All of lore.kernel.org
 help / color / mirror / Atom feed
From: Lu Baolu <baolu.lu@linux.intel.com>
To: Joerg Roedel <joro@8bytes.org>
Cc: iommu@lists.linux-foundation.org
Subject: [PATCH 01/22] iommu/vt-d: Add Kconfig option to enable/disable scalable mode
Date: Thu,  2 Jan 2020 08:18:02 +0800	[thread overview]
Message-ID: <20200102001823.21976-2-baolu.lu@linux.intel.com> (raw)
In-Reply-To: <20200102001823.21976-1-baolu.lu@linux.intel.com>

This adds Kconfig option INTEL_IOMMU_SCALABLE_MODE_DEFAULT_ON
to make it easier for distributions to enable or disable the
Intel IOMMU scalable mode by default during kernel build.

Signed-off-by: Lu Baolu <baolu.lu@linux.intel.com>
---
 drivers/iommu/Kconfig       | 12 ++++++++++++
 drivers/iommu/intel-iommu.c |  7 ++++++-
 2 files changed, 18 insertions(+), 1 deletion(-)

diff --git a/drivers/iommu/Kconfig b/drivers/iommu/Kconfig
index 0b9d78a0f3ac..bcd1c9510458 100644
--- a/drivers/iommu/Kconfig
+++ b/drivers/iommu/Kconfig
@@ -248,6 +248,18 @@ config INTEL_IOMMU_FLOPPY_WA
 	  workaround will setup a 1:1 mapping for the first
 	  16MiB to make floppy (an ISA device) work.
 
+config INTEL_IOMMU_SCALABLE_MODE_DEFAULT_ON
+	bool "Enable Intel IOMMU scalable mode by default"
+	depends on INTEL_IOMMU
+	help
+	  Selecting this option will enable by default the scalable mode if
+	  hardware presents the capability. The scalable mode is defined in
+	  VT-d 3.0. The scalable mode capability could be checked by reading
+	  /sys/devices/virtual/iommu/dmar*/intel-iommu/ecap. If this option
+	  is not selected, scalable mode support could also be enabled by
+	  passing intel_iommu=sm_on to the kernel. If not sure, please use
+	  the default value.
+
 config IRQ_REMAP
 	bool "Support for Interrupt Remapping"
 	depends on X86_64 && X86_IO_APIC && PCI_MSI && ACPI
diff --git a/drivers/iommu/intel-iommu.c b/drivers/iommu/intel-iommu.c
index 42966611a192..26c40134817e 100644
--- a/drivers/iommu/intel-iommu.c
+++ b/drivers/iommu/intel-iommu.c
@@ -355,9 +355,14 @@ static phys_addr_t intel_iommu_iova_to_phys(struct iommu_domain *domain,
 int dmar_disabled = 0;
 #else
 int dmar_disabled = 1;
-#endif /*CONFIG_INTEL_IOMMU_DEFAULT_ON*/
+#endif /* CONFIG_INTEL_IOMMU_DEFAULT_ON */
 
+#ifdef INTEL_IOMMU_SCALABLE_MODE_DEFAULT_ON
+int intel_iommu_sm = 1;
+#else
 int intel_iommu_sm;
+#endif /* INTEL_IOMMU_SCALABLE_MODE_DEFAULT_ON */
+
 int intel_iommu_enabled = 0;
 EXPORT_SYMBOL_GPL(intel_iommu_enabled);
 
-- 
2.17.1

_______________________________________________
iommu mailing list
iommu@lists.linux-foundation.org
https://lists.linuxfoundation.org/mailman/listinfo/iommu

  reply	other threads:[~2020-01-02  0:19 UTC|newest]

