Re: E-mu 1212M ADAT channels missing ?

Re: E-mu 1212M ADAT channels missing ?

[Ctirad Fertr]

Dne Monday 19 of November 2007 03:04:15 Kenneth Long napsal(a):
> yeah, that is it.. it use to be hw 0,0.  Its now 0,2.
>
> There seems to be a lot more xruns now...
> is that from something new?
> my kernel is now 2.6.23-gentoo-r1

There shouldn't be any changes in this aspect. Try to increase size of jack 
buffers and check if jack samplerate matches samplerate in alsamixer. 

------
Ctirad



> thank you.
>
> --- Ctirad Fertr <c.fertr@gmail.com> wrote:
> > Dne Sunday 18 of November 2007 05:54:37 Kenneth Long
> >
> > napsal(a):
> > > I'm using qjackctl to launch jackd and before, I
> >
> > would
> >
> > > see the PCM channels appear under "Connect"
> >
> > button.
> >
> > > Alsa_pcm only shows two channels "capture_1 and
> > > capture_2. Before there were 16 channels...
> >
> > Do you use correct capture device in qjackctl? The
> > correct device for
> > multichannel capture is 0,2 (in case your card is
> > 0).
> >
> > ------
> > Ctirad
> > _______________________________________________
> > Alsa-devel mailing list
> > Alsa-devel@alsa-project.org
>
> http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
>
>
>
> hello

Re: E-mu 1212M/1820M/1616M development

[James Courtier-Dutton]

James Courtier-Dutton wrote:
>
>> 2. Non working S/PDIF (and probably ADAT, too) on 1616(M) microdock 
>> ports. I think tese ports uses different set of registers than PCI 
>> 1010 host card. Am I right?
>>   
> Correct, they are different. I will try to update the driver with some 
> details tomorrow.
Comments added into hg repository, in emu10k1.h
alsa changeset: 5529

E-mu 1212M ADAT channels missing ?

[Kenneth Long]

Hi,

I'm using qjackctl to launch jackd and before, I would
see the PCM channels appear under "Connect" button.
Alsa_pcm only shows two channels "capture_1 and
capture_2. Before there were 16 channels... 

I no longer see the ADAT channels. 
I'm doing the same things I did before. 
what happened?  
The channels are setup in alsamixer under
-V capture as well as  -V playback

I'm not able to pull the latest alsa drivers down
right now to see if that changes anything.. 

thanks 
Ken



hello

Re: E-mu 1212M ADAT channels missing ?

[Ctirad Fertr]

Dne Sunday 18 of November 2007 05:54:37 Kenneth Long napsal(a):
> I'm using qjackctl to launch jackd and before, I would
> see the PCM channels appear under "Connect" button.
> Alsa_pcm only shows two channels "capture_1 and
> capture_2. Before there were 16 channels...

Do you use correct capture device in qjackctl? The correct device for 
multichannel capture is 0,2 (in case your card is 0). 

------
Ctirad