From: patchwork-bot+netdevbpf@kernel.org
To: Ali Rouhi <arouhi@sitime.com>
Cc: jiri@resnulli.us, vadim.fedorenko@linux.dev,
arkadiusz.kubalewski@intel.com, ivecera@redhat.com,
kuba@kernel.org, pabeni@redhat.com, robh@kernel.org,
krzk+dt@kernel.org, conor+dt@kernel.org, cjubran@nvidia.com,
Oleg.Zadorozhnyi@devoxsoftware.com, devicetree@vger.kernel.org,
netdev@vger.kernel.org, linux-kernel@vger.kernel.org
Subject: Re: [PATCH net-next v11 00/13] dpll: add SiTime SiT9531x DPLL clock driver
Date: Wed, 07 Oct 2026 02:10:05 +0000 [thread overview]
Message-ID: <179133900528.2873267.11554390181799157650.git-patchwork-notify@kernel.org> (raw)
In-Reply-To: <20260930233714.87679-1-arouhi@sitime.com>
Hello:
This series was applied to netdev/net-next.git (main)
by Jakub Kicinski <kuba@kernel.org>:
On Wed, 30 Sep 2026 23:37:15 +0000 you wrote:
> This series adds a DPLL subsystem driver for the SiTime SiT95316 and
> SiT95317 I2C clock generators. Each device integrates four PLLs with
> automatic reference selection and on-chip TDC phase-offset measurement,
> and is used for synchronization in telecom, networking, and data-center
> timing.
>
> The series contains the device-tree binding, the driver under
> drivers/dpll/sit9531x/, and the MAINTAINERS entry.
>
> [...]
Here is the summary with links:
- [net-next,v11,01/13] dt-bindings: dpll: allow hex unit addresses on output pins
https://git.kernel.org/netdev/net-next/c/45ad84d2800e
- [net-next,v11,02/13] dt-bindings: vendor-prefixes: add SiTime Corporation
(no matching commit)
- [net-next,v11,03/13] dt-bindings: dpll: add SiTime SiT95316 clock generator
(no matching commit)
- [net-next,v11,04/13] dpll: add basic SiTime SiT9531x support
(no matching commit)
- [net-next,v11,05/13] dpll: sit9531x: read DPLL types and pin properties from system firmware
(no matching commit)
- [net-next,v11,06/13] dpll: sit9531x: register DPLL devices and pins
(no matching commit)
- [net-next,v11,07/13] dpll: sit9531x: implement input pin state on a DPLL
(no matching commit)
- [net-next,v11,08/13] dpll: sit9531x: add support to get and set priority on input pins
(no matching commit)
- [net-next,v11,10/13] dpll: sit9531x: implement output pin state on a DPLL
(no matching commit)
- [net-next,v11,09/13] dpll: sit9531x: add support to get and set frequency on pins
(no matching commit)
- [net-next,v11,11/13] dpll: sit9531x: add support to adjust output phase
(no matching commit)
- [net-next,v11,12/13] dpll: sit9531x: add support to get phase offset on the connected input pin
(no matching commit)
- [net-next,v11,13/13] dpll: sit9531x: model the inter-PLL sync net as a pair of pins
(no matching commit)
You are awesome, thank you!
--
Deet-doot-dot, I am a bot.
