From: Wolfgang Denk <wd@denx.de>
To: u-boot@lists.denx.de
Subject: [U-Boot-Users] CUSTODIANS: List of open issues / not applied patches
Date: Wed, 09 Jan 2008 22:36:14 +0100 [thread overview]
Message-ID: <20080109213614.F0F71242E7@gemini.denx.de> (raw)
Hello everybody,
this is a heads-up especially for all custodians...
Please review the following list of postings / patches that - to the
best of my knowledge - habve not been processed yet; at least I did
not mark them as rejected, nor did I find them in the current U-Boot
tree.
If possible, please apply and send pull requests ASAP! Thanks.
[It would be helpful to me if you could include my private message ID
(the number in column 1) when referring to one of these postings;
thanks.]
9799 09/18 urwithsughosh at gma Re: [U-Boot-Users] [PATCH]: Reset issue fix on mpc85xx
9804 09/18 Jason Jin [PATCH] fsl_pci_init Fix command register initialization issue.
9952 09/24 Anatolij Gustschi [U-Boot-Users] [PATCH] Add Fujitsu CoralP/Lime video driver
9967 09/24 Troy Kisky Re: [U-Boot-Users] PATCH - Fix oob data copied into supplied buffer
9969 09/25 Shinya Kuribayash Re: [U-Boot-Users] [MIPS] Make mips_io_port_base more generic
10068 09/28 Vasiliy Leoenenko [PATCH] M18 flash (Sibley) support (attempt 2)
10078 09/28 Dan Wilson [U-Boot-Users] [PATCH] tsec.c patch for receiver reset
10081 09/29 Shinya Kuribayash [MIPS] Make mips_io_port_base more generic
10159 10/04 Vlad Lungu [U-Boot-Users] [PATCH] Target support for qemu -M mips
10281 10/10 Vlad Lungu [PATCH] Fixed pcnet io_base
10282 10/10 Vlad Lungu [PATCH] Added Am79C970A chip id to pcnet
10397 10/12 Tony Li [U-Boot-Users] [PATCH] mpc83xx: Add ATM makefile entry for MPC8360EM
10676 10/22 Anton Vorontsov [U-Boot-Users] [PATCH] MPC8568E-MDS: reset UCCs to use them reliably
10686 10/23 Shinya Kuribayash Re: [U-Boot-Users] [PATCH 1/1] Fix mips_io_port_base multiple declar
10690 10/22 Anton Vorontsov [U-Boot-Users] [PATCH] MPC8568E-MDS: set up QE pario for UART1
10810 10/25 Johannes Stezenba [U-Boot-Users] [patch 0/3] KB9202 CodeSourcery ARM EABI toolchain bu
11193 11/07 llandre [U-Boot-Users] [PATCH] ARM optimized memcpy/memmove routines
11230 11/09 "Martin Krause" RE: [U-Boot-Users] [PATCH] TQM5200B: update MTD partition layout
11473 11/19 Matthias Fuchs Re: [U-Boot-Users] flash hardware protection with CFI driver does no
11522 11/20 stefano babic [U-Boot-Users] [PATCH] Fix gcc issues in pxa-regs.h
11523 11/20 stefano babic [U-Boot-Users] [PATCH] MMC for PXA 27X (resubmit)
11635 11/23 sivaji [U-Boot-Users] MPC8548 problem in Boot Sequencer mode
11911 12/01 Daniel Mack Re: [U-Boot-Users] [PATCH] add support for Toradex Colibri module
11928 12/03 Yoshihiro Shimoda [PATCH] serial_sh: Add support for SH7720
11929 12/03 Yoshihiro Shimoda [PATCH] sh: Add support SH3 and SH7720
11930 12/03 Yoshihiro Shimoda [PATCH] Add support for MS7720RP02 board
12002 12/06 Ladislav Michl [U-Boot-Users] [PATCH] ARM: Fix at91rm9200dk base address
12003 12/06 Ladislav Michl [U-Boot-Users] [PATCH] ARM: AT91RM9200 based boards config cleanup
12007 12/07 Ladislav Michl [U-Boot-Users] [PATCH] ARM: Board voiceblue update
12044 12/08 Jean-Christophe P Re: [U-Boot-Users] PATCH: add support for MII-connected ethernet swi
12046 12/08 Jean-Christophe P Re: [U-Boot-Users] PATCH: ixp42x UART: support 230400bps, enable RTS
12057 12/09 Jean-Christophe P Re: [U-Boot-Users] PATCH: add support for MII-connected ethernet swi
12096 12/10 Jean-Christophe P [U-Boot-Users] [PATCH] bf537-stamp: remove already defined is_zero_e
12257 12/13 Jean-Christophe P [U-Boot-Users] [PATCH] Nios2: remove common/cmd_bdinfo.c unused vari
12382 12/18 Hebbar Re: [U-Boot-Users] [PATCH] ARM926: compile cpu_init_crit function on
