[U-Boot] [PATCH 1/3] omap: move TI's boards to board/ti/

[Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>]

> Second, where do you know from that all these boards are from TI?
> Are you sure that they are not from SpectrumDigital, Mistral or
> DigiKey etc?
here you mix board vendor and distributor as example you can buy a atmel
ref design at DigiKey or resistor, soc, ddr, etc...


> 
> Third, I don't like the mixing of board and vendor name as directory
> names. It seems to me that where you think you know the vendor, you
> use the vendor name, and where you seem to not know it, you use the
> board name. So, to be consistent, and to overcome vendor name issue
> above, I'd like to use the board name everywhere. That is:
> 
> board/beagle/
> board/omap3evm/
> board/omap1510inn/
> ...
> board/omap5912osk/
> ...
> board/omap2420h4/
> ...
> board/zoom1/
> board/zoom2/
> board/overo/
> board/pandora/
> ...
> 
> To improve this even more, something like this would be nice:
> 
> board/omap3beagle/
> board/omap3evm/
> board/omap1innovator/
> ...
> board/omap1osk/
> ...
> board/omap2h4/
> ...
> board/omap3zoom1/
> board/omap3zoom2/
> board/omap3overo/
> board/omap3pandora/
> ...
it's not the TI board's name and there is no need to specify in each board
name the arch as it's easy to known it via Makefile or config.h
and as repeat multiple time on the ml we prefer shorter name

Best Regards,
J.