Re: [RFC PATCH v2 03/12] drivers/base: Add system device hotplug framework

[Greg KH <gregkh@linuxfoundation.org>]

On Thu, Jan 10, 2013 at 04:40:21PM -0700, Toshi Kani wrote:
> Added sys_hotplug.c, which is the system device hotplug framework code.
> 
> shp_register_handler() allows modules to register their hotplug handlers
> to the framework.  shp_submit_req() provides the interface to submit
> a hotplug or online/offline request of system devices.  The request is
> then put into hp_workqueue.  shp_start_req() calls all registered handlers
> in ascending order for each phase.  If any handler failed in validate or
> execute phase, shp_start_req() initiates its rollback procedure.
> 
> Signed-off-by: Toshi Kani <toshi.kani@hp.com>
> ---
>  drivers/base/Makefile      |    1 
>  drivers/base/sys_hotplug.c |  313 ++++++++++++++++++++++++++++++++++++++++++++
>  2 files changed, 314 insertions(+)
>  create mode 100644 drivers/base/sys_hotplug.c
> 
> diff --git a/drivers/base/Makefile b/drivers/base/Makefile
> index 5aa2d70..2e9b2f1 100644
> --- a/drivers/base/Makefile
> +++ b/drivers/base/Makefile
> @@ -21,6 +21,7 @@ endif
>  obj-$(CONFIG_SYS_HYPERVISOR) += hypervisor.o
>  obj-$(CONFIG_REGMAP)	+= regmap/
>  obj-$(CONFIG_SOC_BUS) += soc.o
> +obj-y			+= sys_hotplug.o

No option to select this for systems that don't need it?  If not, then
put it up higher with all of the other code for the core.

thanks,

greg k-h

--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to majordomo@kvack.org.  For more info on Linux MM,
see: http://www.linux-mm.org/ .
Don't email: <a href=mailto:"dont@kvack.org"> email@kvack.org </a>