12383 12/18 Hebbar Re: [U-Boot-Users] [PATCH] ARM926: Remove compiler warning: target C
12384 12/18 Hebbar Re: [U-Boot-Users] [PATCH] ARM: I2C Init function call in lib_arm/bo
12385 12/18 Hebbar Re: [U-Boot-Users] [PATCH] ARM926: Display Ethernet info in do_bdinf
12390 12/19 Kumar Gala [U-Boot-Users] [PATCH] Reworked FSL Book-E TLB macros to be more rea
12392 12/19 Joakim Tjernlund Re: [U-Boot-Users] 83xx, FSL_UEC reducing boot latency, printf causi
12393 12/19 Stefan Roese [U-Boot-Users] fdt chosen node handling
12394 12/19 Joakim Tjernlund Re: [U-Boot-Users] 83xx, FSL_UEC reducing boot latency, printf causi
12395 12/19 "Gururaja Hebbar Re: [U-Boot-Users] [PATCH] ARM926: compile cpu_init_crit function on
12396 12/19 Dirk Behme Re: [U-Boot-Users] [PATCH] ARM926: compile cpu_init_crit function on
12404 12/19 Harald Welte [U-Boot-Users] [PATCH] ARM: arm920/s3c24xx: IRQ demulitplexer callba
12405 12/19 Harald Welte [U-Boot-Users] [PATCH] ARM: arm920t: Allow use of 'gd' pointer from
12408 12/19 Harald Welte [U-Boot-Users] [PATCH] ARM: s3c24xx: Multiple serial port support
12412 12/19 Harald Welte [U-Boot-Users] [PATCH] ARM: S3C24x0 SoC NAND controller support
12510 12/22 Jean-Christophe P [U-Boot-Users] [PATCH 1/1] qemu-mips: active HUSH PARSER, AUTO_COMPL
12548 12/25 Anton Vorontsov [U-Boot-Users] [PATCH] mpc83xx: UEC: add support for Broadcom BCM548
12549 12/25 Anton Vorontsov [U-Boot-Users] [PATCH] mpc83xx: add support for the MPC8360E-RDK
12602 12/27 Wolfgang Denk [U-Boot-Users] [PATCH] OMAP5912: fix FIFO handling in UART driver
12818 01/04 Jon Loeliger [U-Boot-Users] [PATCH] Convert MPC8610HPCD to use libfdt.
12820 01/04 Timur Tabi Re: [U-Boot-Users] [PATCH] 8610: Fix lingering compile warnings.
12859 01/07 Timur Tabi [U-Boot-Users] [PATCH v2] 85xx: add ability to upload QE firmware
12866 01/07 Kumar Gala Re: [U-Boot-Users] [PATCH] MPC85xx KGDB support
12870 01/08 Kumar Gala [U-Boot-Users] [PATCH] 85xx: Remove cache config from configs.h
12934 01/08 Ben Warren [U-Boot-Users] [PATCH] Fix Ethernet init() return codes
12938 01/08 Ben Warren [U-Boot-Users] [PATCH V2] Fix Ethernet init() return codes.
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Applying computer technology is simply finding the right wrench to
pound in the correct screw.
next reply other threads:[~2008-01-09 21:36 UTC|newest]
Thread overview: 25+ messages / expand[flat|nested] mbox.gz Atom feed top
2008-01-09 21:36 Wolfgang Denk [this message]
2008-01-09 21:45 ` [U-Boot-Users] CUSTODIANS: List of open issues / not applied patches Timur Tabi
2008-01-09 21:47 ` Jerry Van Baren
2008-01-09 22:47 ` Andy Fleming
2008-01-09 23:17 ` Matthias Fuchs
2008-01-10 8:48 ` Haavard Skinnemoen
2008-01-10 10:50 ` Jean-Christophe PLAGNIOL-VILLARD
2008-01-10 15:34 ` Scott McNutt
2008-01-10 20:43 ` Ben Warren
2008-01-11 4:04 ` Kim Phillips
2008-01-11 10:06 ` Martin Krause
2008-01-11 21:06 ` Michael Schwingen
2008-01-12 6:27 ` Stefan Roese
2008-01-12 13:43 ` [U-Boot-Users] [PATCH] fix CONFIG_FLASH_CFI_LEGACY compilation Michael Schwingen
2008-01-12 18:48 ` Wolfgang Denk
2008-01-12 19:29 ` Michael Schwingen
2008-01-13 14:09 ` Stefan Roese
2008-01-14 8:01 ` [U-Boot-Users] CUSTODIANS: List of open issues / not applied patches Haavard Skinnemoen
2008-01-14 8:07 ` Michael Schwingen
2008-01-15 14:48 ` Shinya Kuribayashi
2008-01-16 10:16 ` Vlad Lungu
2008-01-16 12:16 ` Shinya Kuribayashi
2008-01-16 12:18 ` Vlad Lungu
2008-01-15 15:39 ` Nobuhiro Iwamatsu
[not found] <000301c85377$b20206b0$9a4d010a@Emea.Arm.com>
2008-01-16 18:52 ` Wolfgang Denk
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20080109213614.F0F71242E7@gemini.denx.de \
--to=wd@denx.de \
--cc=u-boot@lists.denx.de \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.