Re: [PATCH v1 0/4] powerpc/512x: update COMMON_CLK support for MPC5125

[Mike Turquette <mturquette@linaro.org>]

Quoting Gerhard Sittig (2013-12-10 05:11:33)
> this series improves the previously introduced common clock support for
> MPC512x such that SoC variants 5123 and 5125 get addressed appropriately
> (MPC5125 turned out to be rather different from MPC5121 than I perceived
> before -- there is much more than "just two FECs and no MBX")
> =

> thus this series depends on "add COMMON_CLK support for PowerPC MPC512x"
> (v6 sent in <1385851897-23475-1-git-send-email-gsi@denx.de>, applicable
> on top of v3.13-rc1 or later, currently applied to mpc5xxx -next,
> available at git://git.denx.de/linux-2.6-agust.git next)
> =

> this series does not address the issue of outdated or missing device
> tree binding documentation for MPC512x peripherals -- that's the scope
> of a pending separate series

For the three clock patches:

Acked-by: Mike Turquette <mturquette@linaro.org>

> =

> v1 initial submission (2013-12-10)
> - enforce an even divider value for SDHC (on all MPC512x variants)
> - tell 5121/5123/5125 SoC variants apart and only register the
>   appropriate set of clock items (i.e. refuse to access unused and
>   reserved bits, and support those components which are only found on
>   MPC5125)
> - update the MPC5125 "tower" board DTS (although the code still works in
>   the absence of device tree clock specs)
> =

> the series passes 'checkpatch.pl --strict' except for two warnings which
> cannot get fixed because <linux/clk-provider.h> dictates the data type
> and "fixing" the warning would break the build
> =

>   WARNING: static const char * array should probably be static const char=
 * const
>   #256: FILE: arch/powerpc/platforms/512x/clock-commonclk.c:500:
>   +static const char *parent_names_mux0_spdif[] =3D {
> =

>   WARNING: static const char * array should probably be static const char=
 * const
>   #260: FILE: arch/powerpc/platforms/512x/clock-commonclk.c:504:
>   +static const char *parent_names_mux0_canin[] =3D {
> =

>   total: 0 errors, 2 warnings, 0 checks, 495 lines checked
> =

> the series was build-tested, and was run-tested on the MPC5121 ADS board
> =

> Matteo, can you verify the crystal frequency in the DTS update, please?
> And that v3.13-rc kernels with v6 of the COMMON_CLK introduction for
> MPC512x plus this series for MPC5125 operate your peripherals, both with
> an updated device tree as well as with a former device tree that lacks
> clock specs?  Thank you!  Setting CONFIG_COMMON_CLK_DEBUG=3Dy in your
> .config and eyeballing /sys/kernel/debug/clk/clk_summary will help you.
> =

> Gerhard Sittig (4):
>   powerpc/512x: clk: minor comment updates
>   powerpc/512x: clk: enforce even SDHC divider values
>   powerpc/512x: clk: support MPC5121/5123/5125 SoC variants
>   powerpc/512x: dts: add MPC5125 clock specs
> =

>  arch/powerpc/boot/dts/mpc5125twr.dts          |   53 +++-
>  arch/powerpc/include/asm/mpc5121.h            |    7 +-
>  arch/powerpc/platforms/512x/clock-commonclk.c |  369 +++++++++++++++++++=
++----
>  include/dt-bindings/clock/mpc512x-clock.h     |    9 +-
>  4 files changed, 386 insertions(+), 52 deletions(-)
> =

> -- =

> 1.7.10.4
>=20