Re: [PATCH v7 2/2] soc: mediatek: add mt6779 devapc driver

[Neal Liu <neal.liu@mediatek.com>]

On Thu, 2020-10-08 at 10:35 +0800, Neal Liu wrote:
> On Wed, 2020-10-07 at 12:44 +0200, Matthias Brugger wrote:
> > 
> > On 27/08/2020 05:06, Neal Liu wrote:
[...]

> > > +static int devapc_sync_vio_dbg(struct mtk_devapc_context *ctx)
> > > +{
> > > +	void __iomem *pd_vio_shift_sta_reg;
> > > +	void __iomem *pd_vio_shift_sel_reg;
> > > +	void __iomem *pd_vio_shift_con_reg;
> > > +	int min_shift_group;
> > > +	int ret;
> > > +	u32 val;
> > > +
> > > +	pd_vio_shift_sta_reg = ctx->infra_base +
> > > +			       ctx->data->vio_shift_sta_offset;
> > > +	pd_vio_shift_sel_reg = ctx->infra_base +
> > > +			       ctx->data->vio_shift_sel_offset;
> > > +	pd_vio_shift_con_reg = ctx->infra_base +
> > > +			       ctx->data->vio_shift_con_offset;
> > > +
> > > +	/* Find the minimum shift group which has violation */
> > > +	val = readl(pd_vio_shift_sta_reg);
> > > +	if (!val)
> > > +		return false;
> > 
> > So bit 0 of selection register (pd_vio_shift_sel_reg) does not represent a 
> > violation group?
> > I don't know how the HW works, but is seems odd to me. In case that's bit 0 
> > actually doesn't represent anything: how can an interrupt be triggered without 
> > any debug information present (means val == 0)?
> 
> This check implies HW status has something wrong. It cannot get any
> debug information for this case.
> It won't happen in normal scenario. Should we remove this check?
> 

Sorry, I missed the most common part. Is function is in the while loop:
while (devapc_sync_vio_dbg(ctx))
...

We keep find the minimum bit in pd_vio_shift_sta_reg to get the
violation information, (pd_vio_shift_sta_reg might raise multiple bits)
until all raised bit (shift group) has been handled.
So I don't think it's necessary to add WARN message in this case.
Thanks

