From: Tony Lindgren <tony@atomide.com>
To: Roger Quadros <rogerq@ti.com>
Cc: Nishanth Menon <nm@ti.com>,
balbi@ti.com, bcousson@baylibre.com, p.zabel@pengutronix.de,
broonie@kernel.org, linux-omap@vger.kernel.org,
linux-arm-kernel@lists.infradead.org, linux-usb@vger.kernel.org,
linux-kernel@vger.kernel.org, devicetree@vger.kernel.org
Subject: Re: [PATCH v3 09/10] ARM: dts: omap3-beagle-xm: Add USB Host support
Date: Tue, 26 Nov 2013 13:04:56 -0800 [thread overview]
Message-ID: <20131126210456.GN26766@atomide.com> (raw)
In-Reply-To: <528C8FBC.7020407@ti.com>
* Roger Quadros <rogerq@ti.com> [131120 02:33]:
> Nishant,
>
> On 11/19/2013 11:05 PM, Nishanth Menon wrote:
> >
> >
> > On 09/24/2013 03:53 AM, Roger Quadros wrote:
> >> Provide RESET GPIO and Power regulator for the USB PHY,
> >> the USB Host port mode and the PHY device for the controller.
> >> Also provide pin multiplexer information for USB host pins.
> >>
> >> We also relocate omap3_pmx_core pin definations so that they
> >> are close to omap3_pmx_wkup pin definations.
> >>
> >> Signed-off-by: Roger Quadros <rogerq@ti.com>
> >> ---
> >
> > just using this thread, but a question ->
> >
> > I am kernel * master dec8e46 Merge
> > tag 'arc-v3.13-rc1-part2' of
> > git://git.kernel.org/pub/scm/linux/kernel/git/vgupta/arc
> >
> > and I see that VAUX2 which supplies USB_1V8[1] is not enabled -> I did
> > a quick patch and it did seem to work (Usb keyboard, networking, mouse
> > etc on my ehci ports seems to come up good) - any suggestions how we'd
> > like to handle this?
>
> It worked for me without your patch. It could be that u-boot is enabling
> that regulator for me. I'm on u-boot-v2013.10.
>
> In any case, your patch seems the right thing to do. We should take it in
> the rc cycle.
Can you guys post a proper fix for this? Meanwhile, I'll mark this
thread as read to shrink my inbox a bit.
Regards,
Tony
WARNING: multiple messages have this Message-ID (diff)
From: tony@atomide.com (Tony Lindgren)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH v3 09/10] ARM: dts: omap3-beagle-xm: Add USB Host support
Date: Tue, 26 Nov 2013 13:04:56 -0800 [thread overview]
Message-ID: <20131126210456.GN26766@atomide.com> (raw)
In-Reply-To: <528C8FBC.7020407@ti.com>
* Roger Quadros <rogerq@ti.com> [131120 02:33]:
> Nishant,
>
> On 11/19/2013 11:05 PM, Nishanth Menon wrote:
> >
> >
> > On 09/24/2013 03:53 AM, Roger Quadros wrote:
> >> Provide RESET GPIO and Power regulator for the USB PHY,
> >> the USB Host port mode and the PHY device for the controller.
> >> Also provide pin multiplexer information for USB host pins.
> >>
> >> We also relocate omap3_pmx_core pin definations so that they
> >> are close to omap3_pmx_wkup pin definations.
> >>
> >> Signed-off-by: Roger Quadros <rogerq@ti.com>
> >> ---
> >
> > just using this thread, but a question ->
> >
> > I am kernel * master dec8e46 Merge
> > tag 'arc-v3.13-rc1-part2' of
> > git://git.kernel.org/pub/scm/linux/kernel/git/vgupta/arc
> >
> > and I see that VAUX2 which supplies USB_1V8[1] is not enabled -> I did
> > a quick patch and it did seem to work (Usb keyboard, networking, mouse
> > etc on my ehci ports seems to come up good) - any suggestions how we'd
> > like to handle this?
>
> It worked for me without your patch. It could be that u-boot is enabling
> that regulator for me. I'm on u-boot-v2013.10.
>
> In any case, your patch seems the right thing to do. We should take it in
> the rc cycle.
Can you guys post a proper fix for this? Meanwhile, I'll mark this
thread as read to shrink my inbox a bit.
