[U-Boot] [PATCH] fsl_pci_init: Make fsl_pci_init_port() PCI/PCIe aware

[Wolfgang Denk <wd@denx.de>]

Dear Peter Tyser,

In message <1288297499-21417-1-git-send-email-ptyser@xes-inc.com> you wrote:
> Previously fsl_pci_init_port() always assumed that a port was a PCIe
> port and would incorrectly print messages for a PCI port such as the
> following on bootup:
>     PCI1:  32 bit, 33 MHz, sync, host, arbiter
>                 Scanning PCI bus 00
>     PCIE1 on bus 00 - 00
> 
> This change corrects the output of fsl_pci_init_port():
>     PCI1:  32 bit, 33 MHz, sync, host, arbiter
>                 Scanning PCI bus 00
>     PCI1 on bus 00 - 00
> 
> Signed-off-by: Peter Tyser <ptyser@xes-inc.com>
> ---
> Tested on a MPC8548 with PCI, and a MPC8640 with PCIe
> 
>  drivers/pci/fsl_pci_init.c |    6 +++++-
>  1 files changed, 5 insertions(+), 1 deletions(-)

Applied, thanks.

Kumar, I hope this is OK with you.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Very ugly or very beautiful women should be flattered on their
understanding, and mediocre ones on their beauty.
                                       -- Philip Earl of Chesterfield