[PATCH v4 4/4] ARM: dts: da850: Add the usb otg device nodeg

[b-liu@ti.com (Bin Liu)]

On Tue, Nov 15, 2016 at 04:16:02PM +0530, Sekhar Nori wrote:
> On Thursday 03 November 2016 09:29 PM, Alexandre Bailon wrote:
> > This adds the device tree node for the usb otg
> > controller present in the da850 family of SoC's.
> > This also enables the otg usb controller for the lcdk board.
> > 
> > Signed-off-by: Alexandre Bailon <abailon@baylibre.com>
> > ---
> >  arch/arm/boot/dts/da850-lcdk.dts |  8 ++++++++
> >  arch/arm/boot/dts/da850.dtsi     | 15 +++++++++++++++
> >  2 files changed, 23 insertions(+)
> > 
> > diff --git a/arch/arm/boot/dts/da850-lcdk.dts b/arch/arm/boot/dts/da850-lcdk.dts
> > index 7b8ab21..9f5040c 100644
> > --- a/arch/arm/boot/dts/da850-lcdk.dts
> > +++ b/arch/arm/boot/dts/da850-lcdk.dts
> > @@ -158,6 +158,14 @@
> >  	rx-num-evt = <32>;
> >  };
> >  
> > +&usb_phy {
> > +	status = "okay";
> > +	};
> 
> As mentioned by David already, this node needs to be removed. Please
> rebase this on top of latest linux-davinci/master when ready for merging
> (driver changes accepted).

Dropped this patch due to this comment.

Regards,
-Bin.

> 
> > +
> > +&usb0 {
> > +	status = "okay";
> > +};
> > +
> >  &aemif {
> >  	pinctrl-names = "default";
> >  	pinctrl-0 = <&nand_pins>;
> > diff --git a/arch/arm/boot/dts/da850.dtsi b/arch/arm/boot/dts/da850.dtsi
> > index f79e1b9..322a31a 100644
> > --- a/arch/arm/boot/dts/da850.dtsi
> > +++ b/arch/arm/boot/dts/da850.dtsi
> > @@ -372,6 +372,21 @@
> >  					>;
> >  			status = "disabled";
> >  		};
> > +		usb_phy: usb-phy {
> > +			compatible = "ti,da830-usb-phy";
> > +			#phy-cells = <1>;
> > +			status = "disabled";
> > +		};
> > +		usb0: usb at 200000 {
> > +			compatible = "ti,da830-musb";
> > +			reg = <0x200000 0x10000>;
> > +			interrupts = <58>;
> > +			interrupt-names = "mc";
> > +			dr_mode = "otg";
> > +			phys = <&usb_phy 0>;
> > +			phy-names = "usb-phy";
> > +			status = "disabled";
> > +		};
> 
> Can you separate out the soc specific changes from board changes? Please
> place the usb0 node above the mdio node. I am trying to get to a rough
> ordering based on reg property.
> 
> Thanks,
> Sekhar
>