Re: [PATCH] net: add init-regs for of_phy support

[Laurent Pinchart <laurent.pinchart@ideasonboard.com>]

Hi Ben,

On Monday 17 February 2014 14:12:22 Mark Rutland wrote:
> On Mon, Feb 17, 2014 at 01:50:28PM +0000, Ben Dooks wrote:
> > On 17/02/14 13:44, Mark Rutland wrote:
> > > On Mon, Feb 17, 2014 at 01:08:04PM +0000, Ben Dooks wrote:
> > >> Add new init-regs field for of_phy nodes and make sure these
> > >> get applied when the phy is configured.
> > >> 
> > >> This allows any phy node in an fdt to initialise registers
> > >> that may not be set as standard by the driver at initialisation
> > >> time, such as LED controls.
> > > 
> > > Why not have a driver for the particular PHY? If it's not standard we
> > > don't need to pretend it is. If it has some extensions then the standard
> > > compatible string can be a fallback entry in the compatible list.
> > 
> > I was trying to provide some useful and reasonably generic code
> > to setup PHYs without having to add specific arguments to each of
> > them.
> > 
> > I could have added something like ksz8041,led-mode1 = <1> and
> > updated the micrel driver.
> 
> Perhaps. It depends on precisely what the property is describing.
> 
> I think describing the hardware and letting Linux figure out what to do
> is better than giving it a set of opaque instructions for it to blindly
> follow.

I second that, I think a LED mode property would be better in this case.

-- 
Regards,

Laurent Pinchart