Re: [PATCH 6/6] omap2/3/4: Add Kconfig option to compile in typical omap features

[Tony Lindgren <tony@atomide.com>]

* Shilimkar, Santosh <santosh.shilimkar@ti.com> [100630 09:41]:
> > -----Original Message-----
> > From: Tony Lindgren [mailto:tony@atomide.com]
> > Sent: Wednesday, June 30, 2010 11:47 AM
> > To: Shilimkar, Santosh
> > Cc: linux-arm-kernel@lists.infradead.org; linux-omap@vger.kernel.org
> > Subject: Re: [PATCH 6/6] omap2/3/4: Add Kconfig option to compile in
> > typical omap features
> > 
> > * Shilimkar, Santosh <santosh.shilimkar@ti.com> [100629 17:40]:
> > > > >
> > > > With your series OMAP4 build breaks because of PM and SMP
> > dependencies.
> > > > To ensure that build doesn't break on OMAP4, I needed below change.
> > With
> > > > This change I tried your series and it boots OK on OMAP4430 SDP
> > 
> > Hmm the build does not break for me?
> >
> Looks like I am missing something here. How do you build OMAP4 alone with
> these new changes ??

Use your old config file, or just unselect CONFIG_ARCH_OMAP2
and CONFIG_ARCH_OMAP3. Note that if you now do:

$ yes "" | ARCH=arm make oldconfig

with your old omap4 only config file, then by default the
typical features get added by default. So what you probably
want to do is (untested):

$ echo "# CONFIG_ARCH_OMAP2PLUS_TYPICAL is not set" >> .config
$ yes "" | ARCH=arm make oldconfig

Then it should not change your old config file.

To see how the boards and features show up, you can also play
with it with make xconfig:

System Type -> TI OMAP2/3/4 Specific Features

Uncheck TI OMAP2 and TI OMAP3 so only TI OMAP4 is selected.

Regards,

Tony