All of lore.kernel.org
 help / color / mirror / Atom feed
From: Charles Keepax <ckeepax-yzvPICuk2AATkU/dhu1WVueM+bqZidxxQQ4Iyu8u01E@public.gmane.org>
To: cw00.choi-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org,
	lee.jones-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org
Cc: robh+dt-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org,
	pawel.moll-5wv7dgnIgG8@public.gmane.org,
	mark.rutland-5wv7dgnIgG8@public.gmane.org,
	ijc+devicetree-KcIKpvwj1kUDXYZnReoRVg@public.gmane.org,
	galak-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org,
	myungjoo.ham-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org,
	sameo-VuQAYsv1563Yd54FQh9/CA@public.gmane.org,
	devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
	linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
Subject: [PATCH 6/6] mfd: arizona: Update DT binding documentation for jack detection
Date: Wed, 16 Sep 2015 10:56:44 +0100	[thread overview]
Message-ID: <1442397404-7579-7-git-send-email-ckeepax@opensource.wolfsonmicro.com> (raw)
In-Reply-To: <1442397404-7579-1-git-send-email-ckeepax-yzvPICuk2AATkU/dhu1WVueM+bqZidxxQQ4Iyu8u01E@public.gmane.org>

Add additional bindings for both inverting the polarity of the jack
detection pins and allowing the use of a second jack detection pin. Note
that the second jack detection pin is hard wired in the chip so can only
be enabled through the binding, rather than a pin being specified.

Signed-off-by: Charles Keepax <ckeepax-yzvPICuk2AATkU/dhu1WVueM+bqZidxxQQ4Iyu8u01E@public.gmane.org>
Reviewed-by: Chanwoo Choi <cw00.choi-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
---
 Documentation/devicetree/bindings/mfd/arizona.txt |    6 ++++++
 1 files changed, 6 insertions(+), 0 deletions(-)

diff --git a/Documentation/devicetree/bindings/mfd/arizona.txt b/Documentation/devicetree/bindings/mfd/arizona.txt
index b98a11b..cb3a652 100644
--- a/Documentation/devicetree/bindings/mfd/arizona.txt
+++ b/Documentation/devicetree/bindings/mfd/arizona.txt
@@ -73,6 +73,12 @@ Optional properties:
     If this node is not mentioned or if the value is unknown, then
     headphone detection mode is set to HPDETL.
 
+  - wlf,use-jd-gpio : Use GPIO input along with JD1 for dual pin jack
+    detection.
+  - wlf,use-jd-gpio-nopull : Internal pull on GPIO is disabled when used for
+    jack detection.
+  - wlf,jd-invert : Invert the polarity of the jack detection switch
+
   - wlf,micd-software-compare : Use a software comparison to determine mic
     presence
   - wlf,micd-detect-debounce : Additional software microphone detection
-- 
1.7.2.5

--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

WARNING: multiple messages have this Message-ID (diff)
From: Charles Keepax <ckeepax@opensource.wolfsonmicro.com>
To: <cw00.choi@samsung.com>, <lee.jones@linaro.org>
Cc: <robh+dt@kernel.org>, <pawel.moll@arm.com>,
	<mark.rutland@arm.com>, <ijc+devicetree@hellion.org.uk>,
	<galak@codeaurora.org>, <myungjoo.ham@samsung.com>,
	<sameo@linux.intel.com>, <devicetree@vger.kernel.org>,
	<linux-kernel@vger.kernel.org>
Subject: [PATCH 6/6] mfd: arizona: Update DT binding documentation for jack detection
Date: Wed, 16 Sep 2015 10:56:44 +0100	[thread overview]
Message-ID: <1442397404-7579-7-git-send-email-ckeepax@opensource.wolfsonmicro.com> (raw)
In-Reply-To: <1442397404-7579-1-git-send-email-ckeepax@opensource.wolfsonmicro.com>

Add additional bindings for both inverting the polarity of the jack
detection pins and allowing the use of a second jack detection pin. Note
that the second jack detection pin is hard wired in the chip so can only
be enabled through the binding, rather than a pin being specified.

Signed-off-by: Charles Keepax <ckeepax@opensource.wolfsonmicro.com>
Reviewed-by: Chanwoo Choi <cw00.choi@samsung.com>
---
 Documentation/devicetree/bindings/mfd/arizona.txt |    6 ++++++
 1 files changed, 6 insertions(+), 0 deletions(-)

diff --git a/Documentation/devicetree/bindings/mfd/arizona.txt b/Documentation/devicetree/bindings/mfd/arizona.txt
index b98a11b..cb3a652 100644
--- a/Documentation/devicetree/bindings/mfd/arizona.txt
+++ b/Documentation/devicetree/bindings/mfd/arizona.txt
@@ -73,6 +73,12 @@ Optional properties:
     If this node is not mentioned or if the value is unknown, then
     headphone detection mode is set to HPDETL.
 