Thread overview: 41+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2020-01-02  0:18 [PULL REQUEST] iommu/vt-d: patches for v5.6 Lu Baolu
2020-01-02  0:18 ` Lu Baolu [this message]
2020-01-02  0:18 ` [PATCH 02/22] iommu/vt-d: Fix CPU and IOMMU SVM feature matching checks Lu Baolu
2020-01-02  0:18 ` [PATCH 03/22] iommu/vt-d: Match CPU and IOMMU paging mode Lu Baolu
2020-01-02  0:18 ` [PATCH 04/22] iommu/vt-d: Reject SVM bind for failed capability check Lu Baolu
2020-01-02  0:18 ` [PATCH 05/22] iommu/vt-d: Avoid duplicated code for PASID setup Lu Baolu
2020-01-02  0:18 ` [PATCH 06/22] iommu/vt-d: Fix off-by-one in PASID allocation Lu Baolu
2020-01-02  0:18 ` [PATCH 07/22] iommu/vt-d: Replace Intel specific PASID allocator with IOASID Lu Baolu
2020-01-02  0:18 ` [PATCH 08/22] iommu/vt-d: Avoid sending invalid page response Lu Baolu
2020-01-02  0:18 ` [PATCH 09/22] iommu/vt-d: Misc macro clean up for SVM Lu Baolu
2020-01-02  0:18 ` [PATCH 10/22] iommu/vt-d: trace: Extend map_sg trace event Lu Baolu
2020-01-02  0:18 ` [PATCH 11/22] iommu/vt-d: Avoid iova flush queue in strict mode Lu Baolu
2020-01-02  0:18 ` [PATCH 12/22] iommu/vt-d: Loose requirement for flush queue initializaton Lu Baolu
2020-01-02  0:18 ` [PATCH 13/22] iommu/vt-d: Identify domains using first level page table Lu Baolu
2020-01-02  0:18 ` [PATCH 14/22] iommu/vt-d: Add set domain DOMAIN_ATTR_NESTING attr Lu Baolu
2020-01-02  0:18 ` [PATCH 15/22] iommu/vt-d: Add PASID_FLAG_FL5LP for first-level pasid setup Lu Baolu
2020-01-02  0:18 ` [PATCH 16/22] iommu/vt-d: Setup pasid entries for iova over first level Lu Baolu
2020-01-02  0:18 ` [PATCH 17/22] iommu/vt-d: Flush PASID-based iotlb " Lu Baolu
2020-01-02  0:18 ` [PATCH 18/22] iommu/vt-d: Make first level IOVA canonical Lu Baolu
2020-01-02  0:18 ` [PATCH 19/22] iommu/vt-d: Update first level super page capability Lu Baolu
2020-01-02  0:18 ` [PATCH 20/22] iommu/vt-d: Use iova over first level Lu Baolu
2020-01-02  0:18 ` [PATCH 21/22] iommu/vt-d: debugfs: Add support to show page table internals Lu Baolu
2020-01-02  0:18 ` [PATCH 22/22] iommu/vt-d: Add a quirk flag for scope mismatched devices Lu Baolu
2020-01-02  2:11   ` Roland Dreier via iommu
2020-01-02  2:14     ` Lu Baolu
2020-01-02  2:25       ` Roland Dreier via iommu
2020-01-02  2:34         ` Lu Baolu
2020-01-03  0:32         ` Lu Baolu
2020-01-04 16:52           ` Roland Dreier via iommu
2020-01-05  3:43             ` Lu Baolu
2020-01-06 17:05         ` Jerry Snitselaar
2020-01-07  0:35           ` Lu Baolu
2020-01-07  1:30             ` Jerry Snitselaar
2020-01-07  1:47               ` Lu Baolu
2020-01-09  0:12                 ` Roland Dreier via iommu
2020-01-08 14:16   ` Christoph Hellwig
2020-01-08 23:28     ` Lu Baolu
2020-01-09  7:06       ` Christoph Hellwig
2020-01-09  8:53         ` Lu Baolu
2020-01-09  8:56           ` 答复: " Jim,Yan
2020-01-07 13:06 ` [PULL REQUEST] iommu/vt-d: patches for v5.6 Joerg Roedel

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20200102001823.21976-2-baolu.lu@linux.intel.com \
    --to=baolu.lu@linux.intel.com \
    --cc=iommu@lists.linux-foundation.org \
    --cc=joro@8bytes.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body. 
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.