Re: [PATCH 00/11]: add remaining support for IGEP boards

[Tony Lindgren <tony@atomide.com>]

* Javier Martinez Canillas <javier.martinez@collabora.co.uk> [131116 05:25]:
> In order to make mach-omap2 Device Tree only the board file for
> IGEP boards was removed even when support for wifi and display
> was still not supported by its DTS.
> 
> This patch-set adds support for these remaining peripherals and
> also adds support for USB, HDMI and user LED for the am33xx SoC
> based IGEP Aquila board.
> 
> The patch-set is composed of the following patches:
> 
> Enric Balletbo i Serra (7):
>       ARM: dts: omap3-igep: Fix bus-width for mmc1.
>       ARM: dts: omap3-igep: Add support for LBEE1USJYC WiFi connected to SDIO.
>       ARM: dts: omap3-igep: Update to use the TI AM/DM37x processor.
>       ARM: dts: AM33XX BASE0033: add pinmux and hdmi node to enable display
>       ARM: dts: AM33XX BASE0033: add pinmux and user led support.
>       ARM: dts: AM33XX BASE0033: add 32KBit EEPROM support.
>       ARM: dts: AM33XX IGEP0033: add USB support.
> 
> Javier Martinez Canillas (4):
>       ARM: dts: omap3-igep0020: Add pinmux setup for i2c devices
>       ARM: dts: omap3-igep0020: Add pinmuxing for DVI output
>       ARM: OMAP: dss-common: change IGEP's DVI DDC i2c bus
>       OMAPDSS: DPI: use VPLL2 regulator if VDDS_DSI is not found
> 
> Tony,
> 
> Most of these patches are just DTS changes so they have to be picked
> by Benoit although there are patches that should go to different trees.
> 
> [PATCH 10/11] ARM: OMAP: dss-common: change IGEP's DVI DDC i2c bus
> 
> have to go through your tree and

OK
 
> [PATCH 11/11] OMAPDSS: DPI: use VPLL2 regulator if VDDS_DSI is not found
> 
> should be picked by Tomi Valkeinen.

That may not be needed as it can be set in the .dts file, I'll comment
on that patch.
 
> Since we have removed the board file for IGEP boards I think these
> can be considered as regression fixes for 3.13 although I don't mind
> if you prefer to wait for 3.14.

Yes I agree, let's try to fix these issues during the -rc cycle
so the earlier functionality is maintained.

Regards,

Tony