Re: [PATCH 3/3] ARM: dts: gr-peach: Add ETHER pin group

[jacopo mondi <jacopo@jmondi.org>]

Hi Andrew,
   thanks for the suggestion

On Thu, Oct 05, 2017 at 06:48:26PM +0200, Andrew Lunn wrote:
> On Thu, Oct 05, 2017 at 05:42:39PM +0200, jacopo mondi wrote:
> > Hi Andrew,

[snip]

> > > Hi Jocopo
> > >
> > > So what is this reset resetting?
> > >
> > > The MAC?
> > > The PHY?
> >
> > The reset line goes from our SoC to LAN8710A PHY chip external reset pin.
>
> So yes, this is a PHY property, and should be in the PHY node.
>
> Documentation/devicetree/bindings/net/mdio.txt does not apply here
> anyway. That is for an MDIO binding. This node is an ethernet MAC.
>
> So your binding whats to look something like
>
>         ether: ethernet@e8203000 {
>                 compatible = "renesas,ether-r7s72100";
>                 reg = <0xe8203000 0x800>,
>                       <0xe8204800 0x200>;
>                 interrupts = <GIC_SPI 327 IRQ_TYPE_LEVEL_HIGH>;
>                 clocks = <&mstp7_clks R7S72100_CLK_ETHER>;
>                 power-domains = <&cpg_clocks>;
>                 phy-mode = "mii";
> 		          phy-handle = <&phy0>;
>                 #address-cells = <1>;
>                 #size-cells = <0>;
>
>                 mdio: bus-bus {
>                       #address-cells = <1>;
>                       #size-cells = <0>;
>
>                       phy0: ethernet-phy@1 {
>                             reg = <1>;

Why reg = <1> ?
Shouldn't this be 0, or even better with no reg property at all?

        mdio: bus-bus {
              phy-0 {
                  reset-gpios = <&port4 2 GPIO_ACTIVE_LOW>;
                  reset-delay-us = <5>;
              };
        };

Thanks
   j

>                             reset-gpios = <&port4 2 GPIO_ACTIVE_LOW>;
>                             reset-delay-us = <5>;
>                       };
>                 };
>         };
>
> 	Andrew