Re: HTB accuracy for high speed

[Vladimir Ivashchenko <hazard@francoudi.com>]

Hi Antonio,

FYI, these are exactly the same problems I get in real life.
Check the later posts in "bond + tc regression" thread.

On Fri, May 15, 2009 at 03:49:31PM +0100, Antonio Almeida wrote:
> Hi!
> I've been using HTB in a Linux bridge and recently I noticed that, for
> high speed, the configured rate/ceil is not respected as for lower
> speeds.
> I'm using a packet generator/analyser to inject over 950Mpbs, and see
> what returns back to it, in the other side of my bridge. Generated
> packets have 800bytes. I noticed that, for several tc HTB rate/ceil
> configurations the amount of traffic received by the analyser stays
> the same. See this values:
> 
> HTB conf      Analyser reception
> 476000Kbit    544.260.329
> 500000Kbit    545.880.017
> 510000Kbit    544.489.469
> 512000Kbit    546.890.972
> -------------------------
> 513000Kbit    596.061.383
> 520000Kbit    596.791.866
> 550000Kbit    596.543.271
> 554000Kbit    596.193.545
> -------------------------
> 555000Kbit    654.773.221
> 570000Kbit    654.996.381
> 590000Kbit    655.363.253
> 605000Kbit    654.112.017
> -------------------------
> 606000Kbit    728.262.237
> 665000Kbit    727.014.365
> -------------------------
> 
> There are these steps and it looks like doesn't matter if I configure
> HTB to 555Mbit or to 605Mbit - the result is the same: 654Mbit. This
> is 18% more traffic than the configured value. I also realise that for
> smaller packets it gets worse, reaching 30% more traffic than what I
> configured. For packets of 1514bytes the accuracy is quiet good.
> I'm using kernel 2.6.25
> 
> My 'tc -s -d class ls dev eth1' output:
> 
> class htb 1:10 parent 1:2 rate 1000Mbit ceil 1000Mbit burst 126375b/8
> mpu 0b overhead 0b cburst 126375b/8 mpu 0b overhead 0b level 5
>  Sent 51888579644 bytes 62067679 pkt (dropped 0, overlimits 0 requeues 0)
>  rate 653124Kbit 97656pps backlog 0b 0p requeues 0
>  lended: 0 borrowed: 0 giants: 0
>  tokens: 113 ctokens: 113
> 
> class htb 1:1 root rate 1000Mbit ceil 1000Mbit burst 126375b/8 mpu 0b
> overhead 0b cburst 126375b/8 mpu 0b overhead 0b level 7
>  Sent 51888579644 bytes 62067679 pkt (dropped 0, overlimits 0 requeues 0)
>  rate 653123Kbit 97656pps backlog 0b 0p requeues 0
>  lended: 0 borrowed: 0 giants: 0
>  tokens: 113 ctokens: 113
> 
> class htb 1:2 parent 1:1 rate 1000Mbit ceil 1000Mbit burst 126375b/8
> mpu 0b overhead 0b cburst 126375b/8 mpu 0b overhead 0b level 6
>  Sent 51888579644 bytes 62067679 pkt (dropped 0, overlimits 0 requeues 0)
>  rate 653124Kbit 97656pps backlog 0b 0p requeues 0
>  lended: 0 borrowed: 0 giants: 0
>  tokens: 113 ctokens: 113
> 
> class htb 1:108 parent 1:10 leaf 108: prio 7 quantum 1514 rate
> 555000Kbit ceil 555000Kbit burst 70901b/8 mpu 0b overhead 0b cburst
> 70901b/8 mpu 0b overhead 0b level 0
>  Sent 51888579644 bytes 62067679 pkt (dropped 27801917, overlimits 0 requeues 0)
>  rate 653124Kbit 97656pps backlog 0b 0p requeues 0
>  lended: 62067679 borrowed: 0 giants: 0
>  tokens: -798 ctokens: -798
> 
> As you can see, class htb 1:108 rate's is 653124Kbit! Much bigger that
> it's ceil.
> 
> I also note that, for HTB rate configurations over 500Mbit/s on leaf
> class, when I stop the traffic, in the output of "tc -s -d class ls
> dev eth1" command, I see that leaf's rate (in bits/s) is growing
> instead of decreasing (as expected since I've stopped the traffic).
> Rate in pps is ok and decreases until 0pps. Rate in bits/s increases
> above 1000Mbit and stays there for a few minutes. After two or three
> minutes it becomes 0bit. The same happens for it's ancestors (also for
> root class).Here's tc output of my leaf class for this situation:
> 
> class htb 1:108 parent 1:10 leaf 108: prio 7 quantum 1514 rate
> 555000Kbit ceil 555000Kbit burst 70901b/8 mpu 0b overhead 0b cburst
> 70901b/8 mpu 0b overhead 0b level 0
>  Sent 120267768144 bytes 242475339 pkt (dropped 62272599, overlimits 0
> requeues 0)
>  rate 1074Mbit 0pps backlog 0b 0p requeues 0
>  lended: 242475339 borrowed: 0 giants: 0
>  tokens: 8 ctokens: 8
> 
> 
>   Antonio Almeida
> --
> To unsubscribe from this list: send the line "unsubscribe netdev" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at  http://vger.kernel.org/majordomo-info.html

-- 
Best Regards
Vladimir Ivashchenko
Chief Technology Officer
PrimeTel, Cyprus - www.prime-tel.com