[PATCH 12/16] e1000/base: always request clock during K1 at 1G link speed

[Wenzhuo Lu <wenzhuo.lu@intel.com>]

This works around a possible stalled packet issue, which may
occur due to clock recovery from the PCH being too slow, when
the LAN is transitioning from K1 at 1G link speed.

Signed-off-by: Wenzhuo Lu <wenzhuo.lu@intel.com>
---
 drivers/net/e1000/base/e1000_ich8lan.c | 10 ++++++++++
 drivers/net/e1000/base/e1000_ich8lan.h |  2 +-
 2 files changed, 11 insertions(+), 1 deletion(-)

diff --git a/drivers/net/e1000/base/e1000_ich8lan.c b/drivers/net/e1000/base/e1000_ich8lan.c
index 7ab0f7c..89265d2 100644
--- a/drivers/net/e1000/base/e1000_ich8lan.c
+++ b/drivers/net/e1000/base/e1000_ich8lan.c
@@ -1584,6 +1584,16 @@ STATIC s32 e1000_check_for_copper_link_ich8lan(struct e1000_hw *hw)
 			hw->phy.ops.write_reg_locked(hw,
 						     I217_PLL_CLOCK_GATE_REG,
 						     phy_reg);
+
+			if (speed == SPEED_1000) {
+				hw->phy.ops.read_reg_locked(hw, HV_PM_CTRL,
+							    &phy_reg);
+
+				phy_reg |= HV_PM_CTRL_K1_CLK_REQ;
+
+				hw->phy.ops.write_reg_locked(hw, HV_PM_CTRL,
+							     phy_reg);
+				}
 		 }
 		hw->phy.ops.release(hw);
 
diff --git a/drivers/net/e1000/base/e1000_ich8lan.h b/drivers/net/e1000/base/e1000_ich8lan.h
index 50e0e79..bc4ed1d 100644
--- a/drivers/net/e1000/base/e1000_ich8lan.h
+++ b/drivers/net/e1000/base/e1000_ich8lan.h
@@ -250,7 +250,7 @@ POSSIBILITY OF SUCH DAMAGE.
 
 /* PHY Power Management Control */
 #define HV_PM_CTRL		PHY_REG(770, 17)
-#define HV_PM_CTRL_PLL_STOP_IN_K1_GIGA	0x100
+#define HV_PM_CTRL_K1_CLK_REQ		0x200
 #define HV_PM_CTRL_K1_ENABLE		0x4000
 
 #define I217_PLL_CLOCK_GATE_REG	PHY_REG(772, 28)
-- 
1.9.3