From: Stephen Hemminger <shemminger@linux-foundation.org>
To: David Miller <davem@davemloft.net>, klassert@mathematik.tu-chemnitz.de
Cc: netdev@vger.kernel.org
Subject: [patch 21/45] 3c59x: convert to net_device_ops
Date: Fri, 09 Jan 2009 15:01:18 -0800 [thread overview]
Message-ID: <20090109230138.260145774@linux-foundation.org> (raw)
In-Reply-To: 20090109230057.575650817@linux-foundation.org
[-- Attachment #1: 3c59x.patch --]
[-- Type: text/plain, Size: 2725 bytes --]
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
--- a/drivers/net/3c59x.c 2009-01-08 10:29:45.774507470 -0800
+++ b/drivers/net/3c59x.c 2009-01-08 10:34:17.010259034 -0800
@@ -992,6 +992,42 @@ out:
return rc;
}
+static const struct net_device_ops boomrang_netdev_ops = {
+ .ndo_open = vortex_open,
+ .ndo_stop = vortex_close,
+ .ndo_start_xmit = boomerang_start_xmit,
+ .ndo_tx_timeout = vortex_tx_timeout,
+ .ndo_get_stats = vortex_get_stats,
+#ifdef CONFIG_PCI
+ .ndo_do_ioctl = vortex_ioctl,
+#endif
+ .ndo_set_multicast_list = set_rx_mode,
+ .ndo_change_mtu = eth_change_mtu,
+ .ndo_set_mac_address = eth_mac_addr,
+ .ndo_validate_addr = eth_validate_addr,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = poll_vortex,
+#endif
+};
+
+static const struct net_device_ops vortex_netdev_ops = {
+ .ndo_open = vortex_open,
+ .ndo_stop = vortex_close,
+ .ndo_start_xmit = vortex_start_xmit,
+ .ndo_tx_timeout = vortex_tx_timeout,
+ .ndo_get_stats = vortex_get_stats,
+#ifdef CONFIG_PCI
+ .ndo_do_ioctl = vortex_ioctl,
+#endif
+ .ndo_set_multicast_list = set_rx_mode,
+ .ndo_change_mtu = eth_change_mtu,
+ .ndo_set_mac_address = eth_mac_addr,
+ .ndo_validate_addr = eth_validate_addr,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = poll_vortex,
+#endif
+};
+
/*
* Start up the PCI/EISA device which is described by *gendev.
* Return 0 on success.
@@ -1366,18 +1402,16 @@ static int __devinit vortex_probe1(struc
}
/* The 3c59x-specific entries in the device structure. */
- dev->open = vortex_open;
if (vp->full_bus_master_tx) {
- dev->hard_start_xmit = boomerang_start_xmit;
+ dev->netdev_ops = &boomrang_netdev_ops;
/* Actually, it still should work with iommu. */
if (card_idx < MAX_UNITS &&
((hw_checksums[card_idx] == -1 && (vp->drv_flags & HAS_HWCKSM)) ||
hw_checksums[card_idx] == 1)) {
dev->features |= NETIF_F_IP_CSUM | NETIF_F_SG;
}
- } else {
- dev->hard_start_xmit = vortex_start_xmit;
- }
+ } else
+ dev->netdev_ops = &vortex_netdev_ops;
if (print_info) {
printk(KERN_INFO "%s: scatter/gather %sabled. h/w checksums %sabled\n",
@@ -1386,18 +1420,9 @@ static int __devinit vortex_probe1(struc
(dev->features & NETIF_F_IP_CSUM) ? "en":"dis");
}
- dev->stop = vortex_close;
- dev->get_stats = vortex_get_stats;
-#ifdef CONFIG_PCI
- dev->do_ioctl = vortex_ioctl;
-#endif
dev->ethtool_ops = &vortex_ethtool_ops;
- dev->set_multicast_list = set_rx_mode;
- dev->tx_timeout = vortex_tx_timeout;
dev->watchdog_timeo = (watchdog * HZ) / 1000;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = poll_vortex;
-#endif
+
if (pdev) {
vp->pm_state_valid = 1;
pci_save_state(VORTEX_PCI(vp));
next prev parent reply other threads:[~2009-01-09 23:18 UTC|newest]
Thread overview: 56+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-01-09 23:00 [patch 00/45] Another batch of network device conversions Stephen Hemminger
2009-01-09 23:00 ` [patch 01/45] atm: br2684 internal stats Stephen Hemminger
2009-01-09 23:00 ` [patch 02/45] br2684: convert to net_device_ops Stephen Hemminger
2009-01-09 23:01 ` [patch 03/45] clip: convert to internal network_device_stats Stephen Hemminger
2009-01-09 23:01 ` [patch 04/45] lec: " Stephen Hemminger
2009-01-09 23:01 ` [patch 05/45] lec: convert to net_device_ops Stephen Hemminger
2009-01-09 23:01 ` [patch 06/45] netrom: convert to internal net_device_stats Stephen Hemminger
2009-01-10 12:54 ` Ralf Baechle DL5RB
