[U-Boot] [PATCH] drivers/block/systemace: replaced in16/out16 with more common readw/writew macros

[Wolfgang Denk <wd@denx.de>]

Dear Alexey Brodkin,

In message <1357139186-9172-1-git-send-email-alexey.brodkin@gmail.com> you wrote:
> Most architectures don't have symbols "in16"/"out16" defined.
> Only Microblaze/PowerPC/Spark architectures do have them defined.
> 
> At the same time there're much more common macros "readw"/"writew" for
> 16-bit data access defined in most of architectures (in
> linux kernel header "io.h").
> 
> So use of "readw"/"writew" makes it possible to build this driver for
> virtually any architecture.
> 
> Signed-off-by: Alexey Brodkin <alexey.brodkin@gmail.com>

Did you actually test this on - say - any PowerPC board?

To my understanding, in16() / out16() perform big endian accesses 
(i. e. direct load / store operations) on PowerPC, while readw /
writew do byte-swapping (for accessling little-endian things like PCI
busses).

I speculate that this patch will break all big-endian systems.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"There are three principal ways to lose money: wine, women, and engi-
neers. While the first two are more pleasant, the third is by far the
more certain."                           - Baron Rothschild, ca. 1800