Re: [RFC PATCH 1/3] tea575x-tuner: various improvements

[Ondrej Zary <linux@rainbow-software.org>]

On Saturday 26 March 2011 11:19:31 Hans Verkuil wrote:
> On Friday, March 25, 2011 22:40:12 Ondrej Zary wrote:
> > On Tuesday 22 March 2011 20:02:30 Hans Verkuil wrote:
> > > BTW, can you run the v4l2-compliance utility for the two boards that
> > > use this radio tuner?
> > >
> > > This utility is part of the v4l-utils repository
> > > (http://git.linuxtv.org/v4l-utils.git).
> > >
> > > Run as 'v4l2-compliance -r /dev/radioX -v2'.
> > >
> > > I'm sure there will be some errors/warnings (warnings regarding
> > > G/S_PRIORITY are to be expected). But I can use it to make a patch for
> > > 2.6.40 that fixes any issues.
> >
> > The output is the same for both fm801 and es1968 (see below). Seems that
> > there are 4 errors:
> >  1. multiple-open does not work
> >  2. something bad with s_frequency
> >  3. input functions are present
> >  4. no extended controls
>
> Thanks for testing! Some comments are below...
>
> > Running on 2.6.38
> >
> > Driver Info:
> > 	Driver name   : tea575x-tuner
> > 	Card type     : TEA5757
> > 	Bus info      : PCI
> > 	Driver version: 0.0.2
> > 	Capabilities  : 0x00050000
> > 		Tuner
> > 		Radio
> >
> > Compliance test for device /dev/radio0 (not using libv4l2):
> >
> > Required ioctls:
> > 	test VIDIOC_QUERYCAP: OK
> >
> > Allow for multiple opens:
> > 	test second radio open: FAIL
>
> I will fix this. Once 2.6.39-rc1 is released I can make a patch fixing
> this.
>
> > Debug ioctls:
> > 	test VIDIOC_DBG_G_CHIP_IDENT: Not Supported
> > 	test VIDIOC_DBG_G/S_REGISTER: Not Supported
> > 	test VIDIOC_LOG_STATUS: Not Supported
> >
> > Input ioctls:
> > 	test VIDIOC_G/S_TUNER: OK
> > 		fail: set rangehigh+1 frequency did not return EINVAL
> > 	test VIDIOC_G/S_FREQUENCY: FAIL
>
> Hmm, S_FREQUENCY apparently fails to check for valid frequency values.
> Can you take a quick look at the code?

The driver code is OK. But there is a bug in v4l2-test-input-output.cpp at 
line 214:
if (ret)
	return fail("set rangehigh+1 frequency did not return EINVAL\n");

There should be "if (ret != EINVAL)" instead of "if (ret)".

-- 
Ondrej Zary