2009-01-11 8:15 ` David Miller
2009-01-09 23:01 ` [patch 07/45] netrom: convert to net_device_ops Stephen Hemminger
2009-01-10 12:55 ` Ralf Baechle DL5RB
2009-01-09 23:01 ` [patch 08/45] rose: convert to internal net_device_stats Stephen Hemminger
2009-01-10 12:55 ` Ralf Baechle DL5RB
2009-01-09 23:01 ` [patch 09/45] rose: convert to network_device_ops Stephen Hemminger
2009-01-10 12:55 ` Ralf Baechle DL5RB
2009-01-09 23:01 ` [patch 10/45] appletalk: remove unneeded stubs Stephen Hemminger
2009-01-09 23:01 ` [patch 11/45] arcnet: convert to internal stats Stephen Hemminger
2009-01-09 23:01 ` [patch 12/45] arcnet: convert to net_device_ops Stephen Hemminger
2009-01-09 23:01 ` [patch 13/45] com20020: convert to net_devic_ops Stephen Hemminger
2009-01-09 23:01 ` [patch 14/45] 3c501: convert to net_device_ops Stephen Hemminger
2009-01-09 23:01 ` [patch 15/45] 3c505: " Stephen Hemminger
2009-01-09 23:01 ` [patch 16/45] 3c507: " Stephen Hemminger
2009-01-09 23:01 ` [patch 17/45] 3c509: " Stephen Hemminger
2009-01-09 23:01 ` [patch 18/45] 3c515: " Stephen Hemminger
2009-01-09 23:01 ` [patch 19/45] 3c523: " Stephen Hemminger
2009-01-09 23:01 ` [patch 20/45] 3c527: " Stephen Hemminger
2009-01-09 23:01 ` Stephen Hemminger [this message]
2009-01-09 23:01 ` [patch 22/45] ibmtr: convert to internal network_device_stats Stephen Hemminger
2009-01-09 23:01 ` [patch 23/45] ibmtr: convert to net_device_ops Stephen Hemminger
2009-01-09 23:01 ` [patch 24/45] lanstreamer: convert to internal network stats Stephen Hemminger
2009-01-09 23:01 ` [patch 25/45] lanstreamer: convert to net_device_ops Stephen Hemminger
2009-01-09 23:01 ` [patch 26/45] olympic: convert to internal network device stats Stephen Hemminger
2009-01-09 23:01 ` [patch 27/45] olympic: convert to net_device_ops Stephen Hemminger
2009-01-09 23:01 ` [patch 28/45] tms380tr: " Stephen Hemminger
2009-01-09 23:01 ` [patch 29/45] 3c559: " Stephen Hemminger
2009-01-09 23:01 ` [patch 30/45] znet: " Stephen Hemminger
2009-01-09 23:01 ` [patch 31/45] 6pack: " Stephen Hemminger
2009-01-09 23:01 ` [patch 32/45] baycom: convert to internal net_device_stats Stephen Hemminger
2009-01-10 0:03 ` Thomas Sailer
2009-01-09 23:01 ` [patch 33/45] baycom: convert to net_device_ops Stephen Hemminger
2009-01-10 0:03 ` Thomas Sailer
2009-01-09 23:01 ` [patch 34/45] bpqether: convert to internal net_device_stats Stephen Hemminger
2009-01-09 23:01 ` [patch 35/45] bpqether: convert to net_device_ops Stephen Hemminger
2009-01-09 23:01 ` [patch 36/45] dmascc: convert to internal network device stats Stephen Hemminger
2009-01-09 23:01 ` [patch 37/45] dmascc: convert to network_device_ops Stephen Hemminger
2009-01-09 23:01 ` [patch 38/45] hdlcdrv: convert to internal net_device_stats Stephen Hemminger
2009-01-10 0:03 ` Thomas Sailer
2009-01-09 23:01 ` [patch 39/45] hdlcdrv: convert to net_device_ops Stephen Hemminger
2009-01-10 0:03 ` Thomas Sailer
2009-01-09 23:01 ` [patch 40/45] yam: convert to internal net_device_stats Stephen Hemminger
2009-01-09 23:01 ` [patch 41/45] yam: convert to net_device_ops Stephen Hemminger
2009-01-09 23:01 ` [patch 42/45] scc: convert to internal net_device_ops Stephen Hemminger
2009-01-09 23:01 ` [patch 43/45] mkiss: convert to internal network device stats Stephen Hemminger
2009-01-09 23:01 ` [patch 44/45] dmascc: convert to net_device_ops Stephen Hemminger
2009-01-09 23:01 ` [patch 45/45] dmascc: convert to internal net_device_ops Stephen Hemminger
2009-01-10 1:32 ` [patch 00/45] Another batch of network device conversions David Miller
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20090109230138.260145774@linux-foundation.org \
--to=shemminger@linux-foundation.org \
--cc=davem@davemloft.net \
--cc=klassert@mathematik.tu-chemnitz.de \
--cc=netdev@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.