From: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
To: Kevin Hilman <khilman@ti.com>
Cc: linux-omap@vger.kernel.org,
Grant Likely <grant.likely@secretlab.ca>,
Linus Walleij <linus.walleij@stericsson.com>,
linux-arm-kernel@lists.infradead.org
Subject: Re: [PATCH 00/14] GPIO: OMAP: first round of cleanup
Date: Sun, 22 May 2011 08:28:53 +0200 [thread overview]
Message-ID: <20110522062853.GA15292@game.jcrosoft.org> (raw)
In-Reply-To: <1305904497-26013-1-git-send-email-khilman@ti.com>
On 17:14 Fri 20 May , Kevin Hilman wrote:
> Start moving SoC-specific register handling out of the driver by passing
> in register offsets in via platform data.
>
> Also, move OMAP1 MPUIO IRQ handling over to genric IRQ chip.
>
> Applies on top of Tony's for-next branch (which include's the generic
> IRQ chip work from tglx) and the OMAP GPIO driver move to
> drivers/gpio.
>
> Charulatha V (1):
> GPIO: OMAP: remove get_gpio_bank()
>
> Kevin Hilman (13):
> GPIO: OMAP: _clear_gpio_irqbank: fix flushing of posted write
> GPIO: OMAP: remove MPUIO handling from _clear_gpio_irqbank()
> GPIO: OMAP: move bank width into struct gpio_bank
> GPIO: OMAP: _get_gpio_irqbank_mask: replace hard-coded mask with
> bank->width
> GPIO: OMAP: replace get_gpio_index() by using bank width
> GPIO: OMAP: consolidate direction, input, output, remove #ifdefs
> GPIO: OMAP: consolidate IRQ status handling, remove #ifdefs
> GPIO: OMAP: conslidate enable/disable of GPIO IRQs, remove ifdefs
> GPIO: OMAP: convert MPUIO IRQ over to generic irq_chip
> GPIO: OMAP: remove useless gpio_valid() & check_gpio() checks
> GPIO: OMAP: cleanup _set_gpio_wakeup(), remove ifdefs
> GPIO: OMAP: debounce remove SoC specific registers, use pdata
> GPIO: OMAP: cleanup show revision, remove cpu_is checks, display only
> once
looks good
Best Regards,
J.
WARNING: multiple messages have this Message-ID (diff)
From: plagnioj@jcrosoft.com (Jean-Christophe PLAGNIOL-VILLARD)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH 00/14] GPIO: OMAP: first round of cleanup
Date: Sun, 22 May 2011 08:28:53 +0200 [thread overview]
Message-ID: <20110522062853.GA15292@game.jcrosoft.org> (raw)
In-Reply-To: <1305904497-26013-1-git-send-email-khilman@ti.com>
On 17:14 Fri 20 May , Kevin Hilman wrote:
> Start moving SoC-specific register handling out of the driver by passing
> in register offsets in via platform data.
>
> Also, move OMAP1 MPUIO IRQ handling over to genric IRQ chip.
>
> Applies on top of Tony's for-next branch (which include's the generic
> IRQ chip work from tglx) and the OMAP GPIO driver move to
> drivers/gpio.
>
> Charulatha V (1):
> GPIO: OMAP: remove get_gpio_bank()
>
> Kevin Hilman (13):
> GPIO: OMAP: _clear_gpio_irqbank: fix flushing of posted write
> GPIO: OMAP: remove MPUIO handling from _clear_gpio_irqbank()
> GPIO: OMAP: move bank width into struct gpio_bank
> GPIO: OMAP: _get_gpio_irqbank_mask: replace hard-coded mask with
> bank->width
> GPIO: OMAP: replace get_gpio_index() by using bank width
> GPIO: OMAP: consolidate direction, input, output, remove #ifdefs
> GPIO: OMAP: consolidate IRQ status handling, remove #ifdefs
> GPIO: OMAP: conslidate enable/disable of GPIO IRQs, remove ifdefs
> GPIO: OMAP: convert MPUIO IRQ over to generic irq_chip
> GPIO: OMAP: remove useless gpio_valid() & check_gpio() checks
> GPIO: OMAP: cleanup _set_gpio_wakeup(), remove ifdefs
> GPIO: OMAP: debounce remove SoC specific registers, use pdata
> GPIO: OMAP: cleanup show revision, remove cpu_is checks, display only
> once
looks good
Best Regards,
J.
