Re: [PATCH 2/2] pinctrl: sunxi: Change mux setting on PI irq pins

[Maxime Ripard <maxime.ripard@free-electrons.com>]

[-- Attachment #1: Type: text/plain, Size: 1381 bytes --]

On Mon, Feb 29, 2016 at 12:13:27AM +0100, Henry Paulissen wrote:
> While I was testing irq's on the cubietruck I found a couple of
> not working irq pins. Further diving into the problem it opened
> up a mess called "manual".
> 
> This so called manual (A20 user manual v1.3 dated 2014-10-10) says:
> 
> Pin overview:
>     Page 237:       EINT26 is on mux 5.
>     Page 288:       EINT26 is on mux 6.
> 
> The manual is so contradicting that further tests had to be made
> to see which of the 2 statements where correct.
> 
> This patch is based on actual outcome of these tests and not what
> the manual says.
> 
> Test procedure used:
> 
> Connect a 1 pulse per second (GPS) line to the pin.
> 
> echo pin### > /sys/class/gpio/export
> echo in > /sys/class/gpio/gpio###/direction
> echo rising > /sys/class/gpio/gpio###/edge
> 
> Check /proc/interrupts if a irq was attached and if irq's where
> received.
> 
> Hardware used:
> Henry Paulissen: Cubietruck
> Andere Przywara: BananaPi M1
> 
> Tested-by: Andre Przywara <andre.przywara@arm.com>
> Reviewed-by: Andre Przywara <andre.przywara@arm.com>
> Signed-off-by: Henry Paulissen <henry@nitronetworks.nl>

Acked-by: Maxime Ripard <maxime.ripard@free-electrons.com>

Thanks !

-- 
Maxime Ripard, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com

[-- Attachment #2: Digital signature --]
[-- Type: application/pgp-signature, Size: 819 bytes --]