All of lore.kernel.org
 help / color / mirror / Atom feed
From: Sebastian Reichel <sre@kernel.org>
To: Sebastian Reichel <sre@kernel.org>, Tony Lindgren <tony@atomide.com>
Cc: Rob Herring <robh+dt@kernel.org>,
	linux-bluetooth@vger.kernel.org, linux-kernel@vger.kernel.org,
	linux-omap@vger.kernel.org
Subject: [PATCH] ARM: dts: omap4-droid4: add bluetooth
Date: Sun, 16 Apr 2017 00:18:32 +0200	[thread overview]
Message-ID: <20170415221832.16175-1-sre@kernel.org> (raw)

Droid 4 has wl1835 connected to the OMAP's UART4 port, which is
used for Bluetooth and most likely can also be used for controlling
the FM radio and GPS receivers.

Signed-off-by: Sebastian Reichel <sre@kernel.org>
---
Hi,

Thanks to the work of Rob adding Bluetooth support for Droid 4 was
straight forward :) I did a short test scanning for available devices
using bluetoothctl. For that I had to rebind the bluetooth device,
since it has been initialized before rootfs/firmware was available
(builtin driver):

echo serial0-0 > /sys/bus/serial/drivers/hci-ti/unbind
echo serial0-0 > /sys/bus/serial/drivers/hci-ti/bind

According to my research the FM module should be functional on
Droid 4 and the wl1835's GPS is also used. Rob, do you have a
plans for supporting the extra resources?

-- Sebastian
---
 arch/arm/boot/dts/omap4-droid4-xt894.dts | 20 ++++++++++++++++++++
 1 file changed, 20 insertions(+)

diff --git a/arch/arm/boot/dts/omap4-droid4-xt894.dts b/arch/arm/boot/dts/omap4-droid4-xt894.dts
index e0fdfe6cc78c..2495faf79a43 100644
--- a/arch/arm/boot/dts/omap4-droid4-xt894.dts
+++ b/arch/arm/boot/dts/omap4-droid4-xt894.dts
@@ -395,6 +395,15 @@
 		>;
 	};
 
+	uart4_pins: pinmux_uart4_pins {
+		pinctrl-single,pins = <
+		OMAP4_IOPAD(0x15c, PIN_INPUT | MUX_MODE0)		/* uart4_rx */
+		OMAP4_IOPAD(0x15e, PIN_OUTPUT | MUX_MODE0)		/* uart4_tx */
+		OMAP4_IOPAD(0x110, PIN_INPUT_PULLUP | MUX_MODE5)	/* uart4_cts */
+		OMAP4_IOPAD(0x112, PIN_OUTPUT_PULLUP | MUX_MODE5)	/* uart4_rts */
+		>;
+	};
+
 	mcbsp2_pins: pinmux_mcbsp2_pins {
 		pinctrl-single,pins = <
 			OMAP4_IOPAD(0x0f6, PIN_INPUT | MUX_MODE0)	/* abe_mcbsp2_clkx */
@@ -429,6 +438,17 @@
 			       &omap4_pmx_core 0x17c>;
 };
 
+&uart4 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&uart4_pins>;
+
+	bluetooth {
+		compatible = "ti,wl1835-st";
+		enable-gpios = <&gpio6 14 GPIO_ACTIVE_HIGH>; /* gpio 174 */
+		max-speed = <3686400>;
+	};
+};
+
 &usbhsehci {
 	phys = <&hsusb1_phy>;
 };
-- 
2.11.0


WARNING: multiple messages have this Message-ID (diff)
From: Sebastian Reichel <sre-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>
To: Sebastian Reichel <sre-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>,
	Tony Lindgren <tony-4v6yS6AI5VpBDgjK7y7TUQ@public.gmane.org>
Cc: Rob Herring <robh+dt-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>,
	linux-bluetooth-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
	linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
	linux-omap-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
Subject: [PATCH] ARM: dts: omap4-droid4: add bluetooth
Date: Sun, 16 Apr 2017 00:18:32 +0200	[thread overview]
Message-ID: <20170415221832.16175-1-sre@kernel.org> (raw)

Droid 4 has wl1835 connected to the OMAP's UART4 port, which is
used for Bluetooth and most likely can also be used for controlling
the FM radio and GPS receivers.

