Fix phy_init for Marvell network eth driver

[andrew@lunn.ch (Andrew Lunn)]

On Thu, Jan 10, 2013 at 02:00:32PM +0200, Kosta Zertsekel wrote:
> Hi all,
> resubmitting the patch for Marvell mv643xx driver (patch 1/2) adding the below explanation (thanks to Florian F.):
> The D-Link DNS323_REV_C1 board has a specific PHY device fixup using the flag MARVELL_PHY_M1118_DNS323_LEDS which is set by the architecture code in arch/arm/mach-orion5x/dns323-setup.c. This flag is unfortunately lost during the call to phy_attach() in mv643xx_eth and therefore, the underlying Marvell PHY driver cannot make use of this flag to fixup the PHY device LEDs. This patch ensures the phy->dev_flags value is passed to the phy_attach() function such that the PHY device driver can
> actually use it.
> 
> Also submitting new patch 2/2 using the same (or at least very close in meaning) explanation.
> 

Hi Kosta

This comment is supposed to be in the header of the patch. 

Since this comment is about a bug for the D-Link DNS323_REV_C1, the
fix to DSA should be in a separate patch, again with a comment about
the patch, why its needed, what if fixes etc.

I suggest you take a look at Documentation/SubmittingPatches

Thanks
	Andrew