> > 
> > > +
> > > +	min_shift_group = __ffs(val);
> > > +
> > > +	/* Assign the group to sync */
> > > +	writel(0x1 << min_shift_group, pd_vio_shift_sel_reg);
> > > +
> > > +	/* Start syncing */
> > > +	writel(0x1, pd_vio_shift_con_reg);
> > > +
> > > +	ret = readl_poll_timeout(pd_vio_shift_con_reg, val, val == 0x3, 0,
> > > +				 PHY_DEVAPC_TIMEOUT);
> > > +	if (ret) {
> > > +		dev_err(ctx->dev, "%s: Shift violation info failed\n", __func__);
> > 
> > In which case this can happen? I'm asking, because we are calling 
> > devapc_sync_vio_dbg() in a while loop that could make the kernel hang here.
> > 
> > Do I understand correctly, that we are using the while loop, because there can 
> > be more then one violation group which got triggered (read, more then one bit is 
> > set in pd_vio_shift_sta_reg)? Would it make more sense then to read the register 
> > once and do all the shift operation for all groups which bit set to 1 in the 
> > shift status register?
> 
> Yes, your understanding is correct.
> This check also implies HW status has something wrong. We return false
> to skip further violation info dump.
> How could this case make the kernel hang?
> 
> > 
> > > +		return false;
> > > +	}
> > > +
> > > +	/* Stop syncing */
> > > +	writel(0x0, pd_vio_shift_con_reg);
> > > +
> > > +	/* Write clear */
> > > +	writel(0x1 << min_shift_group, pd_vio_shift_sta_reg);
> > > +
> > > +	return true;
> > > +}
> > > +
> > > +/*
> > > + * devapc_extract_vio_dbg - extract full violation information after doing
> > > + *                          shift mechanism.
> > > + */
> > > +static void devapc_extract_vio_dbg(struct mtk_devapc_context *ctx)
> > > +{
> > > +	struct mtk_devapc_vio_dbgs vio_dbgs;
> > > +	void __iomem *vio_dbg0_reg;
> > > +	void __iomem *vio_dbg1_reg;
> > > +
> > > +	vio_dbg0_reg = ctx->infra_base + ctx->data->vio_dbg0_offset;
> > > +	vio_dbg1_reg = ctx->infra_base + ctx->data->vio_dbg1_offset;
> > > +
> > > +	vio_dbgs.vio_dbg0 = readl(vio_dbg0_reg);
> > > +	vio_dbgs.vio_dbg1 = readl(vio_dbg1_reg);
> > > +
> > > +	/* Print violation information */
> > > +	if (vio_dbgs.dbg0_bits.vio_w)
> > > +		dev_info(ctx->dev, "Write Violation\n");
> > > +	else if (vio_dbgs.dbg0_bits.vio_r)
> > > +		dev_info(ctx->dev, "Read Violation\n");
> > > +
> > > +	dev_info(ctx->dev, "Bus ID:0x%x, Dom ID:0x%x, Vio Addr:0x%x\n",
> > > +		 vio_dbgs.dbg0_bits.mstid, vio_dbgs.dbg0_bits.dmnid,
> > > +		 vio_dbgs.vio_dbg1);
> > > +}
> > > +
> > > +/*
> > > + * devapc_violation_irq - the devapc Interrupt Service Routine (ISR) will dump
> > > + *                        violation information including which master violates
> > > + *                        access slave.
> > > + */
> > > +static irqreturn_t devapc_violation_irq(int irq_number,
> > > +					struct mtk_devapc_context *ctx)
> > 
> > static irqreturn_t devapc_violation_irq(int irq_number, void *data)
> > {
> > 	struct mtk_devapc_context *ctx = data;
> 
> Okay, I'll fix it on next patch.
> Thanks
> 
> > 
> > > +{
> > > +	while (devapc_sync_vio_dbg(ctx))
> > > +		devapc_extract_vio_dbg(ctx);
> > > +
> > > +	clear_vio_status(ctx);
> > > +
> > > +	return IRQ_HANDLED;
> > > +}
> > > +
> > > +/*
> > > + * start_devapc - unmask slave's irq to start receiving devapc violation.
> > > + */
> > > +static void start_devapc(struct mtk_devapc_context *ctx)
> > > +{
> > > +	writel(BIT(31), ctx->infra_base + ctx->data->apc_con_offset);
> > > +
> > > +	mask_module_irq(ctx, false);
> > > +}
> > > +
> > > +/*
> > > + * stop_devapc - mask slave's irq to stop service.
> > > + */
> > > +static void stop_devapc(struct mtk_devapc_context *ctx)
> > > +{
> > > +	mask_module_irq(ctx, true);
> > > +
> > > +	writel(BIT(2), ctx->infra_base + ctx->data->apc_con_offset);
> > > +}
> > > +
> > > +static const struct mtk_devapc_data devapc_mt6779 = {
> > > +	.vio_idx_num = 511,
> > > +	.vio_mask_offset = 0x0,
> > > +	.vio_sta_offset = 0x400,
> > > +	.vio_dbg0_offset = 0x900,
> > > +	.vio_dbg1_offset = 0x904,
> > > +	.apc_con_offset = 0xF00,
> > > +	.vio_shift_sta_offset = 0xF10,
> > > +	.vio_shift_sel_offset = 0xF14,
> > > +	.vio_shift_con_offset = 0xF20,
> > > +};
> > > +
> > > +static const struct of_device_id mtk_devapc_dt_match[] = {
> > > +	{
> > > +		.compatible = "mediatek,mt6779-devapc",
> > > +		.data = &devapc_mt6779,
> > > +	}, {
> > > +	},
> > > +};
> > > +
> > > +static int mtk_devapc_probe(struct platform_device *pdev)
> > > +{
> > > +	struct device_node *node = pdev->dev.of_node;
> > > +	struct mtk_devapc_context *ctx;
> > > +	u32 devapc_irq;
> > > +	int ret;
> > > +
> > > +	if (IS_ERR(node))
> > > +		return -ENODEV;
> > > +
> > > +	ctx = devm_kzalloc(&pdev->dev, sizeof(*ctx), GFP_KERNEL);
> > > +	if (!ctx)
> > > +		return -ENOMEM;
> > > +
> > > +	ctx->data = of_device_get_match_data(&pdev->dev);
> > > +	ctx->dev = &pdev->dev;
> > > +
> > > +	ctx->infra_base = of_iomap(node, 0);
> > 
> > Does this mean the device is part of the infracfg block?
> > I wasn't able to find any information about it.
> 
> I'm not sure why you would ask infracfg block. devapc is parts of our
> SoC infra, it's different with infracfg.
> 
> > 
> > > +	if (!ctx->infra_base)
> > > +		return -EINVAL;
> > > +
> > > +	devapc_irq = irq_of_parse_and_map(node, 0);
> > > +	if (!devapc_irq)
> > > +		return -EINVAL;
> > > +
> > > +	ctx->infra_clk = devm_clk_get(&pdev->dev, "devapc-infra-clock");
> > > +	if (IS_ERR(ctx->infra_clk))
> > > +		return -EINVAL;
> > > +
> > > +	if (clk_prepare_enable(ctx->infra_clk))
> > > +		return -EINVAL;
> > > +
> > > +	ret = devm_request_irq(&pdev->dev, devapc_irq,
> > > +			       (irq_handler_t)devapc_violation_irq,
> > 
> > No cast should be needed.
> 
> Okay, I'll remove it on next patch.
> Thanks
> 
> > 
> > > +			       IRQF_TRIGGER_NONE, "devapc", ctx);
> > > +	if (ret) {
> > > +		clk_disable_unprepare(ctx->infra_clk);
> > > +		return ret;
> > > +	}
> > > +
> > > +	platform_set_drvdata(pdev, ctx);
> > > +
> > > +	start_devapc(ctx);
> > > +
> > > +	return 0;
> > > +}
> > > +
> > > +static int mtk_devapc_remove(struct platform_device *pdev)
> > > +{
> > > +	struct mtk_devapc_context *ctx = platform_get_drvdata(pdev);
> > > +
> > > +	stop_devapc(ctx);
> > > +
> > > +	clk_disable_unprepare(ctx->infra_clk);
> > > +
> > > +	return 0;
> > > +}
> > > +
> > > +static struct platform_driver mtk_devapc_driver = {
> > > +	.probe = mtk_devapc_probe,
> > > +	.remove = mtk_devapc_remove,
> > > +	.driver = {
> > > +		.name = KBUILD_MODNAME,
> > 
> > .name = "mtk-devapc",
> 
> Okay, I'll add it on next patch.
> Thanks
> 
> > 
> > Regards,
> > Matthias
> 
> 

_______________________________________________
Linux-mediatek mailing list
Linux-mediatek@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-mediatek