Re: [PATCH v10 4/6] devicetree: Add new SKY81452 backlight binding

[Gyungoh Yoo <gyungoh@gmail.com>]

On Fri, Jan 23, 2015 at 03:28:33PM +0900, gyungoh@gmail.com wrote:
> From: Gyungoh Yoo <jack.yoo@skyworksinc.com>
> 
> Signed-off-by: Gyungoh Yoo <jack.yoo@skyworksinc.com>
> Acked-by: Bryan Wu <cooloney@gmail.com>

The existing Ack is only for backlight driver.

DT Ack please.

> ---
> Changes v10:
> Nothing
> 
> Changes v9:
> Nothing
> 
> Changes v8:
> Renamed property names for backlight with vendor prefix
> Modified gpio-enable property to generic property for GPIO
> Made up the example for backlight DT
> 
> Changes v7:
> Nothing
> 
> Changes v6:
> Nothing
> 
> Changes v5:
> Nothing
> 
> Changes v4:
> Nothing
> 
> Changes v3:
> Nothing
> 
> Changes v2:
> Added reg attribute for I2C slave address
> 
>  .../video/backlight/sky81452-backlight.txt         | 29 ++++++++++++++++++++++
>  1 file changed, 29 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/video/backlight/sky81452-backlight.txt
> 
> diff --git a/Documentation/devicetree/bindings/video/backlight/sky81452-backlight.txt b/Documentation/devicetree/bindings/video/backlight/sky81452-backlight.txt
> new file mode 100644
> index 0000000..8daebf5
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/video/backlight/sky81452-backlight.txt
> @@ -0,0 +1,29 @@
> +SKY81452-backlight bindings
> +
> +Required properties:
> +- compatible		: Must be "skyworks,sky81452-backlight"
> +
> +Optional properties:
> +- name			: Name of backlight device. Default is 'lcd-backlight'.
> +- gpios			: GPIO to use to EN pin.
> +			See Documentation/devicetree/bindings/gpio/gpio.txt
> +- skyworks,en-channels	: Enable mask for current sink channel 1 to 6.
> +- skyworks,ignore-pwm	: Ignore both PWM input
> +- skyworks,dpwm-mode	: Enable DPWM dimming mode, otherwise Analog dimming.
> +- skyworks,phase-shift	: Enable phase shift mode
> +- skyworks,ovp-level	: Over-voltage protection level.
> +			Should be between 14 or 28V.
> +- skyworks,short-detection-threshold	: It should be one of 4, 5, 6 and 7V.
> +- skyworks,current-limit	: It should be 2300mA or 2750mA.
> +
> +Example:
> +
> +	backlight {
> +		compatible = "skyworks,sky81452-backlight";
> +		name = "pwm-backlight";
> +		skyworks,en-channels = <0x3f>;
> +		skyworks,ignore-pwm;
> +		skyworks,phase-shift;
> +		skyworks,ovp-level = <20>;
> +		skyworks,current-limit = <2300>;
> +	};
> -- 
> 1.9.1
>