Re: [PATCH v2 2/2] ARM: dts: sd_600eval: Fix eMMC lockup issue

[Bjorn Andersson <bjorn.andersson@linaro.org>]

On Fri 10 Jun 11:19 PDT 2016, Srinivas Kandagatla wrote:

> From: Parth Pancholi <parth.pancholi@einfochips.com>
> 
> This board locks up if we stress test the eMMC, as the regulator s4 is
> unable to supply enough current for all the peripherials attached to it.
> As this supply is wired up to most of the peripherials including DDR,
> it resulted in such lockup.
> 
> This patch fixes this issue by setting s4 regulator correctly with
> Auto power mode.
> 
> Reported-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
> [Srinivas Kandagatla: rewrote the change log]
> Tested-by: Girish Sharma <girish.sharma@einfochips.com>
> Signed-off-by: Parth Pancholi <parth.pancholi@einfochips.com>

If I read the msm-3.4 tree correctly most (perhaps all) 8064 devices
should have this setup.

Acked-by: Bjorn Andersson <bjorn.andersson@linaro.org>

Regards,
Bjorn

> ---
>  arch/arm/boot/dts/qcom-apq8064-arrow-sd-600eval.dts | 4 +++-
>  1 file changed, 3 insertions(+), 1 deletion(-)
> 
> diff --git a/arch/arm/boot/dts/qcom-apq8064-arrow-sd-600eval.dts b/arch/arm/boot/dts/qcom-apq8064-arrow-sd-600eval.dts
> index 7df0108..39ae2bc 100644
> --- a/arch/arm/boot/dts/qcom-apq8064-arrow-sd-600eval.dts
> +++ b/arch/arm/boot/dts/qcom-apq8064-arrow-sd-600eval.dts
> @@ -1,6 +1,7 @@
>  #include "qcom-apq8064-v2.0.dtsi"
>  #include "qcom-apq8064-arrow-sd-600eval-pins.dtsi"
>  #include <dt-bindings/gpio/gpio.h>
> +#include <dt-bindings/mfd/qcom-rpm.h>
>  
>  / {
>  	model = "Arrow Electronics, APQ8064 SD_600eval";
> @@ -82,7 +83,8 @@
>  				s4 {
>  					regulator-min-microvolt	= <1800000>;
>  					regulator-max-microvolt	= <1800000>;
> -					qcom,switch-mode-frequency = <3200000>;
> +					qcom,switch-mode-frequency = <1600000>;
> +					qcom,force-mode = <QCOM_RPM_FORCE_MODE_AUTO>;
>  					bias-pull-down;
>  					regulator-always-on;
>  				};
> -- 
> 2.8.3
>