https://korg.docs.kernel.org/patchwork/pwbot.html
prev parent reply other threads:[~2026-10-07 2:10 UTC|newest]
Thread overview: 41+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-09-30 23:37 [PATCH net-next v11 00/13] dpll: add SiTime SiT9531x DPLL clock driver Ali Rouhi
2026-09-30 23:37 ` [PATCH net-next v11 01/13] dt-bindings: dpll: allow hex unit addresses on output pins Ali Rouhi
2026-10-02 8:32 ` Krzysztof Kozlowski
2026-09-30 23:37 ` [PATCH net-next v11 03/13] dt-bindings: dpll: add SiTime SiT95316 clock generator Ali Rouhi
2026-10-05 1:09 ` netdev-bot+sashiko
2026-10-09 18:23 ` Ali Rouhi
2026-10-06 3:22 ` Rob Herring (Arm)
2026-10-09 18:23 ` Ali Rouhi
2026-09-30 23:37 ` [PATCH net-next v11 02/13] dt-bindings: vendor-prefixes: add SiTime Corporation Ali Rouhi
2026-09-30 23:37 ` [PATCH net-next v11 04/13] dpll: add basic SiTime SiT9531x support Ali Rouhi
2026-10-05 1:09 ` netdev-bot+sashiko
2026-10-09 18:23 ` Ali Rouhi
2026-09-30 23:37 ` [PATCH net-next v11 05/13] dpll: sit9531x: read DPLL types and pin properties from system firmware Ali Rouhi
2026-10-05 1:09 ` netdev-bot+sashiko
2026-10-09 18:23 ` Ali Rouhi
2026-09-30 23:37 ` [PATCH net-next v11 06/13] dpll: sit9531x: register DPLL devices and pins Ali Rouhi
2026-10-05 1:09 ` netdev-bot+sashiko
2026-10-09 18:23 ` Ali Rouhi
2026-09-30 23:37 ` [PATCH net-next v11 07/13] dpll: sit9531x: implement input pin state on a DPLL Ali Rouhi
2026-10-05 1:10 ` netdev-bot+sashiko
2026-10-09 18:23 ` Ali Rouhi
2026-09-30 23:37 ` [PATCH net-next v11 08/13] dpll: sit9531x: add support to get and set priority on input pins Ali Rouhi
2026-10-05 1:10 ` netdev-bot+sashiko
2026-10-09 18:23 ` Ali Rouhi
2026-09-30 23:37 ` [PATCH net-next v11 09/13] dpll: sit9531x: add support to get and set frequency on pins Ali Rouhi
2026-10-05 1:10 ` netdev-bot+sashiko
2026-10-09 18:23 ` Ali Rouhi
2026-09-30 23:37 ` [PATCH net-next v11 10/13] dpll: sit9531x: implement output pin state on a DPLL Ali Rouhi
2026-10-05 1:10 ` netdev-bot+sashiko
2026-10-09 18:23 ` Ali Rouhi
2026-09-30 23:37 ` [PATCH net-next v11 11/13] dpll: sit9531x: add support to adjust output phase Ali Rouhi
2026-10-05 1:10 ` netdev-bot+sashiko
2026-10-09 18:23 ` Ali Rouhi
2026-09-30 23:37 ` [PATCH net-next v11 12/13] dpll: sit9531x: add support to get phase offset on the connected input pin Ali Rouhi
2026-10-05 1:10 ` netdev-bot+sashiko
2026-10-09 18:23 ` Ali Rouhi
2026-09-30 23:37 ` [PATCH net-next v11 13/13] dpll: sit9531x: model the inter-PLL sync net as a pair of pins Ali Rouhi
2026-10-02 9:14 ` sashiko-bot
2026-10-05 1:10 ` netdev-bot+sashiko
2026-10-09 18:23 ` Ali Rouhi
2026-10-07 2:10 ` patchwork-bot+netdevbpf [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=179133900528.2873267.11554390181799157650.git-patchwork-notify@kernel.org \
--to=patchwork-bot+netdevbpf@kernel.org \
--cc=Oleg.Zadorozhnyi@devoxsoftware.com \
--cc=arkadiusz.kubalewski@intel.com \
--cc=arouhi@sitime.com \
--cc=cjubran@nvidia.com \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=ivecera@redhat.com \
--cc=jiri@resnulli.us \
--cc=krzk+dt@kernel.org \
--cc=kuba@kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=netdev@vger.kernel.org \
--cc=pabeni@redhat.com \
--cc=robh@kernel.org \
--cc=vadim.fedorenko@linux.dev \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.