ACPI and CDROM problems

ACPI and CDROM problems

[Werner LEMBERG]

I have an inspiron 6400 (running SuSE 10.0), using kernel 2.6.18
(unmodified) together with harddisk suspend.  This laptop showed
severe problems at resuming with 2.6.17 (about 1 out of 5 resumes
failed).  Now, with 2.6.18, about 1 out of 30 doesn't work.

It takes about 20 seconds, then a normal reboot happens.

Before sending various configuration and log data I wonder what I
shall specifically do to improve debugging so that you get meaningful
data in case it is a new problem (I searched the archive but doesn't
found something relevant).  In particular, which debugging flags shall
I activate -- if I enable all of them, my `/var/log/messages' file
increases by about 100k per second...  And the default settings
doesn't show anything suspicious.


    Werner

Re: ACPI and CDROM problems

[Rafael J. Wysocki]

On Saturday, 21 October 2006 06:58, Werner LEMBERG wrote:
> 
> I have an inspiron 6400 (running SuSE 10.0), using kernel 2.6.18
> (unmodified) together with harddisk suspend.  This laptop showed
> severe problems at resuming with 2.6.17 (about 1 out of 5 resumes
> failed).  Now, with 2.6.18, about 1 out of 30 doesn't work.
> 
> It takes about 20 seconds, then a normal reboot happens.

I assume this is the suspend to RAM that doesn't work?  Have you tried using
swsusp (suspend to disk)?

Rafael


-- 
You never change things by fighting the existing reality.
		R. Buckminster Fuller

Re: ACPI and CDROM problems

[Werner LEMBERG]

> > I have an inspiron 6400 (running SuSE 10.0), using kernel 2.6.18
> > (unmodified) together with harddisk suspend.  This laptop showed
> > severe problems at resuming with 2.6.17 (about 1 out of 5 resumes
> > failed).  Now, with 2.6.18, about 1 out of 30 doesn't work.
> >
> > It takes about 20 seconds, then a normal reboot happens.
> 
> I assume this is the suspend to RAM that doesn't work?

I have never tried suspend to RAM.  I only use suspend to disk.

> Have you tried using swsusp (suspend to disk)?

No, and I'm too lazy to try that.  I'm writing to this list so that I
can help in fixing problems.  For example, I could compile and run a
newer kernel in case this is of benefit.  As mentioned before, I just
need advice which kind of data, setup, etc., you need so that I
produce valuable information.


    Werner

ACPI and CDROM problems

[Werner LEMBERG]

I have an inspiron 6400, using kernel 2.6.17 together with harddisk
suspend.  This laptop shows severe problems at resuming if a music CD
is in the drive.  In many cases it works fine, but sometimes[*] it
happens that the process stops after these lines have appeared on the
screen (approximately):

  sr0: scsi3-mmc drive: 24x/24x writer cd/rw xa/form2 cdda tray
       Uniform CD-ROM driver Revision: 3.20
       sr 1:0:0:0: Attached scsi CD-ROM sr0

It takes about 20 seconds, then a normal reboot happens.

Either the cdrom drive has a problem with recovering, or the resume
process doesn't wait long enough before continuing.

Before sending various configuration and log data I wonder what I
shall specifically do to improve debugging so that you get meaningful
data in case it is a new problem (I searched the archive but doesn't
found something relevant).

Maybe it isn't a bug at all, and I just have to improve configuration
-- please advise.


    Werner


[*] At least 1 out of 10 tries.