From: Tony Lindgren <tony@atomide.com>
To: linux-arm-kernel@lists.infradead.org
Cc: linux-omap@vger.kernel.org
Subject: Re: [PATCH 0/6] add support for omap wake-up interrupts via pinctrl-single
Date: Wed, 2 Oct 2013 22:40:00 -0700 [thread overview]
Message-ID: <20131003054000.GK8949@atomide.com> (raw)
In-Reply-To: <20131003051049.8444.16913.stgit@localhost>
* Tony Lindgren <tony@atomide.com> [131002 22:25]:
> Hi all,
>
> Here's a respin of the pinctrl-single related patches to
> use chained irq as suggested by Linus W earlier. This series
> does not try to provide any generic automated solution yet,
> but works by doing a request_irq() for the wake-up pin, so
> it should be flexible enough for both manual control and
> automated solution.
>
> This series removes the last nasty blocker for making omap3
> to be device tree only without causing nasty PM regressions.
>
> Assuming Linus W acks the drivers/pinctrl parts, I can
> provide those three patches in a separate immutable branch
> against v3.12-rc3 for Linus W to pull so I can merge them in
> too.
>
> This series is based on my earlier series "[PATCH 0/4] Clean
> up legacy platform data handling for omaps for v3.13" as
> it has a dependency for the pdata quirks for passing the
> auxdata to the driver.
Sorry I had some typos in my Cc addresses and this series
did not get fully sent. Will resend it, sorry for the noise.
> Regards,
>
> Tony
>
> ---
>
> Tony Lindgren (6):
> ARM: dts: Fix pinctrl mask for omap3
> ARM: OMAP2+: Add support for auxdata
> pinctrl: single: Prepare for supporting SoC specific features
> pinctrl: single: Add support for wake-up interrupts
> pinctrl: single: Add support for auxdata
> ARM: OMAP: Move DT wake-up event handling over to use pinctrl-single-omap
>
>
> .../devicetree/bindings/pinctrl/pinctrl-single.txt | 11 +
> arch/arm/boot/dts/omap3.dtsi | 8
> arch/arm/boot/dts/omap4.dtsi | 4
> arch/arm/mach-omap2/board-generic.c | 5
> arch/arm/mach-omap2/common.h | 3
> arch/arm/mach-omap2/mux.c | 8
> arch/arm/mach-omap2/mux.h | 4
> arch/arm/mach-omap2/pdata-quirks.c | 29 +-
> arch/arm/mach-omap2/prm3xxx.h | 8
> arch/arm/mach-omap2/prm44xx_54xx.h | 8
> arch/arm/mach-omap2/prm_common.c | 11 +
> drivers/pinctrl/pinctrl-single.c | 386 ++++++++++++++++++++
> include/dt-bindings/pinctrl/omap.h | 4
> include/linux/platform_data/pinctrl-single.h | 12 +
> 14 files changed, 474 insertions(+), 27 deletions(-)
> create mode 100644 include/linux/platform_data/pinctrl-single.h
>
> --
> Signature
> --
> To unsubscribe from this list: send the line "unsubscribe linux-omap" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
WARNING: multiple messages have this Message-ID (diff)
From: tony@atomide.com (Tony Lindgren)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH 0/6] add support for omap wake-up interrupts via pinctrl-single
Date: Wed, 2 Oct 2013 22:40:00 -0700 [thread overview]
Message-ID: <20131003054000.GK8949@atomide.com> (raw)
In-Reply-To: <20131003051049.8444.16913.stgit@localhost>
* Tony Lindgren <tony@atomide.com> [131002 22:25]:
> Hi all,
>
> Here's a respin of the pinctrl-single related patches to
> use chained irq as suggested by Linus W earlier. This series
> does not try to provide any generic automated solution yet,
> but works by doing a request_irq() for the wake-up pin, so
> it should be flexible enough for both manual control and
> automated solution.
>
> This series removes the last nasty blocker for making omap3
> to be device tree only without causing nasty PM regressions.
>
> Assuming Linus W acks the drivers/pinctrl parts, I can
> provide those three patches in a separate immutable branch
> against v3.12-rc3 for Linus W to pull so I can merge them in
> too.
>
> This series is based on my earlier series "[PATCH 0/4] Clean
> up legacy platform data handling for omaps for v3.13" as
> it has a dependency for the pdata quirks for passing the
> auxdata to the driver.
Sorry I had some typos in my Cc addresses and this series
did not get fully sent. Will resend it, sorry for the noise.
> Regards,
>
> Tony
>
> ---
>
> Tony Lindgren (6):
> ARM: dts: Fix pinctrl mask for omap3
> ARM: OMAP2+: Add support for auxdata
> pinctrl: single: Prepare for supporting SoC specific features
> pinctrl: single: Add support for wake-up interrupts
> pinctrl: single: Add support for auxdata
> ARM: OMAP: Move DT wake-up event handling over to use pinctrl-single-omap
>
>
> .../devicetree/bindings/pinctrl/pinctrl-single.txt | 11 +
> arch/arm/boot/dts/omap3.dtsi | 8
> arch/arm/boot/dts/omap4.dtsi | 4
> arch/arm/mach-omap2/board-generic.c | 5
> arch/arm/mach-omap2/common.h | 3
> arch/arm/mach-omap2/mux.c | 8
> arch/arm/mach-omap2/mux.h | 4
> arch/arm/mach-omap2/pdata-quirks.c | 29 +-
> arch/arm/mach-omap2/prm3xxx.h | 8
> arch/arm/mach-omap2/prm44xx_54xx.h | 8
> arch/arm/mach-omap2/prm_common.c | 11 +
> drivers/pinctrl/pinctrl-single.c | 386 ++++++++++++++++++++
> include/dt-bindings/pinctrl/omap.h | 4
> include/linux/platform_data/pinctrl-single.h | 12 +
> 14 files changed, 474 insertions(+), 27 deletions(-)
> create mode 100644 include/linux/platform_data/pinctrl-single.h
>
> --
> Signature
> --
> To unsubscribe from this list: send the line "unsubscribe linux-omap" in
> the body of a message to majordomo at vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
next prev parent reply other threads:[~2013-10-03 5:40 UTC|newest]
Thread overview: 8+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-10-03 5:16 [PATCH 0/6] add support for omap wake-up interrupts via pinctrl-single Tony Lindgren
2013-10-03 5:16 ` Tony Lindgren
2013-10-03 5:16 ` [PATCH 1/6] ARM: dts: Fix pinctrl mask for omap3 Tony Lindgren
2013-10-03 5:16 ` Tony Lindgren
2013-10-03 5:17 ` [PATCH 2/6] ARM: OMAP2+: Add support for auxdata Tony Lindgren
2013-10-03 5:17 ` Tony Lindgren
2013-10-03 5:40 ` Tony Lindgren [this message]
2013-10-03 5:40 ` [PATCH 0/6] add support for omap wake-up interrupts via pinctrl-single Tony Lindgren
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20131003054000.GK8949@atomide.com \
--to=tony@atomide.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-omap@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.