Re: [Qemu-devel] [RFC] Memory API

[Alex Williamson <alex.williamson@redhat.com>]

On Wed, 2011-05-18 at 14:34 -0500, Anthony Liguori wrote:
> On 05/18/2011 02:27 PM, Jan Kiszka wrote:
> > On 2011-05-18 21:10, Anthony Liguori wrote:
> >> On 05/18/2011 10:30 AM, Jan Kiszka wrote:
> >> You really don't need to register 90% of the time.  In the case of a PC
> >> with i440fx, it's really quite simple:
> >>
> >> if an I/O is to the APIC page,
> >>     it's handled by the APIC
> >
> > That's not that simple. We need to tell apart:
> >   - if a cpu issued the request, and which one =>  forward to APIC
> 
> Right, but what I'm saying is that this logic lives in 
> kvm-all.c:kvm_run():case EXIT_MMIO.
> 
> Obviously for TCG, it's a bit more complicated but this should be 
> handled way before there's any kind of general dispatch.
> 
> >   - if the range was addressed by a device (PCI or other system bus
> >     devices) =>  forward to MSI or other MMIO handlers
> 
> The same is true for MSI.  Other MMIO handlers can be handled as 
> appropriate.  For instance, once an I/O is sent to the PCI bus, you can 
> walk each PCI device's BAR list to figure out which device owns the I/O 
> event.
> 
> For ISA, it's a little trickier since ISA doesn't do positive decoding. 
>   You need each ISA device to declare what I/O addresses it handles.

Do we only need to handle CPU based I/O with this API?  I would think we
would be layering memory regions and implementing them as a hierarchy
that reflects the actual hardware layout we're emulating.  An access
from an I/O device may get a different translation to memory than a CPU
(IOMMU).  We also might have a system with two VGA devices that both
register 0xa0000 with a switch in the chipset that decides which one
sees the accesses, just as real hardware does. ISTR a presentation at
one of the first KVM forums from you that talked about this type of
model.  Thanks,

Alex