[PATCHv6 0/6] ARM: imx: Add Freescale LS1021A SoC and board support

[jingchang.lu@freescale.com (Jingchang Lu)]

________________________________________
From: Shawn Guo <shawn.guo@linaro.org>
Sent: Sunday, October 26, 2014 8:23 AM
To: Lu Jingchang-B35083
Cc: arnd at arndb.de; mark.rutland at arm.com; linux-arm-kernel at lists.infradead.org; devicetree at vger.kernel.org
Subject: Re: [PATCHv6 0/6] ARM: imx: Add Freescale LS1021A SoC and board support

On Fri, Oct 24, 2014 at 06:08:41PM +0800, Jingchang Lu wrote:
>> This series contain the support for Freescale LS1021A CPU and LS1021A-QDS
>> and LS1021A-TWR board.
>>
>> The LS1021A SoC combines two ARM Cortex-A7 cores that have been optimized
>> for high reliability and pack the highest level of integration available
> >for sub-3W embedded communications processors and with a comprehensive
>> enablement model focused on ease of programmability.
>>
>> The LS1021A SoC shares IPs with i.MX family, Vybrid family and Freescale
>> PowerPC platform.
>>
>> For the detail information about LS1021A SoC, please refer to the RM doc.
>>
>> ---
>> changes in v6:
>>  add dts patch description.
>>  remove '-' from QDS and TWR board dts name for consistence with u-boot.

>I'm not sure it's a good idea.  The most idiomatic DTS naming schema is
just <socname>-<boardname>.dts.
Many our PowerPC platforms doesn't have '-' between SoCs and board names. This becomes a project requirement when integrating in our SDK release, and I have renamed these board names internally, so I also rename them on upstream for consistence. Thanks.

Best Regards,
Jingchang

>Shawn