Re: Pericom PCIe Serial board Support (12d8:7952/4/8) - Chip PI7C9X7952/4/8

[Greg KH <greg@kroah.com>]

On Tue, Oct 15, 2013 at 10:41:10PM +0300, Angelo Butti wrote:
> On 10/15/2013 08:28 PM, Greg KH wrote:
> > On Tue, Oct 15, 2013 at 07:20:18PM +0200, Angelo Butti wrote:
> >> I'm really sorry for my mistake.
> >
> > No worries, but your email client turned all tabs into spaces, and made
> > the patch imposible to apply :(
> >
> >> Also, maybe that there is a simple way to change the clock without
> >> rewrite the standard serial setup procedure, but I cannot find it ....
> >> Below the correct one:
> >>
> >> --- linux-3.10.11-200.fc19.i686/drivers/tty/serial/8250/8250_pci.c.orig
> >> 2013-09-16 20:13:52.918548000 +0300
> >> +++ linux-3.10.11-200.fc19.i686/drivers/tty/serial/8250/8250_pci.c
> >> 2013-10-15 16:20:18.566685996 +0300
> >> @@ -1308,6 +1308,29 @@ static int pci_default_setup(struct seri
> >>    return setup_port(priv, port, bar, offset, board->reg_shift);
> >>   }
> >>
> >> +static int pci_pericom_setup(struct serial_private *priv,
> >> +  const struct pciserial_board *board,
> >> +  struct uart_8250_port *port, int idx)
> >
> > See?
> >
> > Also, we need a "Signed-off-by:" line as per the instructions in the
> > Documentation/SubmittingPatches file (take a look at it for what that
> > means.)
> >
> > Care to try again?
> >
> > thanks,
> >
> > greg k-h
> >
> 
> Ok, I change the email client .... I hope ....

The patch was a bit whitespace dammaged, but I fixed it up by hand and
applied it.

thanks,

greg k-h