Signed-off-by: Sebastian Reichel <sre-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>
---
Hi,

Thanks to the work of Rob adding Bluetooth support for Droid 4 was
straight forward :) I did a short test scanning for available devices
using bluetoothctl. For that I had to rebind the bluetooth device,
since it has been initialized before rootfs/firmware was available
(builtin driver):

echo serial0-0 > /sys/bus/serial/drivers/hci-ti/unbind
echo serial0-0 > /sys/bus/serial/drivers/hci-ti/bind

According to my research the FM module should be functional on
Droid 4 and the wl1835's GPS is also used. Rob, do you have a
plans for supporting the extra resources?

-- Sebastian
---
 arch/arm/boot/dts/omap4-droid4-xt894.dts | 20 ++++++++++++++++++++
 1 file changed, 20 insertions(+)

diff --git a/arch/arm/boot/dts/omap4-droid4-xt894.dts b/arch/arm/boot/dts/omap4-droid4-xt894.dts
index e0fdfe6cc78c..2495faf79a43 100644
--- a/arch/arm/boot/dts/omap4-droid4-xt894.dts
+++ b/arch/arm/boot/dts/omap4-droid4-xt894.dts
@@ -395,6 +395,15 @@
 		>;
 	};
 
+	uart4_pins: pinmux_uart4_pins {
+		pinctrl-single,pins = <
+		OMAP4_IOPAD(0x15c, PIN_INPUT | MUX_MODE0)		/* uart4_rx */
+		OMAP4_IOPAD(0x15e, PIN_OUTPUT | MUX_MODE0)		/* uart4_tx */
+		OMAP4_IOPAD(0x110, PIN_INPUT_PULLUP | MUX_MODE5)	/* uart4_cts */
+		OMAP4_IOPAD(0x112, PIN_OUTPUT_PULLUP | MUX_MODE5)	/* uart4_rts */
+		>;
+	};
+
 	mcbsp2_pins: pinmux_mcbsp2_pins {
 		pinctrl-single,pins = <
 			OMAP4_IOPAD(0x0f6, PIN_INPUT | MUX_MODE0)	/* abe_mcbsp2_clkx */
@@ -429,6 +438,17 @@
 			       &omap4_pmx_core 0x17c>;
 };
 
+&uart4 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&uart4_pins>;
+
+	bluetooth {
+		compatible = "ti,wl1835-st";
+		enable-gpios = <&gpio6 14 GPIO_ACTIVE_HIGH>; /* gpio 174 */
+		max-speed = <3686400>;
+	};
+};
+
 &usbhsehci {
 	phys = <&hsusb1_phy>;
 };
-- 
2.11.0

             reply	other threads:[~2017-04-15 22:18 UTC|newest]

Thread overview: 6+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2017-04-15 22:18 Sebastian Reichel [this message]
2017-04-15 22:18 ` [PATCH] ARM: dts: omap4-droid4: add bluetooth Sebastian Reichel
2017-04-16  1:56 ` Rob Herring
     [not found] ` <CAEz3QY0duPa91TT3e86xA=tDGppiq0UXmDzuUm2i6cXbBi9CgQ@mail.gmail.com>
2017-04-16 15:26   ` Sebastian Reichel
2017-04-17 12:51     ` Rob Herring
2017-05-16 16:34 ` Tony Lindgren

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20170415221832.16175-1-sre@kernel.org \
    --to=sre@kernel.org \
    --cc=linux-bluetooth@vger.kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-omap@vger.kernel.org \
    --cc=robh+dt@kernel.org \
    --cc=tony@atomide.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.