[patch 3/4] x86: enable the intr-remap fault handling after local apic setup

[Suresh Siddha <suresh.b.siddha@intel.com>]

[-- Attachment #1: vtd_fault_handling_after_local_apic_setup.patch --]
[-- Type: text/plain, Size: 2188 bytes --]

From: Kenji Kaneshige <kaneshige.kenji@jp.fujitsu.com>
Subject: x86: enable the intr-remap fault handling after local apic setup

Interrupt-remapping gets enabled very early in the boot, as it determines the
apic mode that the processor can use. And the current code enables the vt-d
fault handling before the setup_local_APIC(). And hence the APIC LDR registers
and data structure in the memory may not be initialized. So the vt-d fault
handling in logical xapic/x2apic modes were broken.

Fix this by enabling the vt-d fault handling in the end_local_APIC_setup()

A cleaner fix of enabling fault handling while enabling intr-remapping
will be addressed for v2.6.38. [ Enabling intr-remapping determines the
usage of x2apic mode and the apic mode determines the fault-handling
configuration. ]

Signed-off-by: Kenji Kaneshige <kaneshige.kenji@jp.fujitsu.com>
Signed-off-by: Suresh Siddha <suresh.b.siddha@intel.com>
Cc: stable@kernel.org [v2.6.32+]
---
 arch/x86/kernel/apic/apic.c     |    8 ++++++++
 arch/x86/kernel/apic/probe_64.c |    7 -------
 2 files changed, 8 insertions(+), 7 deletions(-)

Index: tip/arch/x86/kernel/apic/apic.c
===================================================================
--- tip.orig/arch/x86/kernel/apic/apic.c
+++ tip/arch/x86/kernel/apic/apic.c
@@ -1384,6 +1384,14 @@ void __cpuinit end_local_APIC_setup(void
 #endif
 
 	apic_pm_activate();
+
+	/*
+	 * Now that local APIC setup is completed for BP, configure the fault
+	 * handling for interrupt remapping.
+	 */
+	if (!smp_processor_id() && intr_remapping_enabled)
+		enable_drhd_fault_handling();
+
 }
 
 #ifdef CONFIG_X86_X2APIC
Index: tip/arch/x86/kernel/apic/probe_64.c
===================================================================
--- tip.orig/arch/x86/kernel/apic/probe_64.c
+++ tip/arch/x86/kernel/apic/probe_64.c
@@ -79,13 +79,6 @@ void __init default_setup_apic_routing(v
 		/* need to update phys_pkg_id */
 		apic->phys_pkg_id = apicid_phys_pkg_id;
 	}
-
-	/*
-	 * Now that apic routing model is selected, configure the
-	 * fault handling for intr remapping.
-	 */
-	if (intr_remapping_enabled)
-		enable_drhd_fault_handling();
 }
 
 /* Same for both flat and physical. */