From: Maxime Ripard <maxime.ripard@free-electrons.com>
To: Hans de Goede <hdegoede@redhat.com>, Chen-Yu Tsai <wens@csie.org>
Cc: "Chris Ball" <chris@printf.net>,
"Ulf Hansson" <ulf.hansson@linaro.org>,
"Emilio Lopez" <emilio@elopez.com.ar>,
"Mike Turquette" <mturquette@linaro.org>,
"David Lanzendörfer" <david.lanzendoerfer@o2s.ch>,
linux-mmc@vger.kernel.org, linux-arm-kernel@lists.infradead.org,
devicetree <devicetree@vger.kernel.org>,
linux-sunxi@googlegroups.com
Subject: Re: [PATCH v10 15/15] ARM: dts: sun7i: Add basic support for the Cubietruck WiFi module
Date: Sun, 4 May 2014 23:02:12 -0500 [thread overview]
Message-ID: <20140505040212.GC11606@lukather> (raw)
In-Reply-To: <1399046249-19472-16-git-send-email-hdegoede@redhat.com>
[-- Attachment #1: Type: text/plain, Size: 734 bytes --]
On Fri, May 02, 2014 at 05:57:29PM +0200, Hans de Goede wrote:
> From: Chen-Yu Tsai <wens@csie.org>
>
> The CubieTruck has an AMPAK AP6210 WiFi+Bluetooth module. The WiFi
> part is a BCM43362 IC connected to MMC3 in the A20 SoC via SDIO.
> The IC also takes a power enable signal via GPIO.
>
> The WiFi module supports out-of-band interrupt signaling via GPIO,
> but this is not supported in this patch.
>
> Signed-off-by: Hans de Goede <hdegoede@redhat.com>
It doesn't have Chen-Yu SoB. Chen-Yu, are you fine with adding it?
No need to respin the set, I'll add it when applying if it's ok.
Maxime
--
Maxime Ripard, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com
[-- Attachment #2: Digital signature --]
[-- Type: application/pgp-signature, Size: 836 bytes --]
WARNING: multiple messages have this Message-ID (diff)
From: maxime.ripard@free-electrons.com (Maxime Ripard)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH v10 15/15] ARM: dts: sun7i: Add basic support for the Cubietruck WiFi module
Date: Sun, 4 May 2014 23:02:12 -0500 [thread overview]
Message-ID: <20140505040212.GC11606@lukather> (raw)
In-Reply-To: <1399046249-19472-16-git-send-email-hdegoede@redhat.com>
On Fri, May 02, 2014 at 05:57:29PM +0200, Hans de Goede wrote:
> From: Chen-Yu Tsai <wens@csie.org>
>
> The CubieTruck has an AMPAK AP6210 WiFi+Bluetooth module. The WiFi
> part is a BCM43362 IC connected to MMC3 in the A20 SoC via SDIO.
> The IC also takes a power enable signal via GPIO.
>
> The WiFi module supports out-of-band interrupt signaling via GPIO,
> but this is not supported in this patch.
>
> Signed-off-by: Hans de Goede <hdegoede@redhat.com>
It doesn't have Chen-Yu SoB. Chen-Yu, are you fine with adding it?
No need to respin the set, I'll add it when applying if it's ok.
Maxime
--
Maxime Ripard, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 836 bytes
Desc: Digital signature
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20140504/cade465f/attachment.sig>
next prev parent reply other threads:[~2014-05-05 4:05 UTC|newest]
Thread overview: 68+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-05-02 15:57 [PATCH v10 00/15] ARM: sunxi: Add driver for SD/MMC hosts found on Allwinner sunxi SoCs Hans de Goede
2014-05-02 15:57 ` Hans de Goede
[not found] ` <1399046249-19472-1-git-send-email-hdegoede-H+wXaHxf7aLQT0dZR+AlfA@public.gmane.org>
2014-05-02 15:57 ` [PATCH v10 01/15] clk: sunxi: factors: automatic reparenting support Hans de Goede
2014-05-02 15:57 ` Hans de Goede
[not found] ` <1399046249-19472-2-git-send-email-hdegoede-H+wXaHxf7aLQT0dZR+AlfA@public.gmane.org>
2014-05-06 18:51 ` Maxime Ripard
2014-05-06 18:51 ` Maxime Ripard
2014-05-06 20:24 ` Emilio López
2014-05-06 20:24 ` Emilio López
2014-05-02 15:57 ` [PATCH v10 02/15] clk: sunxi: Implement MMC phase control Hans de Goede
2014-05-02 15:57 ` Hans de Goede
[not found] ` <1399046249-19472-3-git-send-email-hdegoede-H+wXaHxf7aLQT0dZR+AlfA@public.gmane.org>
2014-05-06 18:53 ` Maxime Ripard
2014-05-06 18:53 ` Maxime Ripard