+  - wlf,use-jd-gpio : Use GPIO input along with JD1 for dual pin jack
+    detection.
+  - wlf,use-jd-gpio-nopull : Internal pull on GPIO is disabled when used for
+    jack detection.
+  - wlf,jd-invert : Invert the polarity of the jack detection switch
+
   - wlf,micd-software-compare : Use a software comparison to determine mic
     presence
   - wlf,micd-detect-debounce : Additional software microphone detection
-- 
1.7.2.5


  parent reply	other threads:[~2015-09-16  9:56 UTC|newest]

Thread overview: 26+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2015-09-16  9:56 [PATCH 0/6] Arizona Extcon Update Device Bindings Charles Keepax
2015-09-16  9:56 ` Charles Keepax
     [not found] ` <1442397404-7579-1-git-send-email-ckeepax-yzvPICuk2AATkU/dhu1WVueM+bqZidxxQQ4Iyu8u01E@public.gmane.org>
2015-09-16  9:56   ` [PATCH 1/6] extcon: arizona: Add device binding to enable ADC mode micdet Charles Keepax
2015-09-16  9:56     ` Charles Keepax
2015-09-25  0:54     ` Chanwoo Choi
2015-09-16  9:56   ` Charles Keepax [this message]
2015-09-16  9:56     ` [PATCH 6/6] mfd: arizona: Update DT binding documentation for jack detection Charles Keepax
2015-09-20  4:17     ` Lee Jones
2015-09-16  9:56 ` [PATCH 2/6] extcon: arizona: Add device binding for the general purpose switch Charles Keepax
2015-09-16  9:56   ` Charles Keepax
2015-09-25  0:54   ` Chanwoo Choi
2015-09-16  9:56 ` [PATCH 3/6] extcon: arizona: Add device binding for jack detect polarity inversion Charles Keepax
2015-09-16  9:56   ` Charles Keepax
2015-09-16  9:56 ` [PATCH 4/6] extcon: arizona: Add device binding for second jack detect pin on GPIO5 Charles Keepax
2015-09-16  9:56   ` Charles Keepax
     [not found]   ` <1442397404-7579-5-git-send-email-ckeepax-yzvPICuk2AATkU/dhu1WVueM+bqZidxxQQ4Iyu8u01E@public.gmane.org>
2015-09-25  0:54     ` Chanwoo Choi
2015-09-25  0:54       ` Chanwoo Choi
     [not found]       ` <56049B42.7030509-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
2015-09-25  9:10         ` Charles Keepax
2015-09-25  9:10           ` Charles Keepax
2015-09-27  4:50           ` Chanwoo Choi
2015-09-16  9:56 ` [PATCH 5/6] mfd: arizona: Update DT binding documentation for mic detection Charles Keepax
2015-09-16  9:56   ` Charles Keepax
2015-09-20  4:16   ` Lee Jones
  -- strict thread matches above, loose matches on Subject: below --
2015-09-10 11:41 [PATCH 1/6] mfd: arizona: Add TST_CAP bits for headphone detection Charles Keepax
2015-09-10 11:41 ` [PATCH 6/6] mfd: arizona: Update DT binding documentation for jack detection Charles Keepax
2015-09-10 11:41   ` Charles Keepax
2015-09-11  8:09   ` Chanwoo Choi

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1442397404-7579-7-git-send-email-ckeepax@opensource.wolfsonmicro.com \
    --to=ckeepax-yzvpicuk2aatku/dhu1wvuem+bqzidxxqq4iyu8u01e@public.gmane.org \
    --cc=cw00.choi-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org \
    --cc=devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
    --cc=galak-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org \
    --cc=ijc+devicetree-KcIKpvwj1kUDXYZnReoRVg@public.gmane.org \
    --cc=lee.jones-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org \
    --cc=linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
    --cc=mark.rutland-5wv7dgnIgG8@public.gmane.org \
    --cc=myungjoo.ham-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org \
    --cc=pawel.moll-5wv7dgnIgG8@public.gmane.org \
    --cc=robh+dt-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org \
    --cc=sameo-VuQAYsv1563Yd54FQh9/CA@public.gmane.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.