next prev parent reply other threads:[~2011-05-22 6:40 UTC|newest]
Thread overview: 44+ messages / expand[flat|nested] mbox.gz Atom feed top
2011-05-20 15:14 [PATCH 00/14] GPIO: OMAP: first round of cleanup Kevin Hilman
2011-05-20 15:14 ` Kevin Hilman
2011-05-20 15:14 ` [PATCH 01/14] GPIO: OMAP: _clear_gpio_irqbank: fix flushing of posted write Kevin Hilman
2011-05-20 15:14 ` Kevin Hilman
2011-05-20 15:14 ` [PATCH 02/14] GPIO: OMAP: remove MPUIO handling from _clear_gpio_irqbank() Kevin Hilman
2011-05-20 15:14 ` Kevin Hilman
2011-05-20 15:14 ` [PATCH 03/14] GPIO: OMAP: move bank width into struct gpio_bank Kevin Hilman
2011-05-20 15:14 ` Kevin Hilman
2011-05-20 15:14 ` [PATCH 04/14] GPIO: OMAP: _get_gpio_irqbank_mask: replace hard-coded mask with bank->width Kevin Hilman
2011-05-20 15:14 ` Kevin Hilman
2011-05-20 15:14 ` [PATCH 05/14] GPIO: OMAP: replace get_gpio_index() by using bank width Kevin Hilman
2011-05-20 15:14 ` Kevin Hilman
2011-05-20 15:14 ` [PATCH 06/14] GPIO: OMAP: remove get_gpio_bank() Kevin Hilman
2011-05-20 15:14 ` Kevin Hilman
2011-05-20 15:14 ` [PATCH 07/14] GPIO: OMAP: consolidate direction, input, output, remove #ifdefs Kevin Hilman
2011-05-20 15:14 ` Kevin Hilman
2011-05-20 15:14 ` [PATCH 08/14] GPIO: OMAP: consolidate IRQ status handling, " Kevin Hilman
2011-05-20 15:14 ` Kevin Hilman
2011-05-20 15:14 ` [PATCH 09/14] GPIO: OMAP: conslidate enable/disable of GPIO IRQs, remove ifdefs Kevin Hilman
2011-05-20 15:14 ` Kevin Hilman
2011-05-20 15:14 ` [PATCH 10/14] GPIO: OMAP: convert MPUIO IRQ over to generic irq_chip Kevin Hilman
2011-05-20 15:14 ` Kevin Hilman
2011-05-20 15:14 ` [PATCH 11/14] GPIO: OMAP: remove useless gpio_valid() & check_gpio() checks Kevin Hilman
2011-05-20 15:14 ` Kevin Hilman
2011-05-20 15:14 ` [PATCH 12/14] GPIO: OMAP: cleanup _set_gpio_wakeup(), remove ifdefs Kevin Hilman
2011-05-20 15:14 ` Kevin Hilman
2011-05-20 15:14 ` [PATCH 13/14] GPIO: OMAP: debounce remove SoC specific registers, use pdata Kevin Hilman
2011-05-20 15:14 ` Kevin Hilman
2011-05-20 15:14 ` [PATCH 14/14] GPIO: OMAP: cleanup show revision, remove cpu_is checks, display only once Kevin Hilman
2011-05-20 15:14 ` Kevin Hilman
2011-05-22 6:28 ` Jean-Christophe PLAGNIOL-VILLARD [this message]
2011-05-22 6:28 ` [PATCH 00/14] GPIO: OMAP: first round of cleanup Jean-Christophe PLAGNIOL-VILLARD
2011-05-27 3:24 ` Grant Likely
2011-05-27 3:24 ` Grant Likely
2011-05-27 15:49 ` Kevin Hilman
2011-05-27 15:49 ` Kevin Hilman
2011-06-16 16:07 ` Kevin Hilman
2011-06-16 16:07 ` Kevin Hilman
2011-06-16 16:26 ` Grant Likely
2011-06-16 16:26 ` Grant Likely
2011-06-16 18:16 ` Kevin Hilman
2011-06-16 18:16 ` Kevin Hilman
2011-06-16 19:32 ` Grant Likely
2011-06-16 19:32 ` Grant Likely
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20110522062853.GA15292@game.jcrosoft.org \
--to=plagnioj@jcrosoft.com \
--cc=grant.likely@secretlab.ca \
--cc=khilman@ti.com \
--cc=linus.walleij@stericsson.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-omap@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.