2014-05-02 15:57 ` [PATCH v10 03/15] ARM: sunxi: Add driver for SD/MMC hosts found on Allwinner sunxi SoCs Hans de Goede
2014-05-02 15:57 ` Hans de Goede
2014-05-05 12:41 ` Ulf Hansson
2014-05-05 12:41 ` Ulf Hansson
[not found] ` <CAPDyKFoinhyob7GZLgH4Dm7KdHCxj1+OpuZYKDK3OkU8RFsY8A-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2014-05-05 13:10 ` Hans de Goede
2014-05-05 13:10 ` Hans de Goede
2014-05-05 20:33 ` Ulf Hansson
2014-05-05 20:33 ` Ulf Hansson
[not found] ` <CAPDyKFpAGNLaKagJ_RPt1vbz70pNWJzo-s6Ao50Mh0gFrRLN0g-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2014-05-08 11:26 ` Hans de Goede
2014-05-08 11:26 ` Hans de Goede
2014-05-08 12:17 ` Ulf Hansson
2014-05-08 12:17 ` Ulf Hansson
[not found] ` <CAPDyKFqbN61EgiTbktL-vm+L7q06OTeedCTVXJsP16ZZZd8g8A-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2014-05-08 12:30 ` Hans de Goede
2014-05-08 12:30 ` Hans de Goede
[not found] ` <536B78FF.2020808-H+wXaHxf7aLQT0dZR+AlfA@public.gmane.org>
2014-05-08 15:35 ` Maxime Ripard
2014-05-08 15:35 ` Maxime Ripard
2014-05-08 16:37 ` Hans de Goede
2014-05-08 16:37 ` Hans de Goede
2014-05-02 15:57 ` [PATCH v10 04/15] ARM: dts: sun4i: Add mmc controller nodes Hans de Goede
2014-05-02 15:57 ` Hans de Goede
2014-05-02 15:57 ` [PATCH v10 05/15] ARM: dts: sun4i: Add pin-muxing info for the mmc0 controller Hans de Goede
2014-05-02 15:57 ` Hans de Goede
2014-05-02 15:57 ` [PATCH v10 06/15] ARM: dts: sun4i: Enable mmc controller on various A10 boards Hans de Goede
2014-05-02 15:57 ` Hans de Goede
2014-05-02 15:57 ` [PATCH v10 07/15] ARM: dts: sun5i: Add mmc controller nodes Hans de Goede
2014-05-02 15:57 ` Hans de Goede
2014-05-02 15:57 ` [PATCH v10 08/15] ARM: dts: sun5i: Enable mmc controller on various A10s and A13 boards Hans de Goede
2014-05-02 15:57 ` Hans de Goede
2014-05-02 15:57 ` [PATCH v10 09/15] ARM: dts: sun6i: Add mmc clocks Hans de Goede
2014-05-02 15:57 ` Hans de Goede
2014-05-02 15:57 ` [PATCH v10 10/15] ARM: dts: sun6i: Add mmc controller nodes Hans de Goede
2014-05-02 15:57 ` Hans de Goede
2014-05-02 15:57 ` [PATCH v10 11/15] ARM: dts: sun6i: Add new sun6i-a31-m9 dts file for Mele M9 Hans de Goede
2014-05-02 15:57 ` Hans de Goede
2014-05-02 15:57 ` [PATCH v10 12/15] ARM: dts: sun7i: Add mmc controller nodes Hans de Goede
2014-05-02 15:57 ` Hans de Goede
2014-05-02 15:57 ` [PATCH v10 13/15] ARM: dts: sun7i: Add pin-muxing info for the mmc controllers Hans de Goede
2014-05-02 15:57 ` Hans de Goede
2014-05-02 15:57 ` [PATCH v10 14/15] ARM: dts: sun7i: Enable mmc controller on various A20 boards Hans de Goede
2014-05-02 15:57 ` Hans de Goede
2014-05-02 15:57 ` [PATCH v10 15/15] ARM: dts: sun7i: Add basic support for the Cubietruck WiFi module Hans de Goede
2014-05-02 15:57 ` Hans de Goede
2014-05-05 4:02 ` Maxime Ripard [this message]
2014-05-05 4:02 ` Maxime Ripard
2014-05-05 4:20 ` Chen-Yu Tsai
2014-05-05 4:20 ` Chen-Yu Tsai
2014-05-05 22:46 ` Maxime Ripard
2014-05-05 22:46 ` Maxime Ripard
[not found] ` <1399046249-19472-16-git-send-email-hdegoede-H+wXaHxf7aLQT0dZR+AlfA@public.gmane.org>
2014-05-05 22:45 ` Maxime Ripard
2014-05-05 22:45 ` Maxime Ripard
2014-05-05 4:00 ` [PATCH v10 00/15] ARM: sunxi: Add driver for SD/MMC hosts found on Allwinner sunxi SoCs Maxime Ripard
2014-05-05 4:00 ` Maxime Ripard
2014-05-06 17:04 ` Mike Turquette
2014-05-06 17:04 ` Mike Turquette
2014-05-08 11:05 ` Hans de Goede
2014-05-08 11:05 ` Hans de Goede
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20140505040212.GC11606@lukather \
--to=maxime.ripard@free-electrons.com \
--cc=chris@printf.net \
--cc=david.lanzendoerfer@o2s.ch \
--cc=devicetree@vger.kernel.org \
--cc=emilio@elopez.com.ar \
--cc=hdegoede@redhat.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-mmc@vger.kernel.org \
--cc=linux-sunxi@googlegroups.com \
--cc=mturquette@linaro.org \
--cc=ulf.hansson@linaro.org \
--cc=wens@csie.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.