Re: [PATCH 1/7] powerpc: Add mpc8360epb platform support

[Vitaly Bordug <vbordug@ru.mvista.com>]

On Thu, 29 Jun 2006 13:03:23 -0500
Andy Fleming wrote:

[snip]
> >>> +	iounmap(bcsr_regs);
> >>> +
> >> And if we have a design, which do not contain real ethernet UCC  
> >> usage? Or UCC
> >> geth is disabled somehow explicitly? Stuff like that normally
> >> goes to the
> >> callback that is going to be triggered upon Etherbet init.
> > I will move it.
> 
> 
> Wait...no.  I don't understand Vitaly's objection.  If someone  
> creates a board with an 8360 that doesn't use the UCC ethernet, they  
> can create a separate board file.  This is the board-specific code,  
> and it is perfectly acceptable for it to reset the PHY like this.   
> What ethernet callback could be used?
> 

I am sort of against the unconditional trigger of the ethernet-specific stuff,
dependless if UCC eth is really wanted in specific configuration.

For stuff like that I'd make a function (to setup low-level stuff), and pass it 
via platform_info to the eth driver, so that really driver-specific things happen in driver context only.

Yes this is board specific file, and virtually everything needed for the board can take place here. 
But usually BCSR acts as a toggle for a several things, and IOW, I see it more correct to trigger those stuff from the respective drivers (using a callback passed through platform_info)

-Vitaly