Re: [PATCH v2 2/5] gpio: syscon: Add gpio-syscon for rockchip

[Rob Herring <robh@kernel.org>]

On Fri, May 18, 2018 at 11:52:05AM +0800, djw@t-chip.com.cn wrote:
> From: Levin Du <djw@t-chip.com.cn>
> 
> Some GPIOs sit in the GRF_SOC_CON registers of Rockchip SoCs,
> which do not belong to the general pinctrl.
> 
> Adding gpio-syscon support makes controlling regulator or
> LED using these special pins very easy by reusing existing
> drivers, such as gpio-regulator and led-gpio.
> 
> Signed-off-by: Levin Du <djw@t-chip.com.cn>
> 
> ---
> 
> Changes in v2:
> - Rename gpio_syscon10 to gpio_mute in doc
> 
> Changes in v1:
> - Refactured for general gpio-syscon usage for Rockchip SoCs.
> - Add doc rockchip,gpio-syscon.txt
> 
>  .../bindings/gpio/rockchip,gpio-syscon.txt         | 41 ++++++++++++++++++++++
>  drivers/gpio/gpio-syscon.c                         | 30 ++++++++++++++++
>  2 files changed, 71 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/gpio/rockchip,gpio-syscon.txt
> 
> diff --git a/Documentation/devicetree/bindings/gpio/rockchip,gpio-syscon.txt b/Documentation/devicetree/bindings/gpio/rockchip,gpio-syscon.txt
> new file mode 100644
> index 0000000..b1b2a67
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/gpio/rockchip,gpio-syscon.txt
> @@ -0,0 +1,41 @@
> +* Rockchip GPIO support for GRF_SOC_CON registers
> +
> +Required properties:
> +- compatible: Should contain "rockchip,gpio-syscon".
> +- gpio-controller: Marks the device node as a gpio controller.
> +- #gpio-cells: Should be two. The first cell is the pin number and
> +  the second cell is used to specify the gpio polarity:
> +    0 = Active high,
> +    1 = Active low.

There's no need for this child node. Just make the parent node a gpio 
controller.

Rob