From: Anton Vorontsov <avorontsov-hkdhdckH98+B+jHODAdFcQ@public.gmane.org>
To: linuxppc-dev-mnsaURCQ41sdnm+yROfE0A@public.gmane.org
Cc: spi-devel-general-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org
Subject: [PATCH 7/7] [POWERPC][SPI] spi_mpc83xx: allow use on MPC85xx
Date: Tue, 25 Sep 2007 18:35:31 +0400 [thread overview]
Message-ID: <20070925143531.GG5323@localhost.localdomain> (raw)
In-Reply-To: <20070925143126.GA30013-bi+AKbBUZKY6gyzm1THtWbp2dZbC/Bob@public.gmane.org>
MPC85xx's QE SPI controller is almost the same comparing to MPC83xx.
Thus lets use that driver. Tested to work in loopback mode.
Signed-off-by: Anton Vorontsov <avorontsov-hkdhdckH98+B+jHODAdFcQ@public.gmane.org>
---
drivers/spi/Kconfig | 2 +-
1 files changed, 1 insertions(+), 1 deletions(-)
diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig
index b915711..14f0d0d 100644
--- a/drivers/spi/Kconfig
+++ b/drivers/spi/Kconfig
@@ -125,7 +125,7 @@ config SPI_MPC52xx_PSC
config SPI_MPC83xx
tristate "Freescale MPC83xx SPI controller"
- depends on SPI_MASTER && PPC_83xx && EXPERIMENTAL
+ depends on SPI_MASTER && (PPC_83xx || PPC_85xx) && EXPERIMENTAL
select SPI_BITBANG
help
This enables using the Freescale MPC83xx SPI controller in master
--
1.5.0.6
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
WARNING: multiple messages have this Message-ID (diff)
From: Anton Vorontsov <avorontsov@ru.mvista.com>
To: linuxppc-dev@ozlabs.org
Cc: spi-devel-general@lists.sourceforge.net
Subject: [PATCH 7/7] [POWERPC][SPI] spi_mpc83xx: allow use on MPC85xx
Date: Tue, 25 Sep 2007 18:35:31 +0400 [thread overview]
Message-ID: <20070925143531.GG5323@localhost.localdomain> (raw)
In-Reply-To: <20070925143126.GA30013@localhost.localdomain>
MPC85xx's QE SPI controller is almost the same comparing to MPC83xx.
Thus lets use that driver. Tested to work in loopback mode.
Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
---
drivers/spi/Kconfig | 2 +-
1 files changed, 1 insertions(+), 1 deletions(-)
diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig
index b915711..14f0d0d 100644
--- a/drivers/spi/Kconfig
+++ b/drivers/spi/Kconfig
@@ -125,7 +125,7 @@ config SPI_MPC52xx_PSC
config SPI_MPC83xx
tristate "Freescale MPC83xx SPI controller"
- depends on SPI_MASTER && PPC_83xx && EXPERIMENTAL
+ depends on SPI_MASTER && (PPC_83xx || PPC_85xx) && EXPERIMENTAL
select SPI_BITBANG
help
This enables using the Freescale MPC83xx SPI controller in master
--
1.5.0.6
next prev parent reply other threads:[~2007-09-25 14:35 UTC|newest]
Thread overview: 32+ messages / expand[flat|nested] mbox.gz Atom feed top
2007-09-25 14:31 MPC85xx_MDS: Patches to support QE, UCCs and SPI Anton Vorontsov
2007-09-25 14:34 ` [PATCH 1/7] [POWERPC] mpc85xx_mds: select QUICC_ENGINE Anton Vorontsov
2007-09-25 14:34 ` [PATCH 2/7] [POWERPC] Fix QEIC->MPIC cascading Anton Vorontsov
2007-10-01 23:14 ` Benjamin Herrenschmidt
2007-10-02 12:20 ` Anton Vorontsov
2007-10-02 22:02 ` Benjamin Herrenschmidt
2007-10-04 13:04 ` [RFC][PATCH][POWERPC] QEIC: Implement pluggable handlers, fix MPIC cascading Anton Vorontsov
2007-10-04 22:05 ` Benjamin Herrenschmidt
2007-10-05 5:18 ` Kumar Gala
2007-10-05 12:30 ` Anton Vorontsov
2007-09-25 14:34 ` [PATCH 3/7] [POWERPC] QEIC: implement low+high multiplexed IRQ chained handler Anton Vorontsov
2007-09-25 14:34 ` [PATCH 4/7] [POWERPC] QE pario: support for MPC85xx layout Anton Vorontsov
2007-09-25 16:41 ` Kim Phillips
2007-10-05 5:15 ` Kumar Gala
2007-09-25 14:34 ` [PATCH 5/7] [POWERPC] mpc8568mds: update dts to be able to use UCCs Anton Vorontsov
2007-09-25 14:35 ` [PATCH 6/7] [POWERPC] mpc85xx_mds: reset UCC ethernet properly Anton Vorontsov
[not found] ` <20070925143126.GA30013-bi+AKbBUZKY6gyzm1THtWbp2dZbC/Bob@public.gmane.org>
2007-09-25 14:35 ` Anton Vorontsov [this message]
2007-09-25 14:35 ` [PATCH 7/7] [POWERPC][SPI] spi_mpc83xx: allow use on MPC85xx Anton Vorontsov
[not found] ` <20070925143531.GG5323-bi+AKbBUZKY6gyzm1THtWbp2dZbC/Bob@public.gmane.org>
2007-09-25 14:48 ` Peter Korsgaard
2007-09-25 14:48 ` Peter Korsgaard
[not found] ` <874phiol7j.fsf-uXGAPMMVk8amE9MCos8gUmSdvHPH+/yF@public.gmane.org>
2007-09-25 15:02 ` [PATCH v2 " Anton Vorontsov
2007-09-25 15:02 ` Anton Vorontsov
2007-09-25 15:04 ` [PATCH " Kumar Gala
2007-09-25 15:04 ` [spi-devel-general] " Kumar Gala
[not found] ` <16E78F0E-B57B-4084-887E-5D2F9C1D0331-XVmvHMARGAS8U2dJNN8I7kB+6BGkLq7r@public.gmane.org>
2007-09-25 15:18 ` Anton Vorontsov
2007-09-25 15:18 ` [spi-devel-general] " Anton Vorontsov
[not found] ` <20070925151819.GA6757-bi+AKbBUZKY6gyzm1THtWbp2dZbC/Bob@public.gmane.org>
2007-09-25 16:58 ` David Brownell
2007-09-25 16:58 ` [spi-devel-general] " David Brownell
[not found] ` <20070925165845.40B0E2397FB-ZcXrCSuhvln6VZ3dlLfH/g4gEjPzgfUyLrfjE7I9kuVHxeISYlDBzl6hYfS7NtTn@public.gmane.org>
2007-09-26 4:00 ` Kumar Gala
2007-09-26 4:00 ` [spi-devel-general] " Kumar Gala
[not found] ` <7881139C-EEF1-41DC-AB0F-115632E892B8-XVmvHMARGAS8U2dJNN8I7kB+6BGkLq7r@public.gmane.org>
2007-09-26 13:15 ` [PATCH 7/7] [POWERPC][SPI] spi_mpc83xx: allow use on any processors with QUICC Engine Anton Vorontsov
2007-09-26 13:15 ` Anton Vorontsov
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20070925143531.GG5323@localhost.localdomain \
--to=avorontsov-hkdhdckh98+b+jhodadfcq@public.gmane.org \
--cc=linuxppc-dev-mnsaURCQ41sdnm+yROfE0A@public.gmane.org \
--cc=spi-devel-general-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.