Re: [RFC PATCHv2] usb: USB Type-C Connector Class

[Oliver Neukum <oneukum@suse.com>]

On Wed, 2016-06-01 at 16:29 -0700, Guenter Roeck wrote:
> On Wed, Jun 01, 2016 at 11:26:09AM +0200, Oliver Neukum wrote:
> > On Thu, 2016-05-19 at 15:44 +0300, Heikki Krogerus wrote:
> > > Just noticed that the "active" file is for now read only, but it needs
> > > to be changed to writable. That file will of course provide means for
> > > the userspace to Exit and Enter modes. But please note that the
> > > responsibility of the dependencies between the modes, say, if a plug
> > > needs to be in one mode or the other in order for the partner to enter
> > > some specific mode, will fall on the Alternate Mode specific drivers
> > > once we have the altmode bus. I remember there were concerns about
> > > this in the original thread.
> > 
> > There's one thing we haven't touched upon yet. And I cannot really find
> > an answer in the spec.
> > 
> > What do we do if we return from S4 or S3? I think we need to restore
> > the ALternate Mode because our display may be running over that
> > Alternate Mode.
> > If we want to support USB persist we also need to restore data role
> > after S4.
> > 
> I don't have an answer ... but another interesting question.
> 
> How do we distinguish between alternate modes supported by a host vs.
> alternate modes supported by a sink ? typec_capability includes a pointer
> to alternate modes supportedf by the connector, but it is not clear if
> those are alternate modes supported as host, or alternate modes supported
> as device, or alternate modes supported by both.

I was under the impression that this applies to the current role.

> This doesn't matter much if only a fixed role is supported, but it does matter
> for dual role ports. A laptop will typically only support DisplayPort as host,
> for example.
> 
> Any idea ?

I would state the obvious that we need separate directories for that.
And how do we express captive cables?

	Regards
		Oliver