Re: [PATCH 05/11] ARM: dts: Reflect change of FSL QSPI driver and remove unused properties

[Boris Brezillon <boris.brezillon@bootlin.com>]

On Wed, 30 May 2018 15:14:34 +0200
Frieder Schrempf <frieder.schrempf@exceet.de> wrote:

> The FSL QSPI driver was moved to the SPI framework and it now
> acts as a SPI controller. Therefore the subnodes need to set
> spi-[rx/tx]-bus-width = <4>, so quad mode is used just as before.

We should try to keep the current behavior even when
spi-[rx/tx]-bus-width are not defined. How about considering
spi-[rx/tx]-bus-width as board constraints and then let the core pick
the best mode based on these constraints plus the SPI NOR chip
limitations.

> 
> Also the properties 'bus-num', 'fsl,spi-num-chipselects' and
> 'fsl,spi-flash-chipselects' were never read by the driver and
> can be removed.
> 
> The 'reg' properties are adjusted to reflect the what bus and
> chipselect the flash is connected to, as the new driver needs
> this information.
> 
> The property 'fsl,qspi-has-second-chip' is not needed anymore
> and will be removed after the old driver was disabled to avoid
> breaking ls1021a-moxa-uc-8410a.dts.
> 
> Signed-off-by: Frieder Schrempf <frieder.schrempf@exceet.de>
> ---
>  arch/arm/boot/dts/imx6sx-sdb-reva.dts       | 8 ++++++--
>  arch/arm/boot/dts/imx6sx-sdb.dts            | 8 ++++++--
>  arch/arm/boot/dts/imx6ul-14x14-evk.dtsi     | 2 ++
>  arch/arm/boot/dts/ls1021a-moxa-uc-8410a.dts | 5 ++---
>  4 files changed, 16 insertions(+), 7 deletions(-)
> 
> diff --git a/arch/arm/boot/dts/imx6sx-sdb-reva.dts b/arch/arm/boot/dts/imx6sx-sdb-reva.dts
> index e3533e7..1a6f680 100644
> --- a/arch/arm/boot/dts/imx6sx-sdb-reva.dts
> +++ b/arch/arm/boot/dts/imx6sx-sdb-reva.dts
> @@ -131,13 +131,17 @@
>  		#size-cells = <1>;
>  		compatible = "spansion,s25fl128s", "jedec,spi-nor";
>  		spi-max-frequency = <66000000>;
> +		spi-rx-bus-width = <4>;
> +		spi-tx-bus-width = <4>;
>  	};
>  
> -	flash1: s25fl128s@1 {
> -		reg = <1>;
> +	flash1: s25fl128s@2 {
> +		reg = <2>;

Hm, you're breaking backward compat here. Can we try to re-use the
old numbering scheme instead of patching all DTs?