Re: Errors at boot time from OMAP4430SDP (and a whinge about serial stuff)

[Russell King - ARM Linux <linux@arm.linux.org.uk>]

On Fri, Oct 12, 2012 at 04:54:34PM +0100, Russell King - ARM Linux wrote:
> For those who don't bother looking at my kautobuild boot tests on the OMAP
> boards I have, here's the errors which get spat out at boot time.  Note
> that some of these I've reported in the past, and one of them is missing
> a newline character at the end of its string.
> 
> twd: can't register interrupt 45 (-22)
> twd_local_timer_register failed -22
> omap_hwmod: mcpdm: cannot be enabled for reset (3)
> omap-gpmc omap-gpmc: error: clk_get
> omap-gpmc: probe of omap-gpmc failed with error -2
> Error setting wl12xx data: -38
> omap_hsmmc omap_hsmmc.1: Failed to get debounce clk
> omap_hsmmc omap_hsmmc.0: Failed to get debounce clk
> omap_hsmmc omap_hsmmc.4: Failed to get debounce clk
> twl6040-codec twl6040-codec: ASoC: Failed to create Capture debugfs file
> omap_vc_i2c_init: I2C config for vdd_iva does not match other channels (0).
> omap_vc_i2c_init: I2C config for vdd_mpu does not match other channels (0).Power Management for TI OMAP4.
> mmc1: host does not support reading read-only switch. assuming write-enable.

Here's the latest set of error like messages, thanks to the kautobuild
system:

omap_hwmod: mcpdm: cannot be enabled for reset (3)
Error setting wl12xx data: -38
omap_hsmmc omap_hsmmc.1: Failed to get debounce clk
omap_hsmmc omap_hsmmc.0: Failed to get debounce clk
omap_hsmmc omap_hsmmc.4: Failed to get debounce clk
omap_vc_i2c_init: I2C config for vdd_iva does not match other channels (0).
omap_vc_i2c_init: I2C config for vdd_mpu does not match other channels (0).Power Management for TI OMAP4.
mmc1: host does not support reading read-only switch. assuming write-enable.

This looks much better compared to the previous set, but we could still
do with getting a "\n" on at least one of those messages...