Regards,
Tony
next prev parent reply other threads:[~2013-11-26 21:04 UTC|newest]
Thread overview: 71+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-09-24 8:53 [PATCH v3 00/10] USB: phy: phy-nop: Manage RESET GPIO in the driver Roger Quadros
2013-09-24 8:53 ` Roger Quadros
2013-09-24 8:53 ` Roger Quadros
[not found] ` <1380012836-29900-1-git-send-email-rogerq-l0cyMroinI0@public.gmane.org>
2013-09-24 8:53 ` [PATCH v3 01/10] usb: phy: generic: Add gpio_reset to platform data Roger Quadros
2013-09-24 8:53 ` Roger Quadros
2013-09-24 8:53 ` Roger Quadros
2013-09-24 8:53 ` [PATCH v3 03/10] ARM: OMAP2+: omap-usb-host: Get rid of platform_data from struct usbhs_phy_data Roger Quadros
2013-09-24 8:53 ` Roger Quadros
2013-09-24 8:53 ` Roger Quadros
[not found] ` <1380012836-29900-4-git-send-email-rogerq-l0cyMroinI0@public.gmane.org>
2013-10-02 10:19 ` Roger Quadros
2013-10-02 10:19 ` Roger Quadros
2013-10-02 10:19 ` Roger Quadros
2013-10-03 4:03 ` Tony Lindgren
2013-10-03 4:03 ` Tony Lindgren
2013-09-24 8:53 ` [PATCH v3 04/10] ARM: OMAP2+: usb-host: Adapt to USB phy-nop RESET line changes Roger Quadros
2013-09-24 8:53 ` Roger Quadros
2013-09-24 8:53 ` Roger Quadros
2013-10-02 10:20 ` Roger Quadros
2013-10-02 10:20 ` Roger Quadros
2013-10-02 10:20 ` Roger Quadros
[not found] ` <524BF354.3000502-l0cyMroinI0@public.gmane.org>
2013-10-03 4:03 ` Tony Lindgren
2013-10-03 4:03 ` Tony Lindgren
2013-10-03 4:03 ` Tony Lindgren
2013-09-24 8:53 ` [PATCH v3 05/10] ARM: dts: omap3-beagle: Use reset-gpios for hsusb2_reset Roger Quadros
2013-09-24 8:53 ` Roger Quadros
2013-09-24 8:53 ` Roger Quadros
2013-10-03 10:34 ` Roger Quadros
2013-10-03 10:34 ` Roger Quadros
2013-10-03 10:34 ` Roger Quadros
[not found] ` <524D483D.9040907-l0cyMroinI0@public.gmane.org>
2013-10-03 12:05 ` Benoit Cousson
2013-10-03 12:05 ` Benoit Cousson
2013-10-03 12:05 ` Benoit Cousson
2013-10-03 13:44 ` Benoit Cousson
2013-10-03 13:44 ` Benoit Cousson
[not found] ` <524D74A5.7010604-rdvid1DuHRBWk0Htik3J/w@public.gmane.org>
2013-10-03 13:58 ` Roger Quadros
2013-10-03 13:58 ` Roger Quadros
2013-10-03 13:58 ` Roger Quadros
[not found] ` <524D780C.1090708-l0cyMroinI0@public.gmane.org>
2013-10-03 14:25 ` Benoit Cousson
2013-10-03 14:25 ` Benoit Cousson
2013-10-03 14:25 ` Benoit Cousson
2013-09-24 8:53 ` [PATCH v3 07/10] ARM: dts: omap5-uevm: Use reset-gpios for hsusb2/3_reset Roger Quadros
2013-09-24 8:53 ` Roger Quadros
2013-09-24 8:53 ` Roger Quadros
2013-09-24 8:53 ` [PATCH v3 02/10] usb: phy: generic: Don't use regulator framework for RESET line Roger Quadros
2013-09-24 8:53 ` Roger Quadros
2013-09-24 8:53 ` Roger Quadros
2013-09-24 8:53 ` [PATCH v3 06/10] ARM: dts: omap4-panda: Use reset-gpios for hsusb1_reset Roger Quadros
2013-09-24 8:53 ` Roger Quadros
2013-09-24 8:53 ` Roger Quadros
2013-09-24 8:53 ` [PATCH v3 08/10] ARM: dts: omap3-beagle: Make USB host pin naming consistent Roger Quadros
2013-09-24 8:53 ` Roger Quadros
2013-09-24 8:53 ` Roger Quadros
2013-09-24 8:53 ` [PATCH v3 09/10] ARM: dts: omap3-beagle-xm: Add USB Host support Roger Quadros
2013-09-24 8:53 ` Roger Quadros
2013-09-24 8:53 ` Roger Quadros
[not found] ` <1380012836-29900-10-git-send-email-rogerq-l0cyMroinI0@public.gmane.org>
2013-11-19 21:05 ` Nishanth Menon
2013-11-19 21:05 ` Nishanth Menon
2013-11-19 21:05 ` Nishanth Menon
2013-11-20 10:32 ` Roger Quadros
2013-11-20 10:32 ` Roger Quadros
2013-11-20 10:32 ` Roger Quadros
2013-11-26 21:04 ` Tony Lindgren [this message]
2013-11-26 21:04 ` Tony Lindgren
2013-11-26 22:15 ` Nishanth Menon
2013-11-26 22:15 ` Nishanth Menon
2013-09-24 8:53 ` [PATCH v3 10/10] ARM: dts: omap3-beagle: Add USB OTG PHY details Roger Quadros
2013-09-24 8:53 ` Roger Quadros
2013-09-24 8:53 ` Roger Quadros
2013-10-03 10:32 ` [PATCH v3 00/10] USB: phy: phy-nop: Manage RESET GPIO in the driver Roger Quadros
2013-10-03 10:32 ` Roger Quadros
2013-10-03 10:32 ` Roger Quadros
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20131126210456.GN26766@atomide.com \
--to=tony@atomide.com \
--cc=balbi@ti.com \
--cc=bcousson@baylibre.com \
--cc=broonie@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-omap@vger.kernel.org \
--cc=linux-usb@vger.kernel.org \
--cc=nm@ti.com \
--cc=p.zabel@pengutronix.de \
--cc=rogerq@ti.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.