Re: [PATCH 2/2] backlight: arcxcnn: devicetree bindings for ArticSand devices

[Lee Jones <lee.jones@linaro.org>]

Your subject should look something like [PATCH vX 0/Y]

Where X is the number of times you've submitted this set.

On Fri, 18 Nov 2016, Olimpiu Dejeu wrote:
> Re-submission of arcxcnn backlight driver addressing the naming convention
>  concerns raised by Rob H. Note that all the device tree properties are
>  determined by the board design or IC EPROM settings and are not intended
>  to be user adjustable.

This is a change log, not a commit log.

Here is where you tell us about the patch.

  Read: Documentation/SubmittingPatches
        Documentation/SubmitChecklist

... before submitting again.

> Acked-by: Rob Herring <robh@kernel.org>
> Signed-off-by: Olimpiu Dejeu <olimpiu@arcticsand.com>
> 
> ---

In here (below the ---) you should have a change log which looks like
this:

v3 => v4:
- The changes you made

v2 => v3:
- The changes you made

v1 => v2:
- The changes you made

... etc

>  .../bindings/leds/backlight/arcxcnn_bl.txt         | 31 ++++++++++++++++++++++
>  1 file changed, 31 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/leds/backlight/arcxcnn_bl.txt
> 
> diff --git a/Documentation/devicetree/bindings/leds/backlight/arcxcnn_bl.txt b/Documentation/devicetree/bindings/leds/backlight/arcxcnn_bl.txt
> new file mode 100644
> index 0000000..a7b6ff2
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/leds/backlight/arcxcnn_bl.txt
> @@ -0,0 +1,33 @@
> +Binding for ArcticSand arc2c0608 LED driver
> +
> +Required properties:
> +- compatible: should be "arc,arc2c0608"
> +- reg: slave address
> +
> +Optional properties:
> +- default-brightness: brightness value on boot, value from: 0-4095
> +- label: The name of the backlight device
> +			See Documentation/devicetree/bindings/leds/common.txt
> +- led-sources: List of enabled channels from 0 to 5.
> +			See Documentation/devicetree/bindings/leds/common.txt
> +
> +- arc,led-config-0: setting for register ILED_CONFIG_0
> +- arc,led-config-1: setting for register ILED_CONFIG_1
> +- arc,dim-freq: PWM mode frequence setting (bits [3:0] used)
> +- arc,comp-config: setting for register CONFIG_COMP
> +- arc,filter-config: setting for register FILTER_CONFIG
> +- arc,trim-config: setting for register IMAXTUNE
> +
> +Note: Optional properties not specified will default to values in IC EPROM
> +
> +Example:
> +
> +arc2c0608@30 {
> +	compatible = "arc,arc2c0608";
> +	reg = <0x30>;
> +	default-brightness = <500>;
> +	label = "lcd-backlight";
> +	linux,default-trigger = "backlight";
> +	led-sources = <0 1 2 5>;
> +};
> +

-- 
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog