.ip_nonlocal_bind=1
>     g) sysctl -w net.ipv4.conf.all.accept_local=1
>     # Assuming that the machine has 8 cores
>     h) taskset 000f netserver -L 192.168.1.200
>     i) taskset 00f0 netperf -t TCP_CRR -L 192.168.1.100 -H 192.168.1.200 -l 30
> 
> Signed-off-by: Mahesh Bandewar <maheshb@google.com>
Acked-by: Ben Hutchings <bhutchings@solarflare.com>

-- 
Ben Hutchings, Senior Software Engineer, Solarflare
Not speaking for my employer; that's the marketing department's job.
They asked us to note that Solarflare product names are trademarked.