All of lore.kernel.org
 help / color / mirror / Atom feed
* [U-Boot] [PATCH 1/2] wandboard: Enable HDMI splashscreen
@ 2013-05-23 17:50 Fabio Estevam
  2013-05-23 17:50 ` [U-Boot] [PATCH 2/2] wandboard: Disable data cache Fabio Estevam
  2013-06-03 12:27 ` [U-Boot] [PATCH 1/2] wandboard: Enable HDMI splashscreen Stefano Babic
  0 siblings, 2 replies; 7+ messages in thread
From: Fabio Estevam @ 2013-05-23 17:50 UTC (permalink / raw)
  To: u-boot

Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
---
 board/wandboard/wandboard.c | 98 +++++++++++++++++++++++++++++++++++++++++++++
 include/configs/wandboard.h | 15 ++++++-
 2 files changed, 112 insertions(+), 1 deletion(-)

diff --git a/board/wandboard/wandboard.c b/board/wandboard/wandboard.c
index bb98352..5666cbf 100644
--- a/board/wandboard/wandboard.c
+++ b/board/wandboard/wandboard.c
@@ -10,9 +10,11 @@
  */
 
 #include <asm/arch/clock.h>
+#include <asm/arch/crm_regs.h>
 #include <asm/arch/iomux.h>
 #include <asm/arch/imx-regs.h>
 #include <asm/arch/mx6-pins.h>
+#include <asm/arch/mxc_hdmi.h>
 #include <asm/arch/sys_proto.h>
 #include <asm/gpio.h>
 #include <asm/imx-common/iomux-v3.h>
@@ -21,9 +23,11 @@
 #include <asm/sizes.h>
 #include <common.h>
 #include <fsl_esdhc.h>
+#include <ipu_pixfmt.h>
 #include <mmc.h>
 #include <miiphy.h>
 #include <netdev.h>
+#include <linux/fb.h>
 
 DECLARE_GLOBAL_DATA_PTR;
 
@@ -206,6 +210,88 @@ int board_phy_config(struct phy_device *phydev)
 	return 0;
 }
 
+#if defined(CONFIG_VIDEO_IPUV3)
+static void enable_hdmi(void)
+{
+	struct hdmi_regs *hdmi	= (struct hdmi_regs *)HDMI_ARB_BASE_ADDR;
+	u8 reg;
+	reg = readb(&hdmi->phy_conf0);
+	reg |= HDMI_PHY_CONF0_PDZ_MASK;
+	writeb(reg, &hdmi->phy_conf0);
+
+	udelay(3000);
+	reg |= HDMI_PHY_CONF0_ENTMDS_MASK;
+	writeb(reg, &hdmi->phy_conf0);
+	udelay(3000);
+	reg |= HDMI_PHY_CONF0_GEN2_TXPWRON_MASK;
+	writeb(reg, &hdmi->phy_conf0);
+	writeb(HDMI_MC_PHYRSTZ_ASSERT, &hdmi->mc_phyrstz);
+}
+
+static struct fb_videomode const hdmi = {
+	.name           = "HDMI",
+	.refresh        = 60,
+	.xres           = 1024,
+	.yres           = 768,
+	.pixclock       = 15385,
+	.left_margin    = 220,
+	.right_margin   = 40,
+	.upper_margin   = 21,
+	.lower_margin   = 7,
+	.hsync_len      = 60,
+	.vsync_len      = 10,
+	.sync           = FB_SYNC_EXT,
+	.vmode          = FB_VMODE_NONINTERLACED
+};
+
+int board_video_skip(void)
+{
+	int ret;
+
+	ret = ipuv3_fb_init(&hdmi, 0, IPU_PIX_FMT_RGB24);
+
+	if (ret)
+		printf("HDMI cannot be configured: %d\n", ret);
+
+	enable_hdmi();
+
+	return ret;
+}
+
+static void setup_display(void)
+{
+	struct mxc_ccm_reg *mxc_ccm = (struct mxc_ccm_reg *)CCM_BASE_ADDR;
+	struct hdmi_regs *hdmi	= (struct hdmi_regs *)HDMI_ARB_BASE_ADDR;
+	int reg;
+
+	/* Turn on IPU clock */
+	reg = readl(&mxc_ccm->CCGR3);
+	reg |= MXC_CCM_CCGR3_IPU1_IPU_DI0_OFFSET;
+	writel(reg, &mxc_ccm->CCGR3);
+
+	/* Turn on HDMI PHY clock */
+	reg = readl(&mxc_ccm->CCGR2);
+	reg |=  MXC_CCM_CCGR2_HDMI_TX_IAHBCLK_MASK
+		| MXC_CCM_CCGR2_HDMI_TX_ISFRCLK_MASK;
+	writel(reg, &mxc_ccm->CCGR2);
+
+	/* clear HDMI PHY reset */
+	writeb(HDMI_MC_PHYRSTZ_DEASSERT, &hdmi->mc_phyrstz);
+
+	reg = readl(&mxc_ccm->chsccdr);
+	reg &= ~(MXC_CCM_CHSCCDR_IPU1_DI0_PRE_CLK_SEL_MASK
+		| MXC_CCM_CHSCCDR_IPU1_DI0_PODF_MASK
+		| MXC_CCM_CHSCCDR_IPU1_DI0_CLK_SEL_MASK);
+	reg |= (CHSCCDR_CLK_SEL_LDB_DI0
+		<< MXC_CCM_CHSCCDR_IPU1_DI0_CLK_SEL_OFFSET)
+	      | (CHSCCDR_PODF_DIVIDE_BY_3
+		<< MXC_CCM_CHSCCDR_IPU1_DI0_PODF_OFFSET)
+	      | (CHSCCDR_IPU_PRE_CLK_540M_PFD
+		<< MXC_CCM_CHSCCDR_IPU1_DI0_PRE_CLK_SEL_OFFSET);
+	writel(reg, &mxc_ccm->chsccdr);
+}
+#endif /* CONFIG_VIDEO_IPUV3 */
+
 int board_eth_init(bd_t *bis)
 {
 	int ret;
@@ -222,9 +308,21 @@ int board_eth_init(bd_t *bis)
 int board_early_init_f(void)
 {
 	setup_iomux_uart();
+#if defined(CONFIG_VIDEO_IPUV3)
+	setup_display();
+#endif
 	return 0;
 }
 
+/*
+ * Do not overwrite the console
+ * Use always serial for U-Boot console
+ */
+int overwrite_console(void)
+{
+	return 1;
+}
+
 #ifdef CONFIG_CMD_BMODE
 static const struct boot_mode board_boot_modes[] = {
 	/* 4 bit bus width */
diff --git a/include/configs/wandboard.h b/include/configs/wandboard.h
index 9d7ec3f..d4ac086 100644
--- a/include/configs/wandboard.h
+++ b/include/configs/wandboard.h
@@ -29,7 +29,7 @@
 #define CONFIG_REVISION_TAG
 
 /* Size of malloc() pool */
-#define CONFIG_SYS_MALLOC_LEN		(3 * SZ_1M)
+#define CONFIG_SYS_MALLOC_LEN		(10 * SZ_1M)
 
 #define CONFIG_BOARD_EARLY_INIT_F
 #define CONFIG_BOARD_LATE_INIT
@@ -86,6 +86,19 @@
 #define CONFIG_PHYLIB
 #define CONFIG_PHY_ATHEROS
 
+/* Framebuffer */
+#define CONFIG_VIDEO
+#define CONFIG_VIDEO_IPUV3
+#define CONFIG_CFB_CONSOLE
+#define CONFIG_VGA_AS_SINGLE_DEVICE
+#define CONFIG_SYS_CONSOLE_IS_IN_ENV
+#define CONFIG_SYS_CONSOLE_OVERWRITE_ROUTINE
+#define CONFIG_VIDEO_BMP_RLE8
+#define CONFIG_SPLASH_SCREEN
+#define CONFIG_BMP_16BPP
+#define CONFIG_VIDEO_LOGO
+#define CONFIG_IPUV3_CLK 260000000
+
 #if defined(CONFIG_MX6DL)
 #define CONFIG_DEFAULT_FDT_FILE		"imx6dl-wandboard.dtb"
 #elif defined(CONFIG_MX6S)
-- 
1.8.1.2

^ permalink raw reply related	[flat|nested] 7+ messages in thread
end of thread, other threads:[~2013-06-03 12:27 UTC | newest]

Thread overview: 7+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2013-05-23 17:50 [U-Boot] [PATCH 1/2] wandboard: Enable HDMI splashscreen Fabio Estevam
2013-05-23 17:50 ` [U-Boot] [PATCH 2/2] wandboard: Disable data cache Fabio Estevam
2013-05-23 19:31   ` Anatolij Gustschin
2013-05-23 19:37     ` Fabio Estevam
2013-05-23 21:12   ` Wolfgang Denk
2013-05-23 21:15     ` Fabio Estevam
2013-06-03 12:27 ` [U-Boot] [PATCH 1/2] wandboard: Enable HDMI splashscreen Stefano Babic

This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.