Re: [PATCH v2 0/3] Add support for DLH pressure sensors

[Jonathan Cameron <jic23@kernel.org>]

On Fri, 29 Nov 2019 08:34:17 +0100
<tomislav.denis@avl.com> wrote:

> From: Tomislav Denis <tomislav.denis@avl.com>
> 
> This patchset adds support for All Sensors DLH series low
> voltage digital pressure sensors.
> 
> Datasheet: https://www.allsensors.com/cad/DS-0355_Rev_B.PDF
One generic comment before I look at the code.

Mostly (there may be exceptions) it is better to post a new version
as a separate email thread.   This avoid deep and extremely confusing
threads when we run into many versions.  Also, a lot of maintainers
have limited time so start at their most recent emails on the basis
that earlier discussions have often already been resolved by other
reviewers / contributors.  If you send in a reply to an older thread
you reduce the chance of anyone looking at it ;)

Thanks,

Jonathan

> 
> Changes in v2:
> - web page link in the MAINTAINERS file fixed
> - adjust the units of the output to the IIO ABI
> - unneceseary default case removed
> - define the channel member of the iio_chan_spec
>   struct for channels specification
> - remove explicit cast for pointers of type void *
> - add support for the EOC(data ready) pin
> - drop the unneceseary return ret;
> - rename dlh-i2c.yaml to asc,dlh-i2c.yaml
> - change the bindings copyright to GPL-2.0-only OR BSD-2-Clause
> - document EOC(data ready) pin
> 
> Tomislav Denis (3):
>   iio: pressure: Add driver for DLH pressure sensors
>   dt-bindings: Add asc vendor
>   bindings: iio: pressure: Add dlh-i2c documentation
> 
>  .../bindings/iio/pressure/asc,dlh-i2c.yaml         |  51 +++
>  .../devicetree/bindings/vendor-prefixes.yaml       |   2 +
>  MAINTAINERS                                        |   8 +
>  drivers/iio/pressure/Kconfig                       |  12 +
>  drivers/iio/pressure/Makefile                      |   1 +
>  drivers/iio/pressure/dlh-i2c.c                     | 429 +++++++++++++++++++++
>  6 files changed, 503 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/iio/pressure/asc,dlh-i2c.yaml
>  create mode 100644 drivers/iio/pressure/dlh